6. Get Familiar with the Keyboard
7. Learn to Navigate the Modes
Beginning with the WDT2200 powered off,
Press [CMD] plus the desired
function key (located near the bottom of the
keypad) to perform commands F5 through
F8 or to input special characters that
appear in yellow on some keys.
press and hold these three keys in the
sequence shown to get to the Start Menu:
<< START MENU >>
1.SUPERVISOR
2.WARM START
3.COLD START
WDT2200
Quick Start
Guide
Press the [1] key at the Start Menu, then
supply the default password “2200” and
press [ENT] to access Supervisor Mode:
1.DEV 2.TERM
3.MEM 4.FORM
5.PWR 6.PSWD
7.SYS 8.DIAG
Press [ALPHA] to toggle between
Numeric (block cursor) and Alphabetic
(underscore cursor) entry modes.
Characters are selected by quickly pressing
a key one, two or three times.
The Supervisor Menu allows access to
Language, baud rate, and barcode
symbology selection as well as Form
Caching and functions. Press the [ESC]
key to exit to the Ready Mode:
Press [SP] to input a space (blank)
character.
WDT2200 v1.10
MEM 2560 KB
>
In Command or Supervisor mode,
press [ESC] to return to the previous menu.
In Ready Mode, press and hold the [CMD]
key for two seconds to enter User Mode:
In Numeric or Alphabetic Mode,
press [C] to clear the last character entered
(backspace).
1.RUN 2.TER
3.COM 4.DIR
5.ERA 6.TYP
7.CPY 8.SET
Use [ENT] as an Enter key to
terminate entry of text, for example.
See p. 15 of the WDT2200 User Reference Guide on
the CD in the docs folder for more information on
User Mode. Press [ESC] to exit, then turn off the unit.
When an application has
enabled the built-in scanner, press the
large yellow scan key to read a barcode.
You are now ready to install and use
Wasp’s AppGen Pro software. Insert
the AppGen CD-ROM and run setup.exe
© 2003 Wasp Technologies, Inc.
Download from Www.Somanuals.com. All Manuals Search And Download.
|