i t a l l
s t a r t s
w i t h a
v i s i o n
A s s e m b l y
G u i d e
500 South CP Avenue
toll free 800.335.4348
•
P.O. Box 280
•
Lake Mills. WI 53551
fax 920.648.3373
•
phone 920.648.4090
•
2006 Vision Fitness. All Rights Reserved. 11.06
AG18.47PRD
REV1
U70
COMMERCIAL FITNESS BIKES
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP
3
PINK BAG
A s s e m b l y
G u i d e
• Feed the heart rate wires of the
handlebar through the small hole locat-
ed in the front of the console mast. Pull
these wires up through the hole at the
top of the console mast. Attach the
handlebar to the console mast using
four bolts (M8x20L). Tighten with the
5mm T-shaped wrench.
Console Back Cover
Console
STEP
4
STEP
1
ORANGE BAG
Handlebar
• Install the rear foot with four lock
washers (M8), two inside bolts
(M8x65L), and two outside bolts
(M8x20L). Tighten with the 5mm
T-shaped wrench.
STEP
STEP
4
CONSOLE
3
Accessory
Tray
• Remove the four mounting bolts
from the back of the console and
four screws holding the console back
cover with the screwdriver. Plug in
the wire harness and the two heart
rate wires to the back of the console.
Attach the console to the console mast
with the four bolts removed earlier in
this step.
• Plug in the 9-volt battery. Re-attach
the console back cover with the four
screws removed previously.
STEP
2
BLUE BAG
• With the screwdriver, remove the
two bolts located half way up the con-
sole mast. Attach the accessory tray to
the console mast with the two bolts.
• Slide the console mast boot onto the
console mast.
• Unfold the wire harness located
in the console mast frame bracket.
Connect it to the wire tie coming
from the bottom of the console mast.
Pull the wire tie and wire harness up
through the top of the console mast
while simultaneously sliding the mast
Wire Harness
into the frame bracket.
Rear Foot
• Secure the mast to the frame using
six lock washers (M8) and six bolts
(M8x15L). Tighten with the 5mm
T-shaped wrench. Place the seventh
bolt (M8x15L) in the rear of the frame
bracket and tighten until snug.
Heart Rate
Wires
Console Mast
• Slide the console mast boot down
and set it in place on the side cover.
Console Mast
Boot
• Remove the nuts (M8) from the bot-
tom of the seat. Attach the seat to the
seat post with the nuts you just removed.
Tighten with the 15mm wrench.
STEP
1
STEP
2
Frame
Bracket
Download from Www.Somanuals.com. All Manuals Search And Download.
|