DSS
2405
Optional Handset
and Charge Base
For use with Multi
Handset Cordless
Systems: DSS2415,
DSS2455/2465
Owner's
Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation & Safety
Choosing the best location for your phone.
When choosing a location for your phone there are a number of
appliances the phone should not be near, and areas you should avoid.
AVOID -
Television sets and
other electronic
appliances
AVOID -
Microwave ovens
AVOID - moisture
AVOID - Computers
CHOOSE -
a central location
and rise the Antenna
AVOID -
other cordless telephones
AVOID - Moisture
CHARGE -
Don’t -
AVOID -
the new phone
for 17 - 20 hrs.
overload the
power outlet.
multi power boards.
AVOID - connecting more than
3
phones as ringing may be impaired
Note: Ringing will not be impaired by adding extra cordless handsets.
• This symbol indicates important operating and
servicing instructions.
• The earcap of this telephone may attract and retain
small metallic objects.
– 2 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Connect the Charger
Connect the AC adapter to the
DC IN 9V jack and to a
1
2
standard AC wall outlet.
Set the charger on a desk or
tabletop, and place the
handset in the charger with
the keypad facing forward.
Route the cord.
AC adaptor
(supplied)
To AC outlet
To DC IN 9V
Make sure the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the charger
charging contacts.
3
Use only the supplied AAD-600S AC adapter. Do not use
any other AC adapter.
Installing the AA Batteries
Press down on the battery cover
release and slide the cover down
until it comes off.
1
2
Install the batteries supplied
with your phone. Check for
correct (+ -) polarity.
– 3 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Securely close the battery compartment cover by sliding
it until it snaps into place.
3
“Please Register” appears in the display.
The DSS2405 will only work with
“AA” Ni-MH rechargeable batteries.
If you use any other type of batteries,
the display will show “Use
rechargeable battery only”.
Use only “AA” rechargeable Ni-MH
batteries. Do Not use Alkaline, Lithium,
or non-rechargeable batteries. Using
incorrect batteries could damage or limit
the performance of the handset and could
cause bodily injury.
Battery Information
Bat t ery use t ime ( per charge)
From fully charged (17-20 hours charge time)
• Up to 7 hours continuous use
(up to 5 hours when the Clarity Booster is On)
• Up to 14 days when the handset is in the standby mode
(up to 24 hours in the DirectLink mode)
Recharge your handset on a regular basis by returning the
handset to the charger after each phone call.
Low bat t ery alert
When the batteries are very low and need to be charged, the phone
is programmed to eliminate functions in order to save power.
The batteries need to be charged when :
- The empty battery icon
appears.
- “Low Battery” appears in the display.
If the phone is in the standby mode, none of the keys will operate.
If you are on a call, complete your conversation as quickly as
possible, and return the handset to the charging cradle.
– 4 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Cleaning t he bat t ery charging cont act s
To maintain a good charge, it is
important to clean the charging contacts
on both the handset and the charger
once a month. Use a dry cloth or pencil
eraser to clean.
contacts
Register the Handset
YOU NEED TO REGISTER THE DSS2405 TO THE MAIN BASE
BEFORE USE!
DSS2415
Main Base
DSS2455/ 2465
Main Base
Charger
After placing the batteries in the handset, charge for 10
minutes. Then remove the handset from the charger and
place it in the main base (DSS2415, DSS2455, or DSS2465).
1
Registration starts automatically. While registering, “Handset
2
3
Registering” appears in the display.
When the registration is complete, “Registration
Complete” appears in the display.
If the registration fails, “Registration Failed” appears in the
display. Try the above steps again.
Once registration is complete, place the handset back in
the charger for 17 to 20 hours to ensure the batteries are
fully charged.
4
• An extra handset can be registered when the main base
is in the standby mode.
• In some cases you may need to attempt registration a
few times.
– 5 –
Download from Www.Somanuals.com. All Manuals Search And Download.
WARRANTY
One Year Limit ed Warrant y
Important : Evidence of original purchase is required for warranty service.
Warrantor : Uniden Australia Pty Limited A.B.N. 58 001 865 498
Uniden New Zealand Limited
ELEMENT OF WARRANTY : Uniden warrants to the original retail owner for the duration of
this warranty, its DSS2405 (herein after referred to as the Product), to be free from defects
in materials and craftsmanship with only the limitations or exclusions set out below.
Warranty is only valid in original country of purchase.
WARRANTY DURATION : This warranty to the original retail owner only, shall terminate and
be of no further effect 12 months after the date of original retail sale. This warranty will be
deemed invalid if the product is:
(A) Damaged or not maintained as reasonable and necessary,
(B) Modified, altered or used as part of any conversion kits, subassemblies, or any
configurations not sold by Uniden,
(C) Improperly installed,
(D) Repaired by someone other than an authorised Uniden Repair Agent for a defect or
malfunction covered by this warranty,
(E) Used in conjunction with any equipment or parts or as part of a system not
manufactured by Uniden.
PARTS COVERED : This warranty covers for one (1) year, the Base Unit and Handset only. All
accessories (AC Adaptor etc)are covered for 90 days only.
STATEMENT OF REMEDY : In the event that the product does not conform to this warranty at
any time while this warranty is in effect, the warrantor at its discretion, will repair the
defect or replace the product and return it to you without charge for parts or service. THIS
WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS GUARANTEE IS IN ADDITION TO AND DOES
NOT IN ANY WAY AFFECT YOUR RIGHTS UNDER THE CONSUMER GUARANTEE ACT.
PROCEDURE FOR OBTAINING PERFORMANCE OR WARRANTY : In the event that the product
does not conform to this warranty, the Product should be shipped or delivered, freight pre-
paid, with evidence of original purchase (eg. a copy of the sales docket), to the warrantor at :
UNIDEN AUSTRALIA PTY LIMITED
SERVICE DIVISION
UNIDEN NEW ZEALAND LIMITED
SERVICE DIVISION
345 Princes Highway, Rockdale NSW 2216
Ph 1300 366 895
Fx (02) 9599 3278
150 Harris Road, East Tamaki, Auckland
Ph 0800 4 UNIDEN (4 864 336)
Fx (09) 274 4253
www.uniden.com.au
www.uniden.co.nz
Customers in other States should ship or deliver the Product freight pre-paid to their nearest
Uniden Authorised Repair Centre (Contact Uniden for the nearest Warranty Agent to you).
– 6 –
Download from Www.Somanuals.com. All Manuals Search And Download.
© 2003
Uniden Australia Pty Limited
Uniden New Zealand Limited
Printed in China
UUZZ01827BZ
Download from Www.Somanuals.com. All Manuals Search And Download.
|