Uniden Cordless Telephone DCX520 User Manual

Download from Www.Somanuals.com. All Manuals Search And Download.  
Install the AA Batteries  
Charge the AA batteries for at least 17-20 hours before  
completing the installation or using the handset.  
Press down on the battery cover  
release and slide the cover down  
until it comes off.  
1
Install the batteries supplied  
with your phone. Check for  
correct (+ -) polarity.  
2
Securely close the battery  
compartment cover by sliding  
it until it snaps into place.  
3
Please Register” appears in  
the display.  
Place the handset in the charging  
cradle with the keypad facing forward.  
4
The DCX520 will only work with  
“AA” Ni-MH rechargeable batteries.  
If you use any other type of  
batteries, the display will show “Use  
rechargeable battery only.  
Use only “AA” rechargeable Ni-MH  
batteries. Do Not use Alkaline, Lithium,  
or non-rechargeable batteries. To insure  
maximum performance and safety, use  
replacement batteries specifically matched for  
this phone, contact www.uniden.com.  
Using incorrect batteries could damage or  
limit the performance of the handset and  
could cause bodily injury.  
• Recharge your handset on a regular basis by  
returning the handset to the charger after  
each phone call.  
– 3 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Battery Information  
Battery use time (per charge)  
From fully charged (17-20 hours charge time)  
• Up to 7 hours continuous use  
(up to 5 hours when the Clarity Booster is On)  
• Up to 14 days when the handset is in the standby mode  
(up to 24 hours in the DirectLink mode)  
Low battery alert  
When the batteries are very low and need to be charged, the phone  
is programmed to eliminate functions in order to save power.  
The batteries need to be charged when:  
- The battery icon  
appears.  
- “Low Battery” appears in the display.  
If the phone is in the standby mode, none of the keys will operate.  
If you are on a call, complete your conversation as quickly as  
possible, and return the handset to the charging cradle.  
Cleaning the battery charging contacts  
To maintain a good charge, it is important to clean the charging  
contacts on both the handset and the  
charger once a month. Use a dry cloth  
or pencil eraser to clean. If the contacts  
become very dirty, use water only, dampen  
a cloth to clean the charging contacts.  
Then make sure to go back over the charging  
contacts with a dry cloth before returning  
the handset to the charger to charge.  
contacts  
Connect the Charger  
Connect the AC adapter  
1
to the DC IN 9V jack  
and to a standard 120V  
AC wall outlet.  
Set the charger on a  
2
desk or tabletop, and  
place the handset in  
the charger with the  
keypad facing forward.  
– 4 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Make sure the charge LED illuminates. If the LED does not  
illuminate, check to see that the AC adapter is plugged in  
and that the handset makes good contact with the charger  
charging contacts.  
3
Use only the supplied AD-310  
AC adapter. Do not use any  
Polarity of the plug  
other AC adapter.  
• Place the charger close to the AC  
outlet so that you can unplug the  
AC adapter easily.  
Register the Handset  
YOU NEED TO REGISTER THE DCX520 BEFORE USE.  
After placing the batteries in the handset and charging the  
batteries, remove the handset from the charger and place it  
in the main base.  
1
Registration starts automatically. While registering,  
Handset Registering” appears in the display.  
2
When the registration is complete,  
Registration Complete” appears in the display.  
3
If the registration fails, “Registration Failed” appears in  
the display. Try the steps above again.  
• An extra handset can be registered when the main base  
is in the standby mode.  
• In some cases you may need to attempt registration a  
few times.  
Using the DCX520 with the  
Integrated Answering Device  
If the original unit has a built-in answering system, you can check  
your new messages, skip, repeat, or delete your messages with the  
DCX520 handset. For more instructions, see the owner’s manual  
supplied with the original unit.  
– 5 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
To playback a message  
To skip a message  
Press the  
Press the  
soft key.  
soft key.  
To repeat the current message Press the  
To repeat the previous message Press the  
soft key after four seconds.  
soft key within four seconds.  
To delete a message  
To stop operation  
Press the DELETE soft key.  
Press end.  
• If you press end before the answering system answers, the  
phone will return to the standby mode.  
• When the answering system does not answer within 6 seconds,  
you will hear a beep and the phone will return to the  
standby mode.  
• When you receive a call, the remote operation is canceled.  
I.C. Notice  
TERMINAL EQUIPMENT  
NOTICE: This equipment meets the applicable Industry Canada  
Terminal Equipment Technical Specifications. This is confirmed by  
the registration number. The abbreviation, IC, before the  
registration number signifies that registration was performed based  
on a Declaration of Conformity indicating that Industry Canada  
technical specifications were met. It does not imply that Industry  
Canada approved the equipment.  
NOTICE: The Ringer Equivalence Number (REN) for this terminal  
equipment is marked on the equipment itself. The REN assigned to  
each terminal equipment provides an indication of the maximum  
number of terminals allowed to be connected to a telephone interface.  
The termination on an interface may consist of any combination of  
devices subject only to the requirement that the sum of the Ringer  
Equivalence Numbers of all the devices does not exceed five.  
RADIO EQUIPMENT  
The term “IC:” before the radio certification number only signifies  
that Industry Canada technical specifications were met.  
Operation is subject to the following two conditions: (1) this device  
may not cause interference, and (2) this device must accept any  
interference, including interference that may cause undesired  
operation of the device. “Privacy of communications may not be  
ensured when using this telephone.  
– 6 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
One Year Limited Warranty  
Important: Evidence of original purchase is required for warranty service.  
WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”)  
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this  
Uniden Product to be free from defects in materials and craftsmanship with only the  
limitations or exclusions set out below.  
WARRANTY DURATION: This warranty to the original user shall terminate and be of no further  
effect 12 months after the date of original retail sale. The warranty is invalid if the Product  
is (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used  
as part of any conversion kits, subassemblies, or any configurations not sold by Uniden,  
(C) improperly installed, (D) serviced or repaired by someone other than an authorized  
Uniden service center for a defect or malfunction covered by this warranty, (E) used in any  
conjunction with equipment or parts or as part of any system not manufactured by Uniden,  
or (F) installed or programmed by anyone other than as detailed by the owner’s manual for  
this product.  
STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at  
any time while this warranty is in effect, warrantor will either repair or replace the defective  
unit and return it to you without charge for parts, service, or any other cost (except  
shipping and handling) incurred by warrantor or its representatives in connection with the  
performance of this warranty. Warrantor may replace the unit with a new or refurbished unit.  
THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING  
TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE  
WHATSOEVER, WHETHER EXPRESSED, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING,  
BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A  
PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE  
REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do  
not allow this exclusion or limitation of incidental or consequential damages so the above  
limitation or exclusion may not apply to you.  
LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have  
other rights which vary from state to state. This warranty is void outside the United States  
of America and Canada.  
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions  
in the owner’s manual you are certain that the Product is defective, pack the Product  
carefully (preferably in its original packaging). The Product should include all parts and  
accessories originally packaged with the Product. Include evidence of original purchase and a  
note describing the defect that has caused you to return it. The Product should be shipped  
freight prepaid, by traceable means, to warrantor at:  
Uniden America Corporation  
Parts and Service Division  
4700 Amon Carter Blvd.  
Fort Worth, TX 76155  
(800) 297-1023, 8 a.m. to 5 p.m. Central, Monday through Friday  
– 7 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Tektronix Printer 4681FXI User Manual
Tricity Bendix Freezer TB 80 L User Manual
Tripp Lite Power Supply Alternative Power Sources User Manual
Tripp Lite TV Cables N546 20M User Manual
Troy Bilt Tiller 634BM User Manual
Troy Bilt Trimmer TB3000 User Manual
Viking Pager CPA 7B User Manual
Vivotek Security Camera FE8174 User Manual
Vivotek Security Camera IP8130 User Manual
Vizio Flat Panel Television E320A0 User Manual