Owner's Manual
LINE
CONDITIONERS
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support:
+1(773) 869-1234
(220/240V-50/60 Hz )
ESPAÑOL: p. 6
FRANÇAIS: p. 11
DEUTSCH: p.16
Safety:
p. 2
Quick Installation: p. 3
Basic Operation:
Service:
p. 4
p. 5
Warranty:
p. 5
Copyright © 2004 Tripp Lite. All rights reserved.
Download from Www.Somanuals.com. All Manuals Search And Download.
Quick Installation—220/240V-50/60 Hz
Connect your computer
1
or electronics to the Line
Conditioner, and the
Line Conditioner to an
electrical outlet.
A. Exchange the Line Conditioner's cord with
your equipment's cord. Connect the Line
Conditioner cord's male plug into a Line
Conditioner receptacle. Connect its female
plug into the equipment's male input.
B. Connect the equipment cord's male plug
into a wall outlet. Connect its female plug into
the line conditioner's male input.
Connect additional
2
equipment to the Line
Conditioner in the same
manner.
Additional cords and receptacle adapters are
available to accommodate most outlet
configurations.
Turn on your Line
Conditioner's power
switch.
3
Note: (select models) Source Voltage
Matching Switch
Set the source voltage matching switch to
either 208, 220 or 240 volts to match the
input voltage being used.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Basic Operation
Indicator Lights
All indicator light descriptions apply when the Line Conditioner is plugged
into a wall outlet and turned on. (Available on select models only.)
A green "NORM" light will turn ON whenever your Line Conditioner is plugged in
and receiving nominal AC line voltage.
Yellow lights labelled "LOW" (or "BOOST") and "HIGH" (or "TRIM") will turn
ON when incoming voltage is above or below nominal AC line voltage.
Red lights labelled "VERY HIGH" or "VERY LOW" will turn ON when incoming
voltage is substantially above or below nominal AC line voltage.
A green "LINE OK" light will turn ON when AC power is present and no wiring
faults are detected. When this light is illuminated, AC power is acceptable for
connected equipment.
A red "LINE FAULT" light will turn ON to indicate a wiring fault has been
detected. The condition should be investigated and repaired by a qualified technician
as soon as possible. A loose wall outlet may cause this light to come ON. Your Line
Conditioner will identify most common wiring faults (but not necessarily every
possible type of fault).
Other Features
AC Receptacles: The receptacles provide your connected equipment with
AC line power during normal operation. They adjust incoming voltage to pro-
vide equipment with nominal 220/240V power. The receptacles also protect
your equipment against damaging surges and line noise, eliminating the need
IEC-320-C13
for external surge suppression.
(220/240V)
Note: As the Line Conditioner corrects fluctuating input voltages, the unit will
make a gentle clicking sound. The frequency of the clicking will depend on the
quality of the utility power in your particular area. The clicking is normal and
indicates the Line Conditioner is compensating for fluctuating input voltages as
NEMA 5-15R*
(220/240V)
described in this manual.
* Available on select models.
NEMA 6-15R*
(220/240V)
Circuit Breaker (Available on select models): If the rated capacity of
the Line Conditioner is exceeded at any time, the circuit breaker will open
(trip). Remove the overload and let the circuit breaker cool for one minute.
Reset the circuit breaker by pushing in the plunger.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Service
If returning your Line Conditioner to Tripp Lite or an authorized Tripp Lite service center,
please carefully pack the it using the ORIGINAL PACKING MATERIAL that came with the
unit. Enclose a letter describing the symptoms of the problem. If the Line Conditioner is
within the 2 year warranty period, enclose a copy of your sales receipt.
2-Year Limited Warranty
TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of two years from
the date of initial purchase. TRIPP LITE’s obligation under this warranty is limited to repairing or replacing (at its sole
option) any such defective products. To obtain service under this warranty, you must obtain a Returned Material
Authorization (RMA) number from TRIPP LITE or an authorized TRIPP LITE service center. Products must be
returned to TRIPP LITE or an authorized TRIPP LITE service center with transportation charges prepaid and must be
accompanied by a brief description of the problem encountered and proof of date and place of purchase. This warran-
ty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been
altered or modified in any way. This warranty applies only to the original purchaser who must have properly registered
the product within 10 days of purchase.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit
limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the
purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically, TRIPP LITE is not liable for any costs, such as
lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes,
claims by third parties, or otherwise.
The policy of TRIPP LITE is one of continuous improvement. Specifications are subject to change without notice.
Regulatory Compliance Identification Numbers
Select models: For the purpose of regulatory compliance certifications and identification, your Tripp Lite product may
have been assigned a unique series number. The series number can be found on the product nameplate label, along
with all required approval markings and information. When requesting compliance information for this product, always
refer to the series number. The series number should not be confused with the marking name or model number of the
product.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
1111 W. 35th Street, Chicago, IL 60609 USA
773.869.1234 (USA) • 773.869.1212 (International)
200407139 93-2268_EN
Download from Www.Somanuals.com. All Manuals Search And Download.
|