AIR-DISCHARGE DIRECTION KIT FOR AIR CONDITIONER (SPLIT TYPE)
Installation Manual
Air-Discharge Direction Kit
(for 4-way air discharge cassette Type)
Model name:
Air-discharge direction kit
TCB-BC1602UUL
Installation Manual
Air-discharge direction kit
English
1
7
Manuel du proprietaire
Climatiseur (Type à deux éléments)
Français
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Manual
Air-dischage direction kit
3 INSTALLATION METHODS
CAUTION
• Before installing the wind shield, change the air conditioner settings. Refer to “Changing the setting” on page 4.
• Unless the setting is changed, the air blow temperature becomes low. This may cause the dew condensation.
Installing the wind shield(s) and packings
• Attach the wind shields to the air flow openings (made of styrene foam) of the indoor unit and place the packings
on them to block the air flow. (Refer to Fig. 1 to 3.)
• Put the packings bending along the edges of the indoor unit external surface without blocking the concaved
portions of the drain pans. (If the packings are not put bending along the edge of the indoor unit external surface,
the dew condensation may occur.) (Refer to Fig. 1 and 3.)
* The size adjustment is required for the packing which are attached on the wind shield C. Cut 1.58” (40 mm) to
adjust its size in 16.5” x 4.3” (420 mm x 110 mm).
(Fig. 1)
(Fig. 2)
Packing
Packing Wind shield (A, B, C) Drain pan
Wind shield A
Wind shield A
Packing
Indoor
unit
External
surface
(requiredtocut
1.58” (40 mm.)
Packing
Wind shield B
Wind shield C
Interior styrene foam
Air flow outlet
Drain piping
(Fig. 3)
Putthepackingswithout
blocking the concaved
portions.
Refrigerant piping
EN
2-EN
– 2 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Manual
Air-dischage direction kit
Installing the indoor unit
• Install the indoor unit (Install the indoor unit following the instructions described on the installation manual of the
indoor unit.)
• Block the air flow outlets following the air flow blocking pattern shown in the table below when controlling 3-way
or 2-way air flow.
• The blockage portions of the air flow outlet are specified depending on the models. Do not specify the blockage
of the airflow outlet other than specified in the table below.
Limited models only
Wind shield A
3-way air flow
Wind shield C
Available only for
SP180 to SP240.
Available only for
SP300 to SP420.
Available for all models
Available for all models
Wind shield A
2-way air flow
Wind shield C
Wind shield C
Available for all models
Available for all models
Available for all models
3-EN
– 3 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Manual
Air-dischage direction kit
Changing the setting
• The setting is changed by using a wired remote controller. (For the details, Refer to “Changing procedure”
described below.)
• Perform “Setting the louver lock (Louver position fixing)”.
CAUTION
When the ceiling is higher than the specification, the fan control is required. So, in that case, perform the “high ceiling
setting” other than the setting described below.
The setting should be performed according to the instructions described on the installation manual attached to the
indoor unit.
“Changing procedure”: Change the setting while the device stops.
1
Push
sec.
+
+
buttons simultaneously for more than 4
The unit No. displayed at first shows the indoor unit address of the
header unit in group control operation. The fan operation of the
indoor unit (header unit), selected at this time, is carried out.
2
Every time when UNIT
in the group cotrol operation are displayed in order.
(Left button) is pushed, the No.
The fan operation of the indoor unit, selected at this time, is carried
out.
3
4
Set the CODE No.
by using the TEMP.
/
button.
Set the setting data by pushing TIME
TIME setting.
/
buttons for the
3-way air flow......................
3 6
5
14
2
2-way air flow......................
5
6
Push the
data are displayed.)
When changing the setting of other indoor unit in the group control
operation, return to 2.
button. (The setting completes if the setting
Pushing the
button enters to the normal stop status.
EN
4-EN
– 4 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Manual
Air-dischage direction kit
Setting the louver lock (Louver position fixing)
• Fix the louver at the air flow blockage portions. (For the setting methods, follow the procedures below.)
1
Push the LOUVER
4 seconds while the air conditioner is stopped.
The blinks.
(Right button) for more than
Unit No.
1-2
Unit No.
1-1
Unit No.
1-4
Unit No.
1-3
2
Push the UNIT
unit you want to set.
Every time you push the button, the Unit No. changes.
The fan of the selected indoor unit starts its operation and the
louvers swing.
(Left button) to select the indoor
F2
F3
F1
F4
3
4
Push the TEMP.
louver No. with the wind shield applied.
The selected louver starts to swing.
/
buttons to display the
Select the code 0001 by pushing the TIME
buttons.
/
Louver fixing position code
Electric parts box
Louver No.
5
6
Push the
After the setting contents is defined, the
(Return to step 3 if there are other two wind shields.)
button to define the setting contents.
mark lights.
Refrigerant piping
Push the button to exit the setting.
“F1” is displayed in the CODE No. on the remote controller
display.
This means that the 01 louver shown on the illustration is
Drain piping
selected.
(Louver No. diagram)
Confirming the installation
• After the installation completes, perform the test run to confirm that no abnormality is found.
• For your future reference, please keep the installation manual on your side.
5-EN
– 5 –
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Manual
Air-dischage direction kit
MEMO
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
.....................................................................................................................
EN
– 6 –
Download from Www.Somanuals.com. All Manuals Search And Download.
EH99678401
Download from Www.Somanuals.com. All Manuals Search And Download.
|