TIC WRS010 Wireless Outdoor Rock Speakers
TIC Outdoor Wireless Rock Speakers = Weatherproof Design
Pair of Stone Wireless Rock Speakers
"State of the art" 2.4gHz! operation
“Safe” 9v speaker transformers power supply incl.
or uses 6xAA batteries
Full featured remote control included
Remote control power 1x23A battery
"Mini Rock" transmitter unit included
Transmitter power 3xAA batteries
300ft.! transmitter broadcast range
80ft.! Remote Control range
2x 5" Dual Cone Speaker Drivers
Aerospace grade, Teflon© sealed, multi-layer composite cabinetry
Canyon (CN) or Slate (SL) Stone finish
Accent & aesthetically enhance any exterior landscape setting without
wires!
©TIC Corporation U.S.A. TIC01092009SR-I
Download from Www.Somanuals.com. All Manuals Search And Download.
Index…
Introduction – Index……………..
Component List………………….
Pre-Installation…………………...
Installation Prep……………........
General Installation……………...
Exterior Installation………………
Maintenance……………………..
Customer Service………………..
Warranty………………………….
Installation Notes………………...
Trouble Shooting………………...
Technical Specifications………..
Contact TIC………………………
3
4
4
5
6, 7
8
9
9
9
10
11
12
12
Thank You!, for purchasing another high quality outdoor audio product
from TIC Corporation. Please read the enclosed installation guidelines
carefully and thoroughly to ensure years of trouble free service from your
new TIC exterior audio products.
Carefully unpack your new TIC exterior product and save all packaging
materials for possible future use. Check that your new TIC product
contains all system parts detailed in your components list. Do not attempt
to operate, install or use your new TIC product if any components appear
missing or damaged, if so, please notify TIC Corporation or your TIC
product Dealer as soon as possible.
*WARNING! To avoid possible suffocation or injury
please keep all plastic bags away from children or pets.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Component List…
Check all components carefully before use
2x Outdoor Wireless Rock Speakers
2x Battery compartment modules and mains AC transformers
(120v house mains AC to 9v DC, base of units)
1x Broadcast Transmitter unit, 3x AA batteries
1x 3.5mm to 2x phono/ RCA type audio output connection cable
1x 3.5mm to 3.5mm digital audio, CD, MP3, Iphone etc. Output
cable
1x Full featured Remote Control unit, 1x 24A battery
1x Instruction manual & Warranty card
Pre-Installation…
Need Professional Help?
Please read this owners guide carefully before installation. Failure to follow these
instructions fully or incorrect installation may damage your new TIC products and
any third party equipment used in your new system installation. This may also
void any warranty for your new TIC products. If you are unsure of your ability to
fully understand and fully complete the installation of this TIC product, please
consult a professional installer.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Prep…
Before you begin the installation of your new TIC outdoor product, please
carefully select the locations of your new TIC outdoor products.
1. Select a reasonably level surface for the installation of your new TIC
outdoor speakers. For surface speakers this will prevent movement or
excessive vibration during use. This will also ensure more uniform sound
dispersion.
2. For Wireless Speaker Broadcasts: in normal circumstances we suggest
placing the transmitter at a height of 1 meter above the receiving units
(rock speakers) because land will absorb radio waves produced by the
transmitter. Within the maximum area of coverage, the zero boundary is
100m, unobstructed, or approx. 300ft.
3. Do not place your TIC outdoor speakers in a depression or area where
water pools or in the direct path of garden sprinklers.
4. Whenever possible avoid long term exposure of your new TIC outdoor
speakers to excessive high temperatures, chlorinated solvents, acids
such as those often contained in fertilizers and other solvents which
potentially, could wear your speaker components prematurely.
5. There is no requirement for customers to open this unit far any kind of
operation or maintenance. Doing so may void the warranty!
6. Please ensure the base plate, silicone covered, power switch is in the
“off” position when not in use. The unit consumes power, including
battery power, even in the “stand by” mode.
7. Avoid any shocks, high vibration, collisions or sudden impacts to the
speaker unit or its electronic components.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
General Installation…
Set up the Transmitter
1. Power the Transmitter;
In the base of the
transmitter, remove the
cover plate and insert
3x AA batteries to power
the transmitter.
2. Check the “Green” LED
light is on showing the
transmitter has power.
3. Connect the transmitter
to an Audio Source
using either the 3.5mm
jack or 2x phono/ RCA
type red & white plugs
supplied.
Note: The TIC WRS010 is capable of working with the “Audio Output” of many
different sound sources. The 3.5mm to 3.5mm jack cable supplied connects to
many different audio sources including CD’s, MP3’s Ipod’s etc. The 3.5mm jack
to 2x phono/ RCA type red & white plugs supplied connects to many devices
through the “audio out” function of devices like TV’s, DVD’s and receiver
amplifiers.
Note: It is possible that the supplied, packaged batteries have lost their charge
during the shipping process. Please replace before troubleshooting.
Set up the Wireless Rock Speakers
1. Carefully unpack, tilt on their side, and look carefully at the base of your
new TIC wireless rock speakers.
2. Note first the 110v mains connection input on the base plate, covered by
6
Download from Www.Somanuals.com. All Manuals Search And Download.
a soft rubber protector. Locate the supplied mains cable, plug in
connection cable and push in firmly then screw on its protective cover,
then plug in the connection at the wall mains plug.
3. Locate the silicone covered “On & Off” switch. Switch “On” the Red
rocker switch and note the Green LED light comes on which shows the
unit is operating and ready to receive a broadcast signal.
4. Note: At this time you should test the operation of the units using the
mains power only to ensure correct operation of the system so far.
5. Switch off the units rocker switch and disconnect the mains cable
connection. Note the Screw On/ Off Battery cover. Carefully screw off
this cover and remove the battery container. Insert 6x AA batteries.
Switch on using the rocker switch and, again note the Green operating
LED light. The unit should now be prepared to operate on batteries only.
6. Note: At the base of the wireless rock speakers is a Red LED light.
Should the units receive power fluctuations or the batteries lose charge
this red LED light should flash in warning of insufficient power to the
units. You may also experience a lessening in range and performance.
7. Note: Batteries leak power and lose their charge. Avoid leaving the
batteries installed when using mains power or during periods of inactivity.
WRS010 Remote Control
1. Once the Transmitter and rock
speakers are set up and ready for
operation please study your
WRS010 system Remote Control
pad.
2. On the back of the unit, please
slide off/ down the battery
compartment cover plate. Insert
1x MN21/23 or 1x 23A battery.
Replace the battery cover
3. Press the “ON/ OFF” button on
the remote; if powered you may
hear a pop noise from the
speakers notifying you they are
receiving. The “Red” LED light will
flash on whenever you operate a
remote control button.
4. Ensure your transmitter and
speakers are operational with the
transmitter receiving an Audio
Source Signal. Press and hold
the “Vol +” button for a short time
until the speakers reach an
appreciable volume level.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Note: It is possible for your speakers to be “out of phase” where switching on
the remote switches on one speaker but not the other. In this case completely
power down the system removing any batteries in the speakers, then power up
and switch on again, regaining balance.
Exterior Installation…
Some general notes and tips for when you install your new TIC Wireless Outdoor
Rock Speakers in an Exterior environment.
1. Don’t forget to test your new product prior to exterior installation.
2. Carefully unpack your new TIC WRS010 outdoor wireless rock speakers
and inspect all components as previously described.
3. Carefully connect your “Mini Rock” broadcast transmitter to a working
sound source. Attach any output devices, CD’s, MP3’s, Ipod, receiver
amplifier etc. Ensure it has power and is switched “On”. (Green LED)
4. Locate your new exterior rock speakers using the previously described
placement techniques; ensure no architectural or other broadcast signal
obstructions.
5. Power up your speakers ensuring the Green signal light is lit.
6. Using your remote control, switch “On”, then adjust the volume of your
outdoor speakers.
7. Be aware of the Red LED light flashing when battery power is low.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Once connected properly sit back and enjoy!
Enjoy a quality outdoor music room!
Disclaimer: TIC Corporation will in no way be held responsible for the
improper, misuse or unsecured installation of this product. Any and all damage(s)
arising from the installation or use of this product is the purchaser/ end user and
final installers’ sole responsibility. Please see Warranty for other conditions.
Maintenance…
Occasional maintenance of your TIC exterior products cannot hurt and may help
greatly. Inspect the installation area regularly removing any twigs, dirt or
impediments from building up around the output grill area. The units may be
cleaned using very mild detergents, like dishwashing liquid, if desired. A hose
using clean water may be used but please avoid using high pressure or forcing
water into the grill or acoustic ports.
In very cold climates with heavy snowfall, an old trick from the many theme parks
which use our products is to place a plastic bag over the unit outdoors until
spring.
Customer Service…
For any additional help please contact TIC Corporation at 800.SPX.OMNI or
be happy to assist you. Also please visit our website for FAQ (frequently asked
questions) and for full Contact information.
Warranty Period…
TIC Corporation offers a full, UCC approved, one year full parts and labor
warranty on all its exterior outdoor products.
Note: Please see the full 12 months limited warranty card for fuller description of
terms and conditions that apply to the warranty with this product.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Notes…
Note: Do not mix Battery types, alkaline, zinc etc. This could be detrimental or
damage the unit and the battery compartment and function of the unit.
Do not leave the batteries installed when operating on AC power.
Please dispose of all batteries in accordance with local & federal regulations.
General: While TIC tries to offer its customers the most adaptable unit possible,
for ease of use and this product does offer a wide variety of connection methods
we thought we should point out that there is a preference. Whenever possible,
please try to use outputs or adjust volume using only the supplied remote control
volume buttons and not use the volume controls on the output devices used.
Please make any installation notes you feel important here;
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting…
No Sound?
Transmitter is not initialized – Re-check the
power is “on” at the transmitter and try changing
“channels at the transmitter.
Check the audio signal source both to and from
the transmitter. Try another cable to ensure
integrity.
Check the receiver amplifier, if used, is powered
“on” at the mains, is not on “mute”, has no
headphones attached and that the Channels
used for the transmitter/ exterior speakers
(usually A or B) is in operation.
Refer to the owners guide that came with your
receiver amplifier.
Check the “on” switch at the Remote Control to
make sure the speaker is switched “on”.
Check the volume control on your Remote
Control is switched high enough for volume to
be heard.
Check the “Green” indicator light on your
speakers to ensure they are receiving a signal.
Ensure you speakers are receiving power. Red
LED..
No Sound from one
speaker
Check the “balance” control on your receiver
amplifier is “equal”.
Check all connections and cable to and from, or
the integrity of the transmitter source to the
inoperable speaker.
Check the batteries or power source(s) to the
inoperable speaker.
Speaker has
Loudspeaker is flashing red or full light – the
battery of the loudspeaker or remote control will
soon be out of power. Please replace.
Check the “range” by temporarily bringing the
exterior speakers closer to the transmitter
source.
intermittent or rough
sound; the distance
of the remote
control volume
controller becomes
nearer
Lift the transmitter height to see if this has any
effect.
One speaker
sounds distorted,
lower volume
Follow same procedure as above for “No
Sound”
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Technical Specifications…
TIC WRS010 wireless rock speakers
Audio Inputs Analog/ digital: CD’s, MP3’s, Ipod’s,
receiver amplifier’s, 2x mic’s
Accessories Included 1x 3.5mm to 3.5mm digital cable
1x 3.5mm to 2x phono/ RCA type cable
2x rock speaker 120v to 9v transformer
Selectable RF Channels 8 channels
Broadcast Frequency Range 2400 – 2483 mHz
Transmitter Voltage DC 7.5v 500mA
Receiver Voltage DC 9v 800mA
Power consumption 90mA
Impedance 8 Ohms
Sensitivity @1W/1M 84db ±3db
Continuous / Peak 2.5 – 5W
Frequency Response 90Hz – 18kHz
Transmitter Range 100m/ 300ft. (unobstructed)
Remote Control Range 30m/ 80ft. (unobstructed)
Battery use Approx. 6 – 8 hrs.
Unit size 9.4 x 9.4 x 7.4 in.
Pack size 18 x 10 x 8.5 in. (pair)
Pack Weight 15.2 Lbs.
TIC Corporation engages in continual product research and development, new materials,
production methods and design improvements. TIC Corporation, their agents,
representatives and distributors therefore, reserves all rights to change or improve
products specifications without notice.
TIC Corporation
15224 East Stafford Street
City of Industry, CA. 91744-4418 U.S.A.
Tel: (626) 968-0211 (5 lines) Fax: (626) 968-1363
12
Download from Www.Somanuals.com. All Manuals Search And Download.
|