| ENCELIUM™Energy Management System   Energy Control Unit   Wiring and Installation Manual   Overview   The Energy Control Unit (ECU) is a gateway that   interfaces to both IT equipment (servers, LAN, etc) and   field bus devices (luminaire controllers, sensors, wall   switches, etc). Communication with IT equipment and   other ECUs is achieved using the Ethernet port.   Additionally, two USB 2.0 ports are provided for data   transfer and back-up purposes.   The ECU provides operating power together with   communication signals via GreenBus IITM to the various   field bus devices of the system via eight GreenBus IITM communication channels.   The ECU makes each device addressable via GreenBus IITM (e.g. each light fixture can be individually dimmed and   turned on/off). Devices will obtain their addresses during the commissioning process and no actions are required   during installation.   The following model(s) are available:   Indoor Locations:   EN-ECU-G4-P3D   Important Safeguards   When using electrical equipment, basic safety precautions should always be followed including the following:   • READ AND FOLLOW ALL SAFETY INSTRUCTIONS.   • Do not let power supply cords touch hot surfaces.   • Do not mount near gas or electric heaters.   • Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by   unauthorized personnel.   • The use of accessory equipment is not recommended by OSRAM Sylvania as it may cause an unsafe condition.   • Do not use this equipment for other than the intended use.   SAVE THESE INSTRUCTIONS   Page 1 of 4   76-015-DA 10/13   OSRAM and Logo are registered trademarks of OSRAM GmbH.   ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA, Inc   GreenBus II are trademarks of OSRAM SYLVANIA, Inc.   Download from Www.Somanuals.com. All Manuals Search And Download.   SEE THE WORLD IN A NEW LIGHT is a registered trademark of OSRAM SYLVANIA, Inc.   Installation Notes   The Energy Control Unit shall be installed in dry, indoor locations ONLY. The Energy Control Unit shall be installed   into a Pollution Degree 2 (or better) environment.   The Energy Control Unit may be installed into a standard 19”   rack or mounted to a wall. A bracket is provided for rack   installations. Using the screws provided, affix the bracket   securely to the Energy Control Unit as shown.   If the Energy Control Unit is to be installed onto a wall   surface, use suitable screws to securely hold the unit. Install the unit with the input power, LAN, and GreenBus IITM   connections facing down. The control buttons shall be facing upward. This orientation will ensure adequate cooling   for the product while installed against a wall surface.   Troubleshooting   There are no user-serviceable parts inside of the Energy Control Unit. Please return the device to OSRAM Sylvania   Inc if service is required.   Energy Control Unit Wiring   Page 3 of 4   76-015-DA 10/13   OSRAM and Logo are registered trademarks of OSRAM GmbH.   ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA, Inc   GreenBus II are trademarks of OSRAM SYLVANIA, Inc.   Download from Www.Somanuals.com. All Manuals Search And Download.   SEE THE WORLD IN A NEW LIGHT is a registered trademark of OSRAM SYLVANIA, Inc.   Regulatory Approvals   United States   OSRAM SYLVANIA   100 Endicott Street   Danvers, MA 01923   1-800-LIGHTBULB   Note: This equipment has been tested and found to comply with the limits for a Class A   digital device, pursuant to part 15 of the FCC Rules. These limits are designed to   provide reasonable protection against harmful interference when the equipment is   operated in a commercial environment. This equipment generates, uses, and can   radiate radio frequency energy and, if not installed and used in accordance with the   instruction manual, may cause harmful interference to radio communications. Operation   of this equipment in a residential area is likely to cause harmful interference in which   case the user will be required to correct the interference at his own expense.   Trade   Phone: 800-255-5042   Fax: 800-255-5043   National Accounts   Phone: 800-562-4671   Fax: 800-562-4674   OEM/Special Markets   Phone: 800-762-7191   Fax: 800-762-7192   Modifications not expressly approved by the manufacturer could void the user's   authority to operate the equipment under FCC rules.   Retail   Phone: 800-842-7010   Fax: 800-842-7011   This equipment has been tested and found to comply with Industry Canada ICES-003   Issue 5 (CAN ICES-3 (A)/NMB-3(A)).   SYLVANIA Lighting Services   Phone: 800-323-0572   Fax: 800-537-0784   The contents of this Wiring and Installation Manual are subject to change without   notice.   Display/Optic   Phone: 888-677-2627   Fax: 855-543-1043   Canada   OSRAM SYLVANIA LTD.   2001 Drew Road   Mississauga, ON L5S 1S4   1-800-LIGHTBULB   Trade   Phone: 800-263-2852   Fax: 800-667-6772   Software End User License Agreement   OEM/Special   Markets/Display/Optic   Phone: 800-265-2852   Fax: 800-667-6772   This product includes third party software under license. See   product is owned by and proprietary to Osram Sylvania Inc and licensed pursuant to   the terms of Osram Sylvania’s end user license agreement.   Retail   Phone: 800-720-2852   Fax: 800-667-6772   SYLVANIA Lighting Services   Phone: 800-663-4268   Fax: 866-239-1278   Mexico   OSRAM MEXICO   Tultitlan/Edo de Mexico   Phone: 011-52-55-58-99-18-50   ENCELIUM® Products   United States   Phone: 201-508-1570   Fax: 201-508-1589   Canada   Phone: 905-731-7678   Fax: 905-731-1401   /Sylvania   /sylvania   Page 4 of 4   76-015-DA 10/13   OSRAM and Logo are registered trademarks of OSRAM GmbH.   ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA, Inc   GreenBus II are trademarks of OSRAM SYLVANIA, Inc.   Download from Www.Somanuals.com. All Manuals Search And Download.   SEE THE WORLD IN A NEW LIGHT is a registered trademark of OSRAM SYLVANIA, Inc.   |