Ultura 2600 Platinum
Dry Iron
Instruction Booklet
SR2600
Please read these instructions carefully
and retain for future reference.
Download from Www.Somanuals.com. All Manuals Search And Download.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR IRON.
• Do not leave the iron unattended while it is
plugged into the power outlet.
• The iron must be used and rested on a stable
surface.
• Do not leave a hot iron within reach of children.
If they come into contact with a hot iron it
could lead to serious burns.
• Iron only on an ironing board.
• When placing the iron on its stand, ensure that
the surface on which the stand is placed is
stable.
• The iron is not to be used if it has been
dropped, if there are visible signs of damage or
if it is leaking.
• An iron takes approximately 30 minutes to
cool down. Allow the iron to cool completely
before storing.
• Do not wind the cord around the
soleplate while the iron is still hot.
Sunbeam is very safety conscious when designing
and manufacturing consumer products, but it is
essential that the product user also exercise care
when using an electrical appliance. Listed below are
precautions which are essential for the safe use of
an electrical appliance:
• Do not use an appliance for any purpose other
than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch any
hot surface.
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.
• Do not use your appliance with an extension cord
unless this cord has been checked and tested by
a qualified technician or service person.
• Always use your appliance from a power outlet of
the voltage (A.C. only) marked on the appliance.
• This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
damaged in any manner. If damage is suspected,
return the appliance to the nearest Sunbeam
Appointed Service Centre for examination, repair
or adjustment.
• For additional protection, Sunbeam recommend
the use of a residual current device (RCD)
with a tripping current not exceeding 30mA in
the electrical circuit supplying power to your
appliances.
• Do not immerse the appliance in water or any
other liquid unless recommended.
• Appliances are not intended to be operated by
means of an external timer or separate remote
control system.
• This appliance is intended to be used in
household and similar applications such as: staff
kitchen areas in shops, offices and other working
environments; farm houses; by clients in hotels,
motels and other residential type environments;
bed and breakfast type environments.
• Children should be supervised to ensure that they
do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while
in use.
If you have any concerns regarding the performance and use of your appliance,
Ensure the above safety precautions are understood.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Features of your Ultura Dry Iron
Thermostat light
Temperature indicator
Long cord with swivel cord outlet
Illuminates to indicate
that the iron is heating
and goes out when
Align the desired setting
with the temperature
indicator.
The swivel cord outlet is ideal for left
or right hand use, and provides greater
versatility and ease of movement when
ironing. The flexible grommet protects
the cord from fraying.
it has reached the
temperature selected on
the temperature dial. The
thermostat light cycles
on and off during ironing
as the iron maintains the
selected temperature.
Temperature dial
Allows you to select
the desired
temperature for
each garment.
s
Stable heel rest
Large heel rest
keeps the iron
stable on the
ironing board.
Figure 1
Teflon® Platinum Pro
non-stick soleplate
Glides easily across
all types of fabric and
prevents sticking.
Full length button groove
For ironing around
buttons.
Cord wrap facility
The built-in cord wrap
facility allows you to wind
the cord around the heel for
neat and tidy storage of the
cord when the iron is not
in use.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Using your Ultura Dry Iron
Before first use
2.Turn the temperature dial to the desired
setting by aligning the setting on the dial with
the temperature indicator. The thermostat
light will illuminate to indicate that the iron
is heating to the selected temperature. When
the thermostat light goes out the iron is at
the selected temperature and is ready to iron.
Remove any adhesive stickers, plastic covers
or cardboard sleeves from the soleplate.
Ensure that all adhesive is removed by
rubbing the soleplate with a cloth
dampened with methylated spirits.
NOTE: When turned on for the first time,
your new iron may give off vapours for up
to 10 minutes. This is due to the initial
heating of the materials used. It is safe, not
detrimental to the performance of the iron,
and will not reoccur.
NOTE: When the temperature dial is changed
from a high setting to a lower temperature
setting during ironing, the thermostat light
will go out immediately. This indicates
that the iron is cooling to the selected
temperature. To ensure that the iron has
reached the selected temperature and is not
too hot, wait until the thermostat light comes
on again and then goes out before ironing.
Using your iron
1.Insert the 3 pin plug into a 230/240 volt
power outlet and turn the power on.
Care and Cleaning
After each use
1.Turn the power off and remove the plug
from the power outlet.
Cleaning the Teflon® Platinum Pro non-stick
soleplate
The non-stick coating reduces sticking of
fabrics and starches to the soleplate. Do
not iron over sharp objects such as buttons,
studs and zippers, as these will scratch the
surface.
2.Allow the iron to cool before winding
the cord around the built-in cord wrap.
Storage
Always store the iron on its heel rest.
Wipe the soleplate with a damp soft cloth
after each use. If polyester has burnt to the
soleplate, iron a damp cotton cloth while hot.
NOTE: Do not store the iron with the soleplate
facing down, or in the carton.
Cleaning
Caution: Do not use scouring pads, abrasives
or harsh cleaners to clean your Teflon®
Platinum Pro soleplate, as these will scratch
and damage the surface.
To clean the exterior of your iron, wipe
over with a damp soft cloth and wipe dry.
Caution: Do not use harsh abrasives, chemical
cleaners or solvents to clean the exterior of
your iron as these will damage the surface.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Ironing Guide
Selecting ironing temperature
Always read garment labels and follow the
manufacturer’s ironing instructions.
• When reducing the temperature to iron
sensitive fabrics, allow approximately 2
minutes for the iron to cool to the new
setting.
• Pure woollen fabrics (100% wool) can be
ironed with the temperature dial set to
Wool. Use an ironing cloth to prevent shine
marks on the fabric.
• Fabrics such as velour, wool, linen and silk
are best ironed with an ironing cloth to
prevent shine marks.
• Never iron areas of a garment where
perspiration marks are visible, as the heat
of the iron will fix the stains, making them
permanent.
Hints for easier ironing
• Sort articles to be ironed according to the
type of fabric. This will reduce the need
to adjust the temperature to suit varying
garments.
• Start with garments requiring lower
temperatures and work your way through to
items requiring higher temperatures.
• If you are unsure of the fabric content of
a garment, test a small area such as a
seam or inside hem section before ironing
a visible area. Start with a low temperature
and gradually increase the heat to find the
best setting for ironing the garment.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
2 Year Replacement Guarantee
In the unlikely event that this appliance develops any malfunction
within 2 years of purchase (3 months commercial use) due to
faulty materials or manufacture, we will replace it for you
free of charge.
Should you experience any difficulties with
your appliance, please phone our customer
service line for advice on 1300 881 861 in
Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim
to Sunbeam at the address listed below.
On receipt of your claim, Sunbeam will
seek to resolve your difficulties or, if the
appliance is defective, advise you on how
to obtain a replacement or refund.
In Australia you are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to
a major failure.
Should your appliance require repair or
service after the guarantee period, contact
your nearest Sunbeam service centre.
Your Sunbeam 2 Year Replacement
Guarantee naturally does not cover misuse
or negligent handling and normal wear and
tear.
For a complete list of Sunbeam’s authorised
service centres visit our website or call:
Australia
Similarly your 2 Year Replacement Guarantee
does not cover freight or any other costs
incurred in making a claim. Please retain
your receipt as proof of purchase.
1300 881 861
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
The benefits given to you by this guarantee
are in addition to your other rights and
remedies under any laws which relate to the
appliance.
New Zealand
0800 786 232
26 Vestey Drive, Mt Wellington
Auckland, New Zealand
Our goods come with guarantees that cannot
be excluded under the Australian Consumer
Law and under the New Zealand Consumer
Guarantees Act.
Download from Www.Somanuals.com. All Manuals Search And Download.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Or call 1300 881 861
In New Zealand
Or call 0800 786 232
is a registered trademark.
‘Ultura’ is a registered trademark of Sunbeam Corporation.
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright. Sunbeam Corporation Limited 2010.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Unit 3, Building D
26 Vestey Drive
Mt Wellington Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
8/11
Download from Www.Somanuals.com. All Manuals Search And Download.
|