Sunbeam Bedding Electric Heater HE2100 User Manual

Compact Ceramic  
Oscillating Heater  
1800W oscillating heater with ceramic element  
Instruction Booklet  
HE2100  
Please read these instructions carefully and  
retain for future reference.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Sunbeam’s Safety Precautions  
Sunbeam are very safety conscious when  
• Never leave an appliance unattended while  
in use.  
designing and manufacturing consumer products,  
but it is essential that the product user also  
exercise care when using an electrical appliance.  
Listed below are precautions which are essential  
for the safe use of an electrical appliance:  
• Do not use an appliance for any purpose  
other than its intended use.  
• Do not place an appliance on or near a hot gas  
flame, electric element or on a heated oven.  
Do not place on top of any other appliance.  
• Read carefully and save all the instructions  
provided with an appliance.  
• Do not let the power cord of an appliance hang  
over the edge of a table or bench top or touch  
any hot surface.  
• Always turn the power off at the power outlet  
before you insert or remove a plug. Remove  
by grasping the plug - do not pull on the cord.  
• For safety reasons and to avoid maintenance  
by unskilled persons, some appliances are  
‘sealed’ using tamperproof screws. Such  
appliances should always be returned to the  
nearest Sunbeam Appointed Service Centre  
for adjustment or repair if required.  
Turn the power off and remove the plug  
when the appliance is not in use and  
before cleaning.  
• Do not use your appliance with an extension  
cord unless this cord has been checked  
and tested by a qualified technician or  
service person.  
• Do not operate any electrical appliance with  
a damaged cord or after the appliance has  
been damaged in any manner. If damage is  
suspected, return the appliance to the nearest  
Sunbeam Appointed Service Centre  
• Always use your appliance from a power  
outlet of the voltage (A.C. only) marked  
on the appliance.  
for examination, repair or adjustment.  
• This appliance is not intended for use by young  
children or infirm persons unless they have  
been adequately supervised by a responsible  
adult to ensure that they can use the appliance  
safely.  
• For additional protection, Sunbeam  
recommend the use of a residual current  
device (RCD) with a tripping current not  
exceeding 30mA in the electrical circuit  
supplying power to your appliances.  
• Young children should be supervised to ensure  
that they do not play with the appliance.  
• Do not immerse the appliance in water  
or any other liquid unless recommended.  
If you have any concerns regarding the performance and use of your appliance,  
Ensure the above safety precautions are understood.  
1
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Sunbeam’s Safety Precautions  
• This heater becomes hot during use. To avoid  
burns, do not let bare skin touch hot surfaces.  
If provided, use handles when moving this  
heater. Keep combustible materials such as  
furniture, pillows, bedding, papers, clothes and  
curtains at least 3 feet (90cm) away from the  
front of the heater and keep them away from  
the sides and rear.  
• Do not locate the heater immediately below a  
socket outlet.  
• Do not use this heater in the immediate  
surrounds of a bath, shower, laundry area or  
swimming pool.  
• Do not insert or allow foreign objects to enter  
any ventilation or exhaust openings as this may  
cause electric shock or fire, or damage to the  
heater.  
• Extreme caution is necessary when any heater  
is used by or near children or invalids and  
whenever the heater is left unattended.  
To prevent a possible fire, do not block air  
intakes or exhaust in any manner. Do not use  
on soft surfaces, such as beds, where opening  
may become blocked.  
• Always unplug the heater when not in use.  
• Do not use outdoors.  
• Do not run the cord of the heater under  
carpeting. Do not cover the cord with throw  
rugs, runners or other floor coverings. Arrange  
the cord away from traffic areas where it will  
not be tripped over.  
• A heater has hot and arcing or sparing parts  
inside. Do not use it in areas where petrol,  
paint or flammable liquids are used or stored.  
To prevent overheating, do not cover the  
heater.  
Important instructions – retain for  
future use.  
If you have any concerns regarding the performance and use of your appliance,  
Ensure the above safety precautions are understood.  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
Sunbeam’s Total Safety System  
Safety auto shut off  
Thermal back-up device  
Your Sunbeam Compact Oscillating Ceramic  
heater is equipped with a safety system that  
detects any abnormally high temperatures  
within the heater and automatically shuts it  
off to prevent overheating. If the heater is  
getting excessively hot, an alarm will sound.  
In addition to this automatic shut-off, your  
heater contains an over temperature thermal  
back-up device to provide additional back-  
up protection. If the heater is in an overheat  
situation, the back-up device will operate,  
stopping the power flow to the element and  
fan.  
Do not operate the heater with the alarm  
sounding. Immediately turn the heater off at  
the power outlet and check that there aren't  
any objects on or around the heater.  
In the event that the back-up device is  
activated, the heater will need to be reset.  
For instructions on how to reset your heater,  
see page 7.  
This first stage of the safety system requires  
the user to manually reset the heater for it to  
resume operation.  
For instructions on how to reset your heater,  
see page 7.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Features of your Compact  
Oscillating Ceramic Heater  
Mode button  
Press the mode button to select the desired  
operating mode:  
LOW HEAT, HIGH HEAT  
AUTO, FAN or STANDBY  
Fan setting  
Ideal for circulating cool air in summer, the fan  
setting operates the fan without heat.  
 
�  
 
 
 
Power ON light  
Illuminates to indicate that the heater is  
connected to the power outlet.  
LCD screen  
The LCD screen displays the current settings  
including the ambient room temperature, the  
selected mode, or heat setting.  
Safety auto shut-off  
The safety auto shut-off system detects any  
abnormally high temperature variations within  
the heater and automatically switches it off to  
prevent overheating.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Oscillation function  
The heater oscillates 90 degrees to provide  
greater heat distribution. Simply press the  
oscillation button (OSC) to activate this  
function.  
Electronic thermostat  
The electronic thermostat allows for precise  
temperature control. Select the auto mode  
to set the electronic thermostat and turn the  
thermostat dial to the desired heat setting.  
Once your desired temperature is reached,  
the heater will cycle on and off to maintain  
it.  
Thermostat dial  
When in auto mode, turn the thermostat dial  
to select your desired temperature.  
Ceramic element  
The 1800 watt ceramic element is more  
efficient than other element types as it  
converts more electricity into heat.  
Ceramic elements are also safer than other  
element types. They do not glow and operate  
at such low temperatures that they will not  
ignite even highly flammable materials such  
as tissue paper.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Using your Compact Oscillating  
Ceramic Heater  
1.Place the heater on a flat level surface and  
ensure that the air intake and outlet are  
clear of obstructions.  
Setting the electronic thermostat  
The electronic thermostat allows you to set  
the precise temperature. Once the desired  
temperature level is reached the heater will  
cycle on and off to maintain it.  
2.Insert the plug into a 230/240V power  
outlet and turn the power on.  
1.Press the mode button until the AUTO  
mode is displayed. The LCD screen will  
display the ambient room temperature.  
3.The power on light and LCD screen will  
illuminate.  
NOTE: When the heater is switched on it  
will be automatically set to the Standby  
mode.  
2.Set the desired temperature by turning the  
thermostat dial. The selected temperature  
will appear on the LCD screen.  
4.Press the mode button to select the  
desired setting, as follows. Each time you  
press the mode button it will scroll through  
the various settings.  
NOTE: The temperature range is from  
15ºC to 30ºC.  
3.When the room temperature reaches  
the set temperature the heater will  
automatically turn off. The fan will  
continue running for 15 seconds to cool  
the heater. The unit will only turn on when  
the room temperature falls below the  
preset temperature.  
LOW  
– low heat setting  
– high heat setting  
HIGH  
AUTO  
– for operating the electronic  
thermostat  
FAN  
– for fan only operation  
without heat  
NOTE: It is normal for the heater to cycle  
on and off as it maintains the preset  
temperature. To prevent the unit from  
cycling, raise the thermostat setting.  
STANDBY  
– the heater remains inactive  
when in this mode  
NOTE: The fan speed will not change when  
the mode is changed from low to high.  
5.To switch the heater off, press the mode  
button until the standby mode is set and  
switch the power off at the power outlet.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Using the Oscillation Function  
The 90 degree oscillation function can be  
used in any mode except standby.  
2. To stop the heater from oscillating, simply  
press the oscillation button (OSC) once  
again.  
1. Press the oscillation button (OSC),  
positioned on the top of the heater. The  
heater will then begin to oscillate from side  
to side.  
Resetting the Total Safety System  
Resetting the safety auto shut-off  
Resetting the thermal backup device  
The safety auto shut-off detects any  
In addition to the safety auto shut-off, your  
heater also contains a thermal back-up  
device for additional protection. Should the  
thermal back-up device activate and switch  
off the heater it will need to be reset.  
abnormally high temperatures within the heater  
and shuts it off to prevent overheating. Should  
the safety auto shut-off activate and switch off  
the heater, it will need to be reset.  
1.To reset the heater, press the mode button  
until the standby mode is selected.  
To reset the heater, follow steps 1 to 3 on  
this page.  
2.Unplug the heater and wait 10 minutes for  
the unit to cool down.  
3.After 10 minutes, plug the heater in again  
and operate as usual.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Troubleshooting Guide  
If your heater fails to operate check the  
following:  
• Check that the thermostat is not set too  
low. Turn the thermostat dial clockwise to  
adjust the electronic thermostat until the  
heater restarts.  
• Make sure the electrical outlet or circuit  
breaker is working.  
• The safety auto shut-off may have  
activated, so follow the instructions for  
resetting on page 7.  
• Check for obstructions. If you find an  
obstruction, turn the heater off and follow  
the reset instructions on page 7.  
Care and Cleaning  
Ensure that the heater is switched off and  
disconnected from the power outlet before  
cleaning.  
Over time, dust may accumulate on the front  
grilles. This can be removed by wiping with a  
damp cloth.  
Carefully wipe the exterior of the heater with  
a soft damp cloth and dry thoroughly with a  
dry cloth.  
Store the heater in a cool dry place when  
not in use. Store the heater in its carton if  
possible.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
‘Sunbeam’, is a registered trademark of Sunbeam  
Corporation.  
Made in China. Due to minor changes in design or  
otherwise, the product may differ from the one shown  
in this leaflet. Backed by Sunbeam’s 2 Year  
Replacement Guarantee and National Service Network.  
© Copyright. SUNBEAM CORPORATION LIMITED 2006.  
ABN 45 000 006 771  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
For more information or advice on this or any other  
Sunbeam appliance, visit www.sunbeam.com.au or  
contact the Sunbeam Consumer Service Line.  
Australia 1800 025 059  
New Zealand 0800 786 232  
12/05  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Consumer Information  
Australia  
1800 025 059  
New Zealand  
0800 786 232  
is a registered Trademark of Sunbeam  
Corporation Limited. ABN 45 000 006 771.  
© Sunbeam Corporation Limited 2006.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Sennheiser Stereo Amplifier Audioport A1 User Manual
Sharp Air Conditioner AF R120CX User Manual
Sharp Car Video System LC 39LE650E V User Manual
Sharp Fax Machine FO 5900 User Manual
Sony Car Speaker XS P2020 User Manual
Sony Car Stereo System 4 216 840 0 User Manual
Sony Printer UPD X100 User Manual
Sony Stereo Receiver CAV M1000ES User Manual
Stow Sewing Machine STR36 User Manual
Sub Zero Ventilation Hood Model SRT484CG User Manual