Keep in a safe and dry place for future reference.
Model Number of your woofer
Serial Number
Place of purchase
Notes
PICASSO COMPONENT SYSTEM
OWNERS MANUAL/INSTALL GUIDE
Soundstream Technologies
1550 S. Maple Ave.
Montebello, CA 90640 USA
PH: 323.724.4600 FX: 323.722.8125
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
Mid-bass Installation
•
Determine the mounting location. Factory speaker locations are
Impedance
4 ohms
50Hz - 20KHz
89dB
recommended for ease of installation. When installing in the factory
speaker locations, make sure that there is enough depth to
accommodate the replacement speaker.
Freq.Response
Sensitivity
•
If an alternate locations is used, measurements should be carefully
taken before any cutting is done to insure that there is enough depth
and to make sure that the speaker will not interfere with any moving
parts in the vehicle (i.e. window gears/braces, hood/trunk cables, etc.).
Once the mounting location is decided upon, the grill-mounting ring
can be used as a template to mark the hole and screw locations. If the
panel that the speaker is to be mounted to can be removed, then it is
recommended that the panel be removed before cutting the speaker
hole. Once the hole is cut to fit the speaker, replace the panel. If there
is any metal obstruction the installation of the speaker, with top panel in
place, mark the metal that needs to be removed and then remove it
with tin snips or a saw.
Power Watts (Rms/Peak)
50Watts/100Watts
Dimensions
•
The wiring that is used should be at least 18 gauge to avoid possible
signal loss. High quality crimp style connectors should be used to
connect the wires to the speaker. Soldering wires directly to the speaker
will void the warranty. If new wiring is necessary, make sure the route
the wires under factory moldings to make the installation as neat as
possible. In addition, make sure that the new wiring is clear of any screw
or clip holes so that it will not be pinched or shorted to metal after
factory panels and screws are replaced.
Download from Www.Somanuals.com. All Manuals Search And Download.
Crossover Installation
1. The crossover should be mounted in a dry, moisture free location. Never
install the crossover in the door where it can be damaged by water and
moisture. The crossover can be installed in the door panel as long as there
is an undamaged vapor barrier.
2. There are three sets of connections on the crossover. The Input terminals
should be connected to the source of the signal (radio or amplifier). The
woofer terminals should be connected to the midbass driver. The tweeter
terminals should be connected to the tweeter. The tweeter volume can be
set at -3dB, 0dB and +3dB. Ensure that the negative polarity wire of the
tweeter is the one used for setting the tweeter volume level. Make sure
that the polarity on all connections is correct.
R3
C3
R4
R2
C1
R1
C2
L2
L1
+IN PUT- WF+ WF- TW+ -3dB 0dB +3dB
Download from Www.Somanuals.com. All Manuals Search And Download.
|