Specifications
AUDIO POWER SPECIFICATIONS
Getting Started
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
13 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
1 % total harmonic distortion.
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
FM/AM
Press the reset button with a pointed object, such
as a ball-point pen.
Other specifications
CD player section
General
Outputs
Reset button
System
Compact disc digital audio
system
Line output
Compact Disc
Player
Power amplifier control
Power antenna relay control
Bass ±8 dB at 100 Hz
Treble ±8 dB at 10 kHz
12 V DC car battery
(negative ground)
Signal-to-noise ratio
Frequency response
Wow and flutter
Laser Diode Properties
Material
Wavelength
Emission Duration
Laser output power
90 dB
10 – 20,000 Hz
Below measurable limit
Tone controls
Power requirements
Dimensions
GaAs + GaAlAs
785 ~ 815 nm (Typ.800 nm)
Continuous
Approx.178×50×178mm
(7 1/8 × 2 × 7 1/8 in.)
(w/h/d)
Approx. 182 × 53 × 162 mm
(7 1/4 × 2 1/8 × 6 1/2 in.)
(w/h/d)
Approx. 1.2 kg (2 lb. 10 oz.)
Parts for installation and
connections (1 set)
Cleaning cloth XP-CD1
Compact disc single adapter
CSA-8
Notes
• Pressing the reset button will erase the clock
setting and some memorized program and
memory functions.
• When you connect the power supply cord to the
unit or reset the unit, wait for about 10 seconds
before you insert a disc. If you insert a disc within
these 10 seconds, the unit will not be reset, and
you will have to press the reset button again.
Less than 0.5 mW*
Operating Instructions
Mounting dimensions
* This output is the value measured at a distance of
0.7 mm from the objective lens surface on the
Optical Pick-up Block.
Mass
Supplied accessories
Tuner section
Optional accessories
FM
Tuning range
87.5 – 107.9 MHz
Antenna terminal
Intermediate frequency 10.7 MHz
Usable sensitivity
Selectivity
Signal-to-noise ratio
External antenna connector
12 dBf
Design and specifications are subject to change
without notice.
75 dB at 400 kHz
65 dB (stereo),
68 dB (mono)
Harmonic distortion at 1 kHz
0.7 % (stereo),
Owner’s Record
The model and serial numbers are located on the bottom of the unit.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
product.
0.5 % (mono)
35 dB at 1 kHz
30 – 15,000 Hz
Separation
Frequency response
AM
Tuning range
Antenna terminal
530 – 1,710 kHz
External antenna connector
Model No. CDX-1150 Serial No.
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity 30 µV
For installation and connections, see the supplied installation/connections
manual.
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
4 – 8 ohms
Speaker impedance
Maximum power output 35 W × 4 (at 4 ohms)
CDX-1150
1999 by Sony Corporation Printed in Japan
Warning
Welcome !
Thank you for purchasing the Sony Compact
Disc Player. This unit lets you enjoy a variety of
features.
Additional Information
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Before playing, clean the discs with an optional
cleaning cloth. Wipe each disc from the center
out.
Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic
spray intended for analog discs.
2 Insert a flathead screwdriver between the
bracket and mounting spring. Gently pry
the spring toward the unit while pulling
the unit out a little. Repeat on the
Precautions
• If your car was parked in direct sunlight
resulting in a considerable rise in temperature
inside the car, allow the unit to cool off before
operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of a two-
speaker system, set the fader control to the
center position.
•If your car is equipped with a power antenna,
it will extend automatically while the unit is
operating.
•Connecting this unit may cause some car
battery wear when your car has no ACC
(accessory) position on the ignition key switch.
Dismounting the unit
1 Insert the supplied tool between the unit
and the frame, and rotate 90° to release
the hidden mounting spring. Repeat on
the opposite side and remove the frame.
opposite side and remove the unit.
Notes on moisture condensation
— Reorient or relocate the receiving antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
On a rainy day or in a very damp area, moisture
may condense on the lenses inside the CD
player. Should this occur, the unit will not
operate properly. In this case, remove the disc
and wait for about an hour until the moisture
evaporates.
10 mm (13/32 in.)
If you have any questions or problems
concerning your unit that are not covered in this
manual, please consult your nearest Sony dealer.
— Consult the dealer or an experienced radio/
TV technician for help.
When you play 8 cm (3 in.) CDs
Use the optional Sony compact disc single
adapter (CSA-8) to protect the CD player from
damage.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
Notes on handling CDs
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc by its edge. To keep the
disc clean, do not touch the surface.
4 mm (3/16 in.)
CAUTION
Maintenance
Fuse replacement
The use of optical instruments with this product
will increase eye hazard.
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse
blows again after replacement, there may be an
internal malfunction. In such a case, consult
your nearest Sony dealer.
Do not stick paper or tape on the labeled surface.
90°
Do not expose the discs to direct sunlight or heat
sources such as hot air-ducts, or leave them in a
car parked in direct sunlight where there can be
a considerable rise in temperature inside the car.
Fuse (10 A)
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
*I-3-866-373-11*(1)
Download from Www.Somanuals.com. All Manuals Search And Download.
|