XE-A506 Quick Start Guide
English
The following describes how to get the cash register ready for operation. Follow these steps before using the cash register for the first time.
Place the cash register on a stable, flat surface not subject to direct sunlight.
Connecting the Barcode Scanner
Initializing the Cash Register
1
2
A barcode scanner is provided with the cash register. To use
the scanner, connect the scanner before turning on the register.
To ensure the cash register operates properly, please use the following procedure:
1. Make sure the power cord plug is not inserted into the AC outlet.
REG
MGR
OPX/Z
OFF
X1/Z1
X2/Z2
2. Insert the manager (MA) key into the mode switch and turn it to the PGM position.
VOID
PGM
1. Open the Scanner port cover at the right side of the register.
2. Insert the connector of the
barcode scanner into the
3. While holding down both the
key and the
key, insert the plug into the AC outlet. The buzzer will
}
l
sound three times and “***MRS.***” will be displayed.
Scanner port, and tighten both
screws on the connector.
4. The cash register has now been initialized.
The register display will show “0.00” with “PGM”.
CAUTION: • Always unplug the power cord of the cash register
when you connect or disconnect the barcode scanner.
• Never connect devices other than the barcode scanner
before changing the interface setting. Otherwise
malfunction of the cash register will occur.
CAUTION: To charge the rechargeable batteries, keep the power on for one or two days. Leave the register with the mode
switch in a position other than “OFF”.
NOTE: If you press a key by mistake, an error message may be displayed. Press the
key to clear message after installing paper rolls.
l
Preparing the Cash Register
Installing the Paper Rolls
3
4
1. Push the printer cover forward and
1. Cut off approximately one revolution
of each paper roll. Make sure the
paper end is cut as illustrated right.
For journal paper installation
5. Set a paper roll in the paper cradle of the journal side as
detach it.
illustrated in step 2.
Correct
Incorrect
6. Insert the end of the paper into the paper chute until it is
caught by the printer auto-feed and comes out the top of
the printer. If the printer does not catch the paper, feed
For receipt paper installation
2. Remove the white retainer at the
To the printer
Retainer
2. Set a paper roll in the paper cradle
of the receipt side (upper side) as
illustrated right.
position shown right.
Correct
the paper while pressing
as illustrated in step 3.
}
NOTE: Please keep this retainer for future
use when transferring the cash
register.
7. Insert the end of the paper into the
slit in the take-up spool and fold
the paper to front side, then wind
the paper two or three turns
To the printer
Incorrect
3. Move the print head release lever
Slit
3. Insert the end of the paper into the
paper chute until it is caught by the
printer auto-feed and comes out
the top of the printer. If the printer
does not catch the paper, feed the
around the spool shaft. (Press
}
upwards as illustrated right.
Print head
release lever
to feed more paper if required.)
8. Set the spool on the bearing, and
press the
excess slack in the paper.
key to take up
}
paper while pressing
.
}
9. Replace the printer cover.
4. Cut off the excess paper with the paper cutter.
Download from Www.Somanuals.com. All Manuals Search And Download.
|