OPERATOR’S MANUAL
®
Ultra-Slim Travel Inverter 120
Converts 12V DC Power to 110V AC
Household Electrical Power + USB (5V)
Model No.
200.71520
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
00-99-000860/0808
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT: READ AND SAVE THIS SAfETY AND INSTRUCTION MANUAL.
1.
IMPORTANT SAfETY INSTRUCTIONS
Before using your Travel Inverter 120, read and understand this Owner’s
Manual.
1.1
1.2
Keep the inverter well ventilated in order to properly disperse heat gener-
ated while it is in use. Make sure that there are several inches of clear-
ance around the top and sides and do not block the slots of the inverter.
Make sure the inverter is not close to any potential source of flammable
fumes, gases or clothing.
1.3
1.4
1.5
Keep the inverter dry.
DO NOT allow the inverter to come into contact with rain or moisture.
DO NOT operate the inverter if you, the inverter, the device being operat-
ed or any other surfaces that may come in contact with any power source
are wet. Water and many other liquids can conduct electricity, which may
lead to serious injury.
1.6
1.7
Do not place the inverter on or near heating vents, radiators or other
sources of heat.
Do not place the inverter in direct sunlight. The ideal air temperature for
operation is between 50° and 80°F.
1.8
1.9
Do not use the inverter near an open engine compartment.
Only connect the travel inverter to a 12-volt accessory outlet.
1.10 Make sure the AC plug connection is tight.
1.11 Do not modify the AC or USB receptacle in any way.
1.12 Use only 15 amp fuses.
1.13 Incorrect operation of your inverter may result in damage and personal
injury. wARNINg: The inverter output is 110V AC and can shock or elec-
trocute the same as any ordinary household AC wall outlet.
wARNINg: Pursuant to California Proposition 65, this product contains
chemicals known to the State of California to cause cancer and birth de-
fects or other reproductive harm.
• 1 •
Download from Www.Somanuals.com. All Manuals Search And Download.
2.
TRAVEL INVERTER 120 PRODUCT fEATURES
1
2
2
1. Blue LED Indicator
2. 3-prong AC Outlet
3. USB Port
6
4. Power Cable Plug
5. Power Cable
3
3
6. 15A Fuse (inside of unit)
7. Protective Case
8. Velcro Strips (not shown)
7
4
4
5
5
3.
BEfORE USINg TRAVEL INVERTER 120
It is important to know the continuous wattage of the device you plan to
use with the inverter. The Travel Inverter 120 must be used with devices
drawing 120 watts or less. If the wattage is not marked on the device, an
estimate can be made by multiplying the AC input current (Amps) by the
AC voltage (110V).
Devices like TVs, fans or electric motors require additional power to start
(commonly known as the “starting or peak power”). The Travel Inverter
120 can supply a momentary surge in wattage; however, even devices
rated less than the maximum 120 watts can exceed the inverters surge
capability and cause an automatic overload shutdown.
Make sure the device you are using is compatible with a modified sine
wave inverter.
• 2 •
Download from Www.Somanuals.com. All Manuals Search And Download.
4.
OPERATINg INSTRUCTIONS
Connect Inverter Power Cable:
4.1
• Plug the included power cable into the inverter. Note, the plug will only fit
into the outlet one way.
• Push the 12V end (cigarette plug) of the power cable firmly into the 12V
accessory outlet. The LED indicator light should glow BLUE verifying the
inverter is receiving power. If the LED indicator is not on, check the con-
nection and fuses.
4.2
Connecting and using the AC or USB device:
• Make sure that the device to be operated is turned OFF.
• Plug the device into the Travel Inverter AC outlet or USB port.
• Turn the device on. If the device doesn’t work and the LED blinks, refer to
section 5.
Note: A “buzzing” sound emitted from a sound systems is the result of
ineffective filters in the sound system. This can be resolved by purchasing
a sound system with a higher quality power supply or higher quality filter.
4.3
Mounting the Travel Inverter 120 in your car:
• Peel and stick the Velcro strips on back of holder
• Attach holder to desired location in vehicle
• Slide inverter into case
5.
LED INDICATOR AND SHUTDOwN PROTECTION
The LED glows BLUE automatically when plugged into a 12V DC source
and will shut off or blink under the following conditions:
5.1
5.2
5.3
When the power input from the vehicle’s battery drops to approximately 10
volts, low battery shutdown occurs and inverter shuts off.
When the power input of the vehicle’s battery exceeds 15 volts, high volt-
age overload protection occurs.
The continuous load demand from the equipment or device being oper-
ated exceeds 120 watts.
5.4
5.5
The case temperature becomes hot (exceeds 145°F).
Reset: After shutdown occurs, determine and correct problem before
resetting.
• 3 •
Download from Www.Somanuals.com. All Manuals Search And Download.
6.
POwER SOURCE
Your average automobile or marine battery at full charge will provide an
ample power supply to the inverter for approximately 3 hours when the en-
gine is off. The actual length of time the inverter will function depends on
the age and condition of the battery and the power demand being placed
by the device being operated with the inverter.
Turn OFF the device plugged into the inverter before starting the engine.
To maintain battery power, run the engine every 2 to 3 hours for approxi-
mately 10 minutes to recharge the battery. The Travel Inverter 120 draws
very low amperage when not in use, and should be unplugged to avoid
battery drain.
7.
USAgE ExAMPLES
Device Type
Estimated wattage
10 Watts
Cell Phones, MP3 Players
Portable CD Players
Laptop Computers
Video Games
50 Watts
90 Watts
100 Watts
8.
SPECIfICATIONS
Maximum Continuous Power
Surge Capacity (Peak Power)
No Load Current Draw
Wave Form
120 Watts
240 Watts
<0.4 Amp, 400mA
Modified Sine Wave
10.5 – 15.5V DC
N/A
Input Voltage Range
Low Battery Alarm
Output Voltage
110 – 125V AC
Low Battery Shutdown
High Battery Shutdown
Optimum Efficiency
AC Receptacles
9.9V – 10.8V DC
15.0V – 16.0V DC
>85%
One, NEMA 5-15 (USA) 110V AC 3-Prong
One, 5V, 0.5A
USB Port
Dimensions
3.75”H x 2.75”W x .875”D
Approximately .4 lbs.
15 Amp (250V)
Product Weight
Fuse
• 4 •
Download from Www.Somanuals.com. All Manuals Search And Download.
9.
REPLACEMENT PARTS
15 A fuse: - 3900000190
Power cable: 0699000329
10. TROUBLESHOOTINg
PROBLEM: LOw OR NO OUTPUT VOLTAgE
REASON
SOLUTION
Poor contact at terminal
Unplug and reinsert the Ultra-Slim Travel
Inverter 120.
Equipment being operated is drawing
too much power
Use a higher capacity inverter or do not
use the device.
Inverter is too hot (thermal shut down) Allow inverter to cool. Check for adequate
ventilation. Reduce the load on the in-
verter to rated continuous power output.
Blown Fuse in Power Cable
A blown fuse is usually caused by reverse
polarity or a short circuit within the device
being operated. To replace:
• Disconnect the device immediately.
• Find the source of the problem and
repair it.
• Install a new 15-amp fuse. Do not
tighten the fuse cap too far; finger tight
is sufficient.
NOTE: Installing a fuse higher than 15-
amps may cause damage to the inverter.
Inverter may be defective
Call 1-800-SEARS-64 for troubleshooting
assistance.
• 5 •
Download from Www.Somanuals.com. All Manuals Search And Download.
• 6 •
Download from Www.Somanuals.com. All Manuals Search And Download.
|