WASHING MACHINE
Owner’s Instructions
SW-T65A1(P) / SW-T65B1(P) / SW-T65C1(P)
FEATURES
PRECAUTIONS
1
1
DESCRIPTION AND CLEANING OF PART 2
CLEANING THE MACHINE
CONTROL PANEL
WASHING PROCEDURE
To Wash
To Spin Dry
To Rinsing
2
2
3
3
3
3
3
4
4
4
4
4
5
5
5
Overflow rinse
Additional rinse
INSTALLATION
Location
Connecting the drain hose
Mounting the legs
LAUNDRY GUIDE
MAINTENANCE
TROUBLE SHOOTING
Before operating the washing machine, please read this manual
thoroughly, and retain it for future reference.
Download from Www.Somanuals.com. All Manuals Search And Download.
DESCRIPTION AND /CLEANING OF PARTS
.
CLEANING THE FILTER
• Pull the overflow filter out and take up
the filter by removing 3 screws as
shown in figure. Wash the filter and
washing tub.
SPIN DRYER LID
When you open this
INNER LID
lid while the spin basket is
spinning,the spinning will
be stopped by the brake
system.
CLEANING THE FILTER
DRAIN HOSE
• Push the strainer(filter) out and take
SPIN DRYER BASKET
(with pump)
up the filter as shown in figure.
Wash the filter and washing tub.
POWER CORD
The plug’s shape
may not be similar to that
shown in this drawing.
OVERFLOW
FILTER
LINT FILTER
This is used for
gathering the
DRAIN FILTER
In case of incomplete drain,
disassemble the drain filter with
screw driver(+), and remove
lints from the filter as shown
in the filter as shown in
the figure.
dregs made during
washing.
WATER DRAIN HOSE
(without pump)
WASH TUB LID
Be sure to keep
the lid closed
EARTH WIRE
during washing
and spinning.
HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter
not to wet the floor.
WASH TUB
PULSATOR
DRAIN FILTER
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and
rotate the filter
clockwise until it
locks in position.
OVERFLOW FILTER
• Pull the upper side of the
overflow filter with your
fingers into the holes
in the direction of
CLEANING THE LINT FILTER
• If the dregs are piled up in the
lint filter after finishing the wash,
push down and
OVERFLOW FILTER
Pull the upper side of the
overflow filter with
two fingers inserted into
hole ‘A’ in the
A
pull it out as
direction of arrow
arrow as shown
shown in the
as shown in the figure.
in the figure.
figure.
• Wash the filter
net in water.
CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level(
, then drain water from the wash tub simultaneously with
operating wash cycle for 1~2 minutes. •Close the wash tub lid.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WASHING PROCEDURE
TO WASH
TO SPIN DRY
TO RINSING
1. Before starting to wash, proceed as follows,
Connect the water supply
1. Transfer the clothes into the
spin basket and arrange the
clothes evenly.
1. Set the cycle selector KNOB to
‘WASH.RINSE’.
Wash/Rinse
Wash
hose and open the water tap.
• Lay the drain hose down toward
a sinkhole. (In case no drain pump)
• Place the drain hose in sink or bath.
(In case no drain pump)
(In the case of
Drain Rinse
Drain
drain pump
‘WASH’)
CYCLE SELECTOR
CYCLE SELECTOR
2. Be sure to replace the safety
cover and close the
inner lid
2. Supply the proper amount of water
so as not to delete one space overflow
the top of the washing tub.
• Connect the power cord to the power
supply outlet.
inner lid.
safty cover
0
Soft
Normal
15
3
6
2. Set the WASH SELECTOR
KNOB to the desired mode.
3. Set the WASH TIMER to
2~3 minutes.
12
9
WASH SELECTOR
Wash Spin
3. Close the spin
dryer lid.
WASH TIMER
3. Set the WTER SELECTOR
KNOB to the desired mode.
(FOR SW-T65B1, SWT65C1)
4. Drain the water. Set the delete
one space cycle selector
KNOB to ‘DRAIN’.
WATER SELECTOR
4. Set the CYCLE SELECTOR KNOB to
“WASH.RINSE”.(in case drain pump WASH)
5. Repeat this cycle until drain
water is clean. (2~3 cycles)
0
3
4. Set the SPIN DRY
TIMER 1-5minutes.
5
4
1
2
Wash/Rinse
Wash
Drain Rinse
Drain
SPIN DRY TIMER
OVER FLOW RINSE
CYCLE SELECTOR
CYCLE SELECTOR
Wash/Rinse
Wash
1. Keep supplying
5. Fill water in the wash tub
and add the detergent.
Drain Rinse
Drain
water(adjust water
pressure to ensure
that the amount of
water supplied does not exceed the amount
of water drained.)
CYCLE SELECTOR
CYCLE SELECTOR
6. Load laundry in the
wash tub and fill water
to proper water level.
0
15
12
3
6
2. Set the WASH TIMER
6~8 minutes.
7. Set the WASH TIMER
1-15 minutes.
0
15
12
3
6
9
WASH TIMER
3. As soon as the
WASH TIMER
shuts off, turn off
the water tap.
0
8. After washing, set the CYCLE
SELECTOR
9
15
3
WASH TIMER
KNOB to 'DRAIN' for drain.
12
6
9
WASH TIMER
4. Set the CYCLE
SELECTOR KNOB
to ‘DRAIN’.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION
CHANGING THE POSITION
OF THE DRAIN HOSE
ADDITIONAL RINSE
LOCATION
Leave some space of
at least 15cm between the washing machine
and the wall.
1 After rinsing you can select this
course for more effective rinse
(Don't just select this course
for rinse.) Load the laundry
evenly into the spin basket.
Before attempting to change the position of the
drain hose, disconnect the plug from the outlet.
Place the washing machine on a sturdy flat 1. Route the drain hose inside the machine.
surface.
2.Take out the drain hose from the opposite hole
and insert the drain hose into the hose holder.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2˚)
2 Set the WATER SELECTOR
KNOB to SPIN and
Wash
Spin
CYCLE SELECTOR
KNOB to ‘DRAIN’.
Never install the washing machine near water.
Do not place the washing machine in steamy rooms
or where the washing machine is directly exposed
to rain. Moisture may damage electrical insulation
and cause an electrical shock to occur.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected
by direct heat, never place the washing machine
near heaters, boilers, etc., or under direct sunlight.
WATER SELECTOR
2
1
3 Supply water for about 1 minute.
Adjust the water flow to prevent
overflow from the wash tub.
Hose holder
CONNECTING THE DRAIN HOSE
After attaching the connector ring(a), insert
the drain hose(b) in the draining direction.
4 After completing the water supply,
cover the laundry with
safety cover and close
the inner lid.
inner lid
safety
cover
a
Install the drain hose
b
about 70~80cm above
the ground for pump model.
5 Close the spin dryer lid.
0
6 Set the SPIN DRY
TIMER 2~3 minutes.
CONNECTING THE DRAIN HOSE
1. Before connecting the drain hose, remove
the cover (a) from the drain hole.
2. After pressing the joint ring (b), insert the
drain hose(c) to drain direction.
5
1
2
MOUNTING THE LEGS
4
Lay down the washer with its back facing
downward. Insert four legs into the leg mounting
sections of the base corners of the main body.
3
SPIN DRY TIMER
Claw
Insert the claw of the
leg with the square
hole of the leg
Square
hole
2
1
mounting section,
and push the leg in
the arrow direction
(a)
(C)
(C)
(b)
(b)
(In case of pump
drained washer)
as shown in the
figure until it clicks.
Leg
Bottom face of
main body
4
Download from Www.Somanuals.com. All Manuals Search And Download.
LAUNDRY GUIDE
MAINTENANCE
TROUBLE SHOOTING
TO LOAD THE LAUNDRY INTO
THE SPIN BASKET.
Press the laundry evenly and put the safety
cover into the spin basket as shown in the
figure.
WASHING TIME
TROUBLE
CHECK POINT
WASHING
SELECTION
WASHING TIME
TYPE OF CLOTHING
The washing
machine does connected to a power outlet.
not work.
Check that the power cord is properly
10 to15 minutes
Extremely soiled
heavy fabric
Is there a power failure?
Is the machine overloaded?
NORMAL
Clothes do
Linen, cotton, etc.
not move freely.
8 to10 minutes
7 minutes
Is the laundry arranged
evenly?
Incomplete
spinning
Ordinary clothes
(underwear,etc)
Is the filter clogged with lint?
• See “Cleaning of parts”.
Slightly soiled
synthetic fiber
Incomplete
draining
2 to 5 minutes
SOFT
100% wool, mixed wool knitting,
thin synthetic fiber with
2 to 5 minutes
TO RETRIEVE THE CLOTHING THAT HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safety reason, pull the power supply plug out of the
socket.
1. Unscrew the spin dryer hatch.
2. The spin dryer hatch is
fixed to the brim by the
concave and convex
parts at two places.
Expand the concave and
Is the spin dryer lid closed
completely?
Are laundry items (socks, etc.) falling
out of the spin dryer basket and
clinging to the axle?
The spin dryer
basket will not
run.
tags indicating hand washing
SPIN DRY TIME
TYPE OF FABRIC
Thin (synthetic fiber)
TIME
1 min.
• See “To retrieve...”on page 5.
wool
cotton
1~2 min.
3~5 min.
5 min.
AFTER OPERATION
1. Remove the power cord from the outlet.
2. Take out the laundry.
thick (cotton)
convex parts,and pull up
the spin dryer hatch to
3. Close the water tap and disconnect the water
supply hose.
DETERGENT
WATER
LEVEL
AMOUNT OF
DETERGENT
remove it.
3. Retrieve the clothing.
4. Close the spin dryer hatch. Push the hatch
firmly until the catch at the front is securely
attached.
4. Clean the washing machine.
- Periodical cleaning will extend the life of your
washing machine.
- Do not spray the unit water or use tinner, benzene,
alcohol etc, for cleaning it.
The amount of detergent
is average. Follow the
instruction printed on the
package for amount of
detergent. Choose the
amount of detergent
Low (30l)
30g
40g
50g
Medium (40l)
High (50l)
according to the fabric type.
DETERGENT
In case the water level is at “High”,
amount of water is 42l.
-H-
Follow the directions printed on the package
for amount of detergent. Choose the amount of
detergent depending on the fabric type and
water level.
CLEANING THE WASHING MACHINE
Wipe off stains on the cabinet and operation pane
with a soft cloth. Neither use benzene, thinner,
cleanser, or wax, nor scrub the washing machine
with a brush. Painted surfaces or plastic parts will
be damaged.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
SPECIFICATIONS
DIMENSIONS
SW-T65A1P
SW-T65B1P
SWT65C1P
776 434 844 mm
776 444 953 mm
776 434 941 mm
WATER PRESSURE
WEIGHT
0.05~0.78 MPa(0.5~8.0 Kg
SW-T65A1(P)
SW-T65B1(P)
SWT65C1(P)
24Kg(26Kg)
26Kg(28Kg)
26Kg(28Kg)
EXTRACTION EFFICIENCY
STANDARD QUANTITY OF WATER
RATING TIME
50 %
50 l
Washing 1 Hour / Spinning 15 minutes
DC68 - 00099A-01
Download from Www.Somanuals.com. All Manuals Search And Download.
|