Operating Instructions
VACUUM CLEANER
❈
Before operating this unit, please read the instructions carefully.
❈ Indoor use only.
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLING THE CLEANER
1
OPTION
OPTION
Features may vary according to model. Refer to 5,6 page.
CAUTION
Please do not press the button of
dust bin handle when carrying
machine.
For storage, park the floor nozzle.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATING THE CLEANER
2
2-1. POWER CORD
NOTE
When removing the
plug from the
electrical outlet, grasp
the plug, not the cord.
2-2. POWER CONTROL (INFRARED CONTROL)
1) REMOTE CONTROL TYPE
- HOSE
1. Vacuum cleaner ON/OFF (
)
Press the ON/OFF button to operate the vacu-
um cleaner. Press again to stop the vacuum
cleaner.
SENDER
2. Vacuum cleaner (+ , -)
Press the (+) button to operate the vacuum to
highsuction power. Press the (-) button to oper-
ate the vacuum to low suction power.
HANDLE CONTROL
[The cleaner is controlled by using
infrared signals.]
NOTE : Don’t cover the handle sender when
you use a handle control button.
- BODY
OPTIONAL - DIGITAL SIGNAL
Press the power ON/OFF button repeatedly to
start and to stop the vacuum cleaner
(OFF → ON → OFF)
POWER ON/OFF
NOTE : If the remote handle control is not
working, the cleaner can be operated
using the ON/OFF button on the body
of the machine.
RECEIVER
The IR light indicates the part
that receives the infra-red signal
from the handle control.
The ON/OFF button operates the
vacuum cleanner or stops it.
The filter light is illuminated when the dust pack
requires checking or emptying. An audio signal will
also sound.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
2) BODY-CONTROL TYPE
- HOSE
- BODY
To control power level, just slide the power control
botton right and left.
off = For stopping the vacuum cleaner.
MAX = For hard floors and heavily soiled carpets.
To reduce suction for cleaning draperies,
small rugs, and other light fabrics, pull the
tap air until the hole is open.
2-3. HOW TO USE AND MAINTAIN THE ACCESSORIES
Features may vary according to model.
PIPE
Adjust the length of the telescopic
To check for blockages, separate the telescop-
ic pipe and adjust to shorten. This allows for
easier removal of waste clogging the tube.
pipe by sliding the length control but-
ton located in the center of the tele-
scopic pipe back and forth.
ACCESSORY
Push the accessory on to
the end of the hose han-
dle.
Pull out and turn the dust-
ing brush for cleaning deli-
cate areas.
All in one Accessory
To use the upholstery tool,
push the accessory on to
the end of the hose handle
in the opposite direction.
1
2
3
4
5
ELBOW EXTENDING TUBE
(OPTION)
1. Connect the elbow extending tube to connecting part for hose knob
and telescopic pipe.
2. Fit the telescopic pipe to the lower part of the elbow extending tube.
3. Press the PUSH button.
4. With the PUSH button pressed, the elbow extending tube is folded.
5. Using the elbow extending tube allows hard to reach areas (e.g. under
furniture)to be cleaned without having to kneel down.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
OPTION
- Carpet
Cleaning
- Floor
Cleaning
Adjust the inlet lever according to the Remove waste matter completely if
floor surface.
the inlet is blocked.
OPTION
OPTION
Vacuum dust in wide area at once
Remove waste matter completely
if the inlet is blocked.
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
1
2
3
Remove waste matter
such as dust and hair
tangled around the
Remove the brushbar
from the transparent
screen.
Push the Open button of
the transparent screen
cover to separate the cover.
brushbar using scissors.
4
5
6
For improved pick-
up of pet hair and
fibre on carpets
Remove dust inside the
brush housing using a
Insert brushbar into
rotating belt and
Click the transparent
screen cover back into
place to reassemble.
dry duster or crevice tool. assemble.
Clogs on turbine keeps brush from turning, and in this case, take care of it.
Turbine
OPTION
Brush
Remove waste
matter com-
pletely when
inlet is blocked.
To reassemble, align the cover to the
front of the main body and close. After
closing the cover, ensure that the lock
button is turned to the ‘LOCK’ position.
Brush for blanket
Turn the lock button to
‘UNLOCK’, and remove
waste matter.
For picking up pet hair
and fibre on upholstery
and bed linen.
Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
EMPTYING THE DUST BIN
3
1
2
3
Once dust reaches the DUST
FULL mark, empty the dust bin.
Take the dust bin out by
pressing the button.
Separate the dust
bin cover.
4
5
6
Throw the dust away
in the bin.
After empting the DUST
Before use, push the dust bin
into the main body of the vac-
uum cleaner until you hear
the "click" sound.
BIN, remove the obstacles
like hair, fur on the cap of
the DUST BIN.
- Empty into a plastic bag
(recommended for asthma/allergy sufferers)
OPTION
NOTE
You may rinse
the dust bin with
cold water
6
Download from Www.Somanuals.com. All Manuals Search And Download.
CLEANING THE DUST PACK
4
4-1. WHEN TO CLEAN THE DUST PACK
- Please, check the dust bin and dust pack if suction is noticeably reduced or
the filter check indicator lamp turns on after empting the dust bin.
The lamp will illuminate to signal
when suction is reduced.
If the light comes on, please
clean the DUST BIN as shown.
4-2. CLEANING THE DUST BIN
1
2
NOTE :
Please, check the filter
check indicator lamp
(4-3) as shown in the
following illustrations if
the lamp is still illumi-
nated even after clean-
ing the dust bin.
After empting the DUST BIN,
remove the obstacles like hair,
fur on the cap of the DUST BIN.
Detach the DUST BIN.
4-3. CHECKING THE FILTER CHECK INDICATOR LAMP
Turn the vacuum power to 'MAX'
HANDLE CONTROL
BODY CONTROL
If the filter check indicator turns
red with the inlet floating 10cm
above flat floor, clean the DUST
PACK.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
4-4. CLEANING THE DUST PACK
1
2
3
Remove the dust bin and dust
pack as shown.
Remove the fixed frame
of the dust pack cover.
Remove the sponge and filter
from the dust pack.
4
5
6
Wash the sponge and the filter
of the dust pack with water.
Let the sponge and filter dry
in the shade for more than
12 hours.
Put the sponge and filter
into the dust pack.
7
8
Before reassembly,
align the dust pack cover
and dust pack correctly.
Put the assembled dust pack
into the main body.
NOTE : Make sure the filter is completely dry before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
CLEANING THE MOTOR PROTECTION FILTER
5
Remove the motor protection filter from
the vacuum cleaner. Shake and tap the
dust from it and put back in machine.
Take out both the dust bin and the
dust pack.
CLEANING THE OUTLET FILTER
6
1
2
Remove the dust bin.
Pull out the HEPA Filter as shown.
3
4
Dust the HEPA filter.
Put the HEPA filter into the main body
until you hear a ‘click’ sound.
OPTION - MICRO CARBON FILTER
NOTE :
Replacement filters are avail-
able at your local Samsung
distributor.
Remove and replace the blocked outlet filter.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
CHANGE THE BATTERY(OPTIONAL)
7
BATTERY TYPE : AAA Size
NOTE
1. When the vacuum cleaner does not work, replace the batteries.
If the problem persists, please contact our authorized dealer.
2. Use 2 batteries of size AAA.
1. Never disassemble or recharge the batteries.
2. Never heat up the batteries or throw them into fire.
3. Do not reverse (+),(-) poles.
4. Dispose of the batteries properly.
WARNING
- IF YOU HAVE A PROBLEM
PROBLEM
CAUSE
REMEDY 0
Motor does not start.
No power supply.
Thermal cut-out.
Check cable, plug and socket.
Leave to cool.
Suction force is gradually
decreasing.
Nozzle, suction hose or tube Check for blockage and
is blocked.
remove it.
Cord does not rewind fully.
Check that the cord is not
twisted or wound unevenly.
Pull the cord out 2-3m and
push the cord rewind button.
Vacuum cleaner does not
pick up dirt.
Crack or hole in hose.
Filter is full of dust.
Check hose and replace if
required.
Low or decreasing suction
Please check filter and, if
necessary, clean as illustrat-
ed in the instructions.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
MEMO
Download from Www.Somanuals.com. All Manuals Search And Download.
MEMO
Download from Www.Somanuals.com. All Manuals Search And Download.
MEMO
Download from Www.Somanuals.com. All Manuals Search And Download.
MEMO
Download from Www.Somanuals.com. All Manuals Search And Download.
DJ68-00369L REV(0.3)
Download from Www.Somanuals.com. All Manuals Search And Download.
|