SECO LARM USA Home Security System EV 5120 N3WQ 480 TV User Guide

Covert PIR Camera  
(Non-Functioning PIR)  
Manual  
Model  
Resolution  
480 TV Lines  
480 TV Lines  
600 TV Lines  
600 TV Lines  
Video Output  
NTSC  
EV-5120-N3WQ  
EV-5120-P3WQ  
EV-5620-N3WQ  
EV-5620-P3WQ  
PAL  
NTSC  
PAL  
Camera is covertly hidden in a  
non-functioning PIR sensor housing  
1/3” Sony Super HAD II CCD  
3.7mm lens (78° viewing angle)  
480 or 600 TV lines  
Low current draw: 200mA  
Note: Model numbers that end with “Q” or that have a round green “Q” sticker signify RoHS-compliant products.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ENFORCER Covert PIR Camera  
Overview:  
Slide camera  
downward onto  
the mounting  
bracket  
Important:  
Do not cut the DC jack or the female BNC  
connector as this will void the warranty.  
Mounting bracket  
Camera  
Female BNC connector  
DC Plug with terminal block  
DC jack  
Before Starting:  
1. Please read this manual carefully and  
keep it for future reference.  
2. Use the camera within given temperature  
and electrical limits.  
3. Do not mount the camera where it is  
exposed to rain or other moisture, or in  
humid or dusty places.  
5. Do not mount the camera in areas  
exposed to radiation, strong magnetic  
fields, or strong electrical signals.  
6. Do not open or disassemble the camera.  
There are no user-serviceable parts inside.  
7. Do not drop the camera or subject it to  
strong vibrations.  
4. Do not point the camera at the sun. Heat  
could damage the camera, even when  
not in use.  
Installation:  
1. Run a 12VDC power supply wire and  
a video cable with a male BNC  
connector through the wall to where  
the camera will be mounted.  
2. Connect the camera’s video and  
power cables.  
3. Do a preliminary test of the camera to  
ensure it will work properly at that  
location.  
pulling it downward, off the camera.  
5. Partially screw a screw into the wall where  
the top of the bracket should go. Slide the  
bracket onto the screw. Finish securing  
the top of the bracket to the wall.  
6. Secure the bottom of the bracket to  
the wall.  
7. Attach the camera to the bracket by sliding  
the camera downward.  
8. Do a final test of the video camera and  
monitor.  
4. Remove the bracket (if attached)  
by gently wiggling it while  
SECO-LARM U.S.A., Inc.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
ENFORCER Covert PIR Camera  
Troubleshooting:  
Check that the camera is powered up.  
Check that the power supply’s polarity is correct.  
Check that the monitor is powered up.  
The screen is blank.  
Check that the video cable connecting the camera to the  
monitor is connected properly.  
Clean the lens using a soft, clean cloth.  
Check that the light source is adequate.  
The screen image is dim  
Adjust the monitor’s contrast knob.  
Change the position of the camera.  
The screen image has poor contrast.  
Change the position of the camera.  
Change the position of the camera.  
The screen image flickers.  
The screen image is distorted.  
The camera case is hot.  
Check that the correct power supply is in use.  
IMPORTANT  
Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws and  
statutes related to monitoring and recording audio and video signals. SECO-LARM will not be held responsible for the use of this  
product in violation of any current laws or statutes.  
WARNING  
Stop using the camera if you see a malfunction such as smoke or unusual heat, as it could cause fire or electric shock. Do not open  
the case of this device, as there are no user-serviceable components inside.  
FCC COMPLIANCE STATEMENT  
Information to the user: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to  
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the  
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if  
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.  
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to  
correct the interference at his or her own expense.  
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for  
a period of two (2) years from the date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or  
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.  
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or  
alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment  
is not operating properly as a result of causes other than defects in material and workmanship.  
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at  
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or  
property damages of any kind to the purchaser or anyone else.  
NOTICE  
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is  
one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without  
notice. SECO-LARM is also not responsible for misprints or typographical errors.  
Copyright © 2011 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part,  
without the written permission of SECO-LARM.  
SECO-LARM U.S.A., Inc.  
16842 Millikan Avenue, Irvine, CA 92606  
Tel: 800-662-0800 / 949-261-2999  
E-mail: sales@seco-larm.com  
PISCN4  
MiEV-5xx0-x3WQ_1108.docx  
4
SECO-LARM U.S.A., Inc.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

ResMed Respiratory Product Hospital Mask User Guide
RightWay GPS Receiver Mini S3 User Guide
Rockford Fosgate Car Amplifier 5002 User Guide
Roland Electronic Keyboard RD 150 User Guide
Russell Hobbs Cooktop RHGC1 User Guide
Ryobi Trimmer RY26000 User Guide
Samsung All in One Printer SCX 3405FW User Guide
Samsung Refrigerator SRS536NP User Guide
Sanus Systems Indoor Furnishings SFV49 User Guide
Sears Chipper 645B User Guide