January 2004
X-10SW Hand-held Sprayer
(Accessory To X-10 OC Chemical Delivery Systems)
Operating and
Maintenance Instructions
Download from Www.Somanuals.com. All Manuals Search And Download.
Table of Contents
Introduction
1
2
2
3
3
4
4
4
Warnings
Features
Optional Accessories
Operating Specifications
Connection to X-10C Chemical Cylinder
Pre-operational Use
Operation of the X-10SW Hand-held Sprayer
After Using or When Refilling the X-10SW
with X-10C Chemical Cylinder Attached
5
Limited Warranty
Technical Support
Replacement Parts
8
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
Introduction
This manual will prepare site personnel to operate the X-10SW
Handheld Sprayer. An orientation and training video can be used in
conjunction with this manual. If you feel that additional instruction or
procedures are necessary, please contact the factory regarding a training
class.
The X-10SW provides the ability to utilize the X-10C chemical cylinder
with a handheld sprayer. The X-10SW sprayer has a pressure washer gun-
grip handle with replaceable nozzle spray tip. The gun grip handle is
furnished with a one-piece high pressure hose and fittings to match the
X-10C chemical cylinder. High pressure swivel fittings allow easy wand
movement and either right- or left-hand operation. All X-10C safety
features are retained. There is only one releasable connector that attaches
to the X-10C chemical cylinder. The X-10SW includes a safety chain to
retain the high pressure hose should the connector become disconnected
under pressure. The X-10C chemical cylinder can be conveniently carried
in a washable backpack carrier. The X-10C is easily removed from the
carrier for refilling.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
Warnings
The X-10SW Hand Held Sprayer must not be used by any officer
until that officer has received training in X-10SW operation and
the officer has also test fired the X-10SW.
IMPORTANT - The X-10SW is a high pressure gas less-lethal
weapon. Careful handling and proper training is required. The X-
10SW high pressure hose contains Oleoresin Capsicum (pepper
spray) under high pressure when the X-10C valve is opened. The
pressure MUST BE RELEASED BEFORE the hose is discon-
nected. When the X-10SW hose is disconnected from the X-10C
chemical cylinder, be careful that no pepper spray chemical
residue drips from the high pressure hose connector.
Features
•
Easy connection to your existing X-10C chemical cylinder
•
Can be used with either 1-liter or 2-liter X-10C chemical
cylinder
•
•
•
•
•
•
Quick-disconnect high pressure swivel connectors
Heavy-duty spray wand and hose assembly
Pistol-grip handle with safety and interchangeable spray tips
Choice of replaceable spray tips
5-foot “soft-flex” high pressure hose and safety chain
Washable backpack carrier with adjustable straps and carrying
handle
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
Optional Accessories
5-inch straight bore tip
5-inch “Salinas” wide-angle spray tip
Wide-angle fog tip
26-inch flexible hose tip
Operating Specifications
Spray force:
15 ft. lbs. at 3 feet, using straight bore nozzle
Note: For ballistic test results, contact the
factory.
Recommended minimum shooting distance: 5 feet
Do not shoot at head area within 8 feet for
“Salinas” tip.
Do not shoot at head area within 12 feet for
straight bore tip.
Average shots:
1-liter chemical bottle – 21-1/4-second bursts
2-liter chemical bottle – 47-1/4-second bursts
Continuous spray: 1-liter chemical bottle – 5.6 seconds
2-liter chemical bottle – 12.5 seconds
Shooting distance: 32 feet – straight bore tip, 6-inch, level shooting
43 feet – straight bore tip, 6 inch, +10-degree
up shooting
20 feet – “Salinas” wide-spray tip, 6-inch
24 feet – 26-inch flexible hose with 4-inch
straight bore tip
Angle of spray:
20 degrees – straight bore tip, 6-inch, level
shooting
50 degrees – “Salinas” wide-spray tip, 6-inch
90 degrees – wide-angle fog tip
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
Connection to X-10C Chemical
Cylinder
Verify that the X-10C chemical cylinder valve is closed before
attempting to attach the X-10SW hose. Carefully attach the X-
10SW hose and verify that the connector is properly seated.
Attach the X-10SW safety chain to the hole in the X-10C pres-
sure gauge shroud. Verify that the safety on the spray wand pistol
grip has been set before proceeding. DO NOT open the X-10C
chemical cylinder valve until you are preparing to use the X-
10SW sprayer. Pressurize the sprayer by carefully opening the X-
10C chemical cylinder valve while observing the built-in pressure
gauge. CAUTION: ALWAYS point the X-10SW/X-10C connec-
tor away from you and in a safe direction before opening the X-
10C valve. The X-10C at full pressure should be between 550 psi
and 700 psi. An X-10C bottle used with the X-10SW handheld
sprayer with 250 psi showing on the gauge can still have up to
five remaining shots before refilling.
Preoperational Use
1. Try to talk inmate out of the cell.
2. Evaluate the barricade and the attitude of the inmate.
3. Decide the best location for probe insertion.
4. Assemble officers who will operate X-10SW. Position each
for best results depending on the amount of room available
on the floor or tier.
5. Inform inmate that you will be using the X-10SW and
allow the inmate to come out voluntarily.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
Operation of X-10SW Handheld
Sprayer
The X-10SW must be used in strict conformation with the
Department Operational Procedures.
1. Place the X-10C chemical cylinder in the fabric carrier.
2. Fasten the Velcro flap and hose straps so the bottle
cannot slip out of the fabric carrier.
3. Place the carrier on your back in the same manner that
you would any backpack.
4. Fasten the chest strap and arrange the hose for either
right-hand or left-hand operation as desired.
5. Verify that the spray wand pistol grip safety lever is in the
safe position before proceeding. Examine the spray wand
tip to be sure that it is properly seated in the quick release
connector. If not properly seated, the tip can be shot off
the pistol grip with the first chemical shot.
6. If you are using a “Salinas” or wide-angle fog tip, verify
that the tip is properly oriented to provide the desired
spray pattern.
NOTE: The spray tips can rotate during repeated use or close
contact, so check tip orientation before each use.
After Using or When Refilling the X-
10SW with X-10C chemical cylinder
Attached
After using the X-10SW, immediately close the X-10C chemical
cylinder valve to stop further chemical flow to the wand. After
closing the X-10C valve, the handheld wand must be sprayed in a
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
safe direction to release the remaining hose pressure. The pepper
spray residue in the hose may drip if not contained.
Whenever refilling the X-10C chemical cylinder, be sure to
follow the procedures contained in the X-10OC Extension
Device, Operating and Filling Instructions.
IMPORTANT - The X-10SW is a high pressure gas less-lethal
weapon. Careful handling and proper training is required. The X-
10SW high pressure hose contains Oleoresin Capsicum (pepper
spray) under high pressure when the X-10C valve is opened. The
pressure MUST BE RELEASED BEFORE the hose is discon-
nected. When the X-10SW hose is disconnected from the X-10C
Chemical Cylinder, be careful that no pepper spray chemical
residue drips from the high pressure hose connector.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
LimitedWarranty
Priax Corporation makes no warranty, expressly or by implication,
except as set forth below.
Priax Corporation warrants that the products delivered hereunder
will be in substantial conformity with applicable specifications
and will be free from defects in material and workmanship. Priax
Corporation’s obligation under this warranty shall be limited to
(at its option) repairing, replacing, or granting a credit at the
prices invoiced at the time of shipment for any of said products
which shall, within 90 days after shipment, be returned to the
factory of origin, transportation charges prepaid, and which are,
after examination, disclosed to Priax Corporation’s satisfaction to
be thus defective. This warranty shall not apply to any of such
products which shall have been repaired or altered, except by
Priax Corporation, or which shall have been subjected to physical
or electrical abuse or misuse.
THE WARRANTIES STATED HEREIN ARE IN LIEU OF
ALL OTHER WARRANTIES EXPRESSED OR IMPLIED,
AND PRIAX CORPORATION NEITHER ASSUMES NOR
AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT
ANY OTHER LIABILITY. PRIAX CORPORATION SHALL
NOT BE LIABLE FOR SPECIAL OR CONSEQUENTIAL
DAMAGES OF ANY NATURE WITH RESPECT TO ANY
PRODUCTS OR SERVICES RENDERED HEREUNDER.
NO PRODUCT IS WARRANTED TO BE FIT FOR ANY
PARTICULAR USE OR APPLICATION.
Technical Support
Technical support is provided by Priax Corporation at no charge
starting from the date of purchase. Priax Corporation will re-
spond to all service calls made during the normal work week
within a 24-hour period during normal business hours of 8:00
AM to 5:00 PM (Pacific Standard Time).
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating and Maintenance Instructions
Replacement Parts
Replacement Components
Part No.
Description
Pistol-grip handle assembly
Quick-release connector, female for Tip, 1/4
inch
X-10SW-210
X-10SW-211
X-10SW-212
X-10SW-213
X-10SW-214
X-10SW-215
X-10SW-216
Straight swivel
Hose, 5-foot with male fittings
Rotary joint, 90-degree swivel
90-degree street ell, 3/8”
Connector, male, mate to bottle, 3/8”
Replacement Tips
Part No.
Description
X-10SW-250
X-10SW-255
Nozzle tip, straight bore, 6-inch, stainless steel
Nozzle tip, “Salinas” wide-spray, 6-inch,
stainless steel
X-10SW-256
X-10SW-257
Nozzle tip, wide-angle fog, stubby brass
Nozzle tip, 26-inch flexible hose, 4-inch
straight bore tip, stainless steel
9
Download from Www.Somanuals.com. All Manuals Search And Download.
|