RUB
TECH
Fast EthernetSwitch
L2 Managed Switch
ES-2310Q
ES-2310Q:
10-Port L2 Managed Fast Ethernet Switch with 2 100Base-FX Ports
Benefits
QoS with four priority queues
Key Features
Standard compliance
The QoS(Quality Of Service) feature provides four internal queues to
---IEEE 802.3 10Base-T
support four different classifications of traffic. High priority packet streams
experience less delay inside the switch, which supports lower latency for
certain delay-sensitive traffic. The ES-2310Q can classify the packet as one
of the four priorities according to vip port, 802.1p priority tag, DiffServ and/or
IP TOS. The QoS operate at full wire speed. The actual scheduling at each
egress port can be based upon a strict priority, weighted round robin or a mix
of both.
---IEEE 802.3u 100Base-TX
---IEEE 802.3x Flow Control Capability
---ANSI/IEEE 802.3 Auto-negotiation
---IEEE 802.1q VLAN
RoHS Compliance
Subscriber Interface
---1-8 10/100Mbps Fast Ethernet ports.
---9,10 are Fast Ethernet Fiber ports with
SEP module
Port Mirroring
This mechanism helps track network errors or abnormal packet transmission
without interrupting the flow of data. Allow ingress traffic to be monitored by a
single port that is defined as mirror capture port. The mirror capture port can
be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but
can create congestion at the mirror capture port.
---Auto-Negotiation and Auto-MDIX
---Back pressure flow control for half
duplex.
---IEEE 802.3x flow control for full duplex
---Connector: 8 ports RJ-45 and 2 ports
Fiber (SEP)
Q-in-Q VLAN for performance & security
The VLAN feature in the switch offers the benefits of both security and
performance. VLAN is used to isolate traffic between different users and thus
provides better security. Limiting the broadcast traffic to within the same
VLAN broadcast domain also enhances performance. Q-in-Q, the use of
double VLAN tags is an efficient method for enabling Subscriber Aggregation.
This is very useful in the MAN.
Performance
Switching capacity:
---Non-blocking switch fabric supports up
to 8 FE+2 SEP ports
---8 K MAC addresses
Isolated Group, provides protection for certain ports
---256K packet buffer and 128K control
memory
The isolated group feature allows certain ports to be designated as protected.
All other ports are non-isolated. Traffic between isolated group members is
blocked.
VSM(Virtual Stacking Management)
---Supports 16 devices stacking
---Multiple switches can be managed via
one IP address, just like software
stacking
Traffic can only be sent from isolated group to non-isolated group.
Mac-based 802.ad LACP with automatic link fail-over
Dynamic fail-over means packets will not get assigned to any trunk member
port that has failed. If one of the ports were to fail, traffic will automatically get
distributed to the remaining active ports.
---Low cost and easily to establish
network environment, not extra
hardware require
802.1x Access Control improves network security
802.1x features enable user authentication for each network access attempt.
Port security features allow you to limit the number of MAC addresses per
port in order to control the number of stations for each port. Static MAC
addresses can be defined for each port to ensure only registered machines
are allowed to access. By enabling both of these features, you can establish
an access mechanism based on user and machine identities, as well as
control the number of access stations.
---Not center on the physical location of
wiring closets
---In tag-base VLAN, supports egress/
ingress packet filter
---Q-in-Q is an efficient method for
enabling Subscriber Aggregation
QoS
802.1d Compatible & 802.1w Rapid Spanning Tree
---Port Based (VIP Port), 802.1p , TOS
and Diffserv(IPv4/IPv6) based QoS
packet classification
For mission critical environments with multiple switches supporting STP, you
can configure the switches with a redundant backup bridge path, so
transmission and reception of packets can be guaranteed in event of any fail-
over switch on the network.
---Supports four level priority queues to
prioritize in-bound and out-bound traffic
Download from Www.Somanuals.com. All Manuals Search And Download.
RUB
TECH
Fast EthernetSwitch
L2 Managed Switch
RFC 1757 RMON MIB
Statistics Group 1
History Group 2
Ordering Information
ES-2310Q:
10-Port L2 Managed Fast Ethernet Switch with 2 100Base-FX Ports
Alarm Group 3
Event Group 9
Optional SEP Fiber Module
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
Enterprise MIB
FM-SEP.SC
SEP, FE SCMulti-Mode Fiber Module 1310nm
SEP, FE SCSingle-Mode 5km Fiber Module
1310nm
FM-SEP.SC.S05
FM-SEP.SC.S20
FM-SEP.SC.S40
FM-SEP.SC.S60
SEP, FE SCSingle-Mode 20km Fiber Module
1310nm
Overview
ES-2310Q is a Managed Fast Ethernet
switch that supports SNMP, Web UI and
CLI management interface and with 8 ports
10/100Base-TX (RJ-45 connectors) and 2
ports 100Base-FX (SEP). It is a standard
switch that meets all IEEE 802.3/u/x/z
Gigabit, Fast Ethernet specifications. In
addition, the switch implements the QoS
(Quality of Service), VLAN, Mac Filtering
Policy, Port Mirror, VLAN and full L2
protocols. It has a rich feature set suitable
for streaming VoIP, video, and data
traffics for multimedia applications.
In this switch, Port 9, 10 support 2-port
100Base-FX ports(SEP) , and the 2-port
fiber is used 2 slots for removable SEP
module supporting, they are 100Base-
FX fiber module.
SEP, FE SCSingle-Mode 40km Fiber Module
1310nm
SEP, FE SCSingle-Mode 60km Fiber Module
1310nm
FM-SEP.BS5.S20 SEP, FE BiDi SC 20km Module Single Fiber
1550nm, Type 1
FM-SEP.BS3.S20 SEP, FE BiDi SC 20km Module Single Fiber
1310nm, Type 2
Ruby Tech Corp.
2F, No.7, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan
TEL:886-2-2785-3961 FAX:886-2-2786-3012
http://www.rubytech.com.tw
|