4CEG"5ECPPGT"+PVGTEQO
YKVJ"2KV"%TGY"*GCFUGVU
20-285
OWNER’S MANUAL — Please read before using this equipment.
MIC GAIN/OFF/MAX — Turn
clockwise until you hear a click to
turn on the intercom. Turn
towards MAX to increase the
volume or towards OFF to
decrease the volume. Turn to OFF
until you hear a click to turn off
the intercom.
Right Side Jacks (R) — Connect up to
two headsets to the R jacks for the
persons sitting on the right side.
AUDIO IN — Connect the
supplied scanner cable to
AUDIO IN and the other
end of the cable to the
scanner headphone jack
to listen to a scanner.
Left Side Jacks (L) — Connect up
to two headsets to the L jacks for
the persons sitting on the left side.
Thank you for purchasing the RadioShack
earpiece. The scanner will be heard in the
right earpiece. The listener on the left will
hear the other person’s voice in the right
earpiece. The scanner will be heard in the
left earpiece.
Race Scanner Intercom with Pit Crew
Headsets. It enables up to four people to
listen to a scanner and communicate at the
same time. It comes with two headsets and
a 3-foot cable to connect a scanner to the
intercom. Additional headsets are available
at your local RadioShack store.
"+/2146#06"
If an icon appears at the end of a paragraph,
go to the box on that page with the
#
#
corresponding icon for pertinent information.
— Warning
° — Hint
± — Note
Rý
. — Caution
.+56'0+0)"5#('.;
— Important
#
To protect your hearing, follow these
guidelines when you use headsets. ±
24'2#4#6+10
• Set the volume to the lowest setting
before you begin listening. After you
begin listening, adjust the volume to a
comfortable level.
+056#..+0)"$#66'4+'5
The intercom uses four AA batteries. For the
longest battery life, we recommend
RadioShack alkaline batteries. ±
• Do not listen at extremely high volume
levels. Extended high-volume listening
can lead to permanent hearing loss.
1. Push the battery compartment cover
back and slide it off to open.
±"016'"±"
• When you turn on the intercom, the green
LED lights. If the LED turns red, replace the
batteries.
• Once you set the volume, do not
increase it. Over time, your ears adapt
to the volume level, so a volume level
that does not cause discomfort initially
might still damage your hearing.
2. Place four AA batteries in the battery
holder as indicated by the polarity
symbols (+ and –).
• If you do not use the intercom for an
extended period of time, remove the
batteries.
3. Slide the cover back in place until it
snaps shut.
• Disconnect the headset if it not being used.
Otherwise, if the microphone is placed near
the earpiece, it might cause a piercing
sound.
64#((+%"5#('6;
Do not use a headset with your intercom
when operating a motor vehicle or riding a
bicycle in or near traffic. Doing so can create
a traffic hazard and could be illegal in some
areas.
%100'%6+0)"#"5%#00'4"
• Turn MIC GAIN/OFF/MAX off or to the
lowest level before connecting or
disconnecting the headset.
61"6*'"+06'4%1/
Connect one end of the supplied scanner
cable to the scanner’s headphone jack and
the other end to the intercom’s AUDIO IN
jack.
If you use a headset with your intercom
while riding a bicycle, be very careful. Do not
listen to a continuous broadcast. Even
though some headsets let you hear some
outside sounds when listening at normal
volume levels, they still can present a traffic
hazard.
%100'%6+0)"*'#&5'65
Turn MIC GAIN/OFF/MAX off or to the lowest
level. ±
Connect a headset for the person(s) on the
left to either of the left side jacks (L) and a
headset for the person(s) on the right to
either of the right side jacks (R). This allows
them to hear each other’s voice through the
corresponding earpiece of their headset. For
example, a listener on the right side will hear
the other person’s voice in the the left
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
Download from Www.Somanuals.com. All Manuals Search And Download.
|