2SHUDWLRQ
)&&ꢀ,QIRUPDWLRQ
:KDW·Vꢀ,QFOXGHG
Your phone complies with Part 68 of FCC Rules and the requirements adopted by the
ACTA. On the back of this product is a label with this product’s FCC Product Identification
number in the format US:AAAEQ##TXXXX. If requested, you must provide this
information to the telephone company.
Making a Call
Heavy Duty Wall Phone
with Lighted Keypad
43-3260
7-foot line cord ꢀ 7-inch modular cord
1. Pick up the handset and wait for a dial tone.
2. Use the keypad to enter the number you wish
to dial.
9-foot coil cord ꢀ Owner’s Manual
Note: You must not connect your phone to:
• coin-operated systems
• most electronic key telephone systems
• party-line systems
3. Hang up the handset when you complete
your call.
Note: The phone features a lighted keypad for
dialing in a dark room.
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission, or corporation commission for information.
3UHSDUDWLRQ
Selecting a Mounting Location
We have designed your phone to conform to federal regulations, and you can connect it
to most telephone lines. However, each phone (and each device, such as an answering
machine) that you connect to the telephone line draws power from the telephone line. We
refer to this power draw as the device's ringer equivalence number, or REN on the
bottom of your phone.
Receiving a Call
When you receive a call, the phone rings. To
answer the call, pick up the handset.
Your telephone connects directly to a modular
telephone line jack. If your telephone wiring does not
have a modular jack, you can update the wiring
yourself using jacks and adapters (available at your
local RadioShack store or online at
www.radioshack.com), or have the telephone
company update the wiring for you. You must use
compatible modular jacks that are compliant with Part
68 of FCC Rules and the requirements adopted by the
ACTA. The telephone cord and modular plug provided
are Part 68 compliant for connecting to the telephone
company network.
Adjusting the Handset Volume
To adjust the handset volume before or during a
call, tune HANDSET VOL to NORM or HI.
Choose your most comfortable listening level.
If you use more than one phone or other device on the line, add up all of the RENs. If the
total is more than five (three in rural areas), your telephones might not ring. If ringer
operation is impaired, remove a device from the line.
In the unlikely event that your phone causes problems on the phone line, the phone
company can temporarily discontinue your service. If this happens, the phone company
attempts to notify you in advance. If advance notice is not practical, the phone company
notifies you as soon as possible and advises you of your right to file a complaint with the
FCC.
Redial
Using Flash
Flash performs the electronic equivalent of a
switch hook operation for special services, such
as Call Waiting. For example, if you have Call
Waiting, press FLASH to answer an incoming call
without disconnecting the current call. Press
FLASH again to return to the first call.
Tone/Pulse
Flash
Mute
Also, the phone company can make changes to its lines, equipment, operations, or
procedures that could affect the operation of this telephone. The telephone company
notifies you of these changes in advance, so you can take the necessary steps to prevent
interruption of your telephone service.
Ringer Volume
HI/LO/OFF
For single line phones:
The USOC number of the jack to be installed is
RJ11C (or RJ11W for a wall plate jack).
Please follow instructions for repairing if any (e.g. battery replacement section); otherwise
do not alternate or repair any parts of device except specified.
Notes:
• If you do not have any special phone
services, pressing FLASH might disconnect
the current call.
NOTICE: If your home has specially wired alarm equipment connected to the telephone
line, ensure the installation of this phone does not disable your alarm equipment. If you
have questions about what will disable alarm equipment, consult your telephone
company or a qualified installer.
For 2 line phones:
The USOC number of the single-line jack to be
installed is RJ11C (or RJ11W for a wall plate jack).
The USOC number for a two-line jack is RJ14C
(or RJ14W for a wall plate).
• Pressing FLASH does not hang up the
This equipment is hearing aid compatible.
system.
Handset Volume
HI/NORM
Lightning
Using Redial
To redial the last number you called, pick up the
handset and press REDIAL when you hear a dial
tone. The phone automatically dials the number.
Your telephone has built-in protection circuits to reduce the risk of damage from surges in
telephone line and power line current. These protection circuits meet or exceed the FCC
requirements. However, lightning striking the telephone or power lines can damage your
telephone.
Mounting and Connecting the Phone
To mount your phone on a wall plate, do the following:
Lightning damage is not common. Nevertheless, if you live in an area that has severe
electrical storms, we suggest that you unplug your phone when storms approach to
reduce the possibility of damage.
1. Plug one end of the supplied short modular cord
into the line jack at the back of the base.
Note: Coil any excess cord inside the compartment below the line jack at the back of the base.
2. Plug the other end of the cord into a wall plate jack.
Using Mute
To talk to someone near you without the person
you’re on the phone with hearing your
conversation, hold down MUTE. Release MUTE
when you are ready to resume your conversation.
/LPLWHGꢀ2QHꢁ<HDUꢀ:DUUDQW\
3. Align the base’s keyhole slots with the wall plate studs and slide the phone downward to secure it.
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one (1) year from the date
of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN,
RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR
PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY
DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Connecting to the Handset
Plug one end of the supplied coiled cord into the handset’s modular jack. Then, connect to the jack on the bottom of the base.
WARNING: To reduce the risk of fire or shock hazard, do
not expose this product to rain or moisture.
Setting the Ringer
If you don’t want to hear the phone ring, slide RINGER to OFF. You can still make calls with the ringer off and you can still
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.
answer calls if you hear another phone on the same line ring. If you want to hear the phone ring, set RINGER to HI or LO.
CAUTION
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date to any
RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price. All replaced parts and products, and products on
which a refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty
service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or
replacement of the product made after the expiration of the warranty period.
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
Setting the Dialing Mode
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
Slide the TONE/PULSE to the setting for the type of service you have. If you are not sure which type you have, perform this
simple test.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage,
failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e)
transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up service adjustment or reinstallation.
1. Slide TONE/PULSE to TONE. Lift the handset and listen for a dial tone.
2. Press any number except 0. If your phone requires that you dial an access code (9, for example) before you dial an outside
This symbol is intended to alert you
to the presence of uninsulated
dangerous voltage within the
product’s enclosure that might be of
sufficient magnitude to constitute a
risk of electric shock. Do not open
the product’s case.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state
number, do not press the access code number.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99
• If the dial tone stops, you have touchtone service. Set the switch to TONE.
• If the dial tone continues, you have pulse service. Set the switch to PULSE.
©2003. RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
43-3260
Printed in China
09A03
Download from Www.Somanuals.com. All Manuals Search And Download.
|