Stereo RF Modulator
15-2525
OWNER’S MANUAL —
Please read before using this equipment.
Thank you for purchasing a RadioShack Stereo RF
Modulator. Your modulator is designed to convert the
separate audio and video signals from a video camera,
computer, portable VCR, DVD player or satellite receiver
into VHF TV signals that you can view on a TV set
without Audio/Video (A/V) inputs. This means you can
connect a DVD player to an older TV's antenna/cable
input. The modulator's gold-plated jacks and terminals
assure maximum reliability and minimum signal loss.
The modulator has two sets of inputs (front/back) so you
can connect two devices at the same time.
REQUIRED ACCESSORIES
WARNING: To reduce the risk of fire or shock
hazard, do not expose this product to rain or
moisture.
Note to the CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
article 820-22 of the NEC that provides
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding
system of the building, as close to the
point of cable entry as practical.
CAUTION
A/V Shielded Cable (1)
S-Video Cable (1)
75-ohm Coaxial Cable
75-ohm to 300-ohm
RISK OF ELECTRIC SHOCK
!
DO NOT OPEN
with F-Connectors (2)
Matching Transformer(1)
Three Plugs (Stereo)
Two Plugs (Mono)
OR
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER OR BACK. NO
USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED PERSONNEL.
The lightning symbol is intended to alert you to
the presence of uninsulated dangerous voltage
within this product’s enclosure that might be of
sufficient magnitude to constitute a risk of
electric shock. Do not open the product’s case.
Use a transformer if your
TV does not have a VHF
75-ohm F-Connector.
You can use an S-Video
cable if the video source
has an S-Video jack.
The exclamation symbol is intended to inform
you that important operating and maintenance
instructions are included in the literature
accompanying this product.
!
CONNECTIONS
USING YOUR MODULATOR
Use the push-button switch on the front panel to select the
device connected to the front or the back of the
modulator. The FRONT LED lights green when
the front jacks are selected.
Connection Notes
•
•
If your TV only has 300-ohm VHF screw terminals, attach a 75- ohm to 300-ohm matching transformer to
the screw terminals and connect the coaxial cable to the transformer to complete the connection.
Your modulator has two sets of inputs, one in the back and one in the
front. The following connection information applies to either set of inputs.
Front View
The modulator selects S-Video as the first priority if both VIDEO and S-VIDEO jacks are connected.
1. Turn on the TV and set it to
channel 3 or 4, whichever is
not used for regular
Back View
USING A/V JACKS
USING THE S-VIDEO JACK
CHANNEL
The A/V jacks on your modulator are color-coded to correspond to the
colors on A/V cable plugs. Be sure to match up the jacks and plugs by
color before completing the connections.
1. Plug one end of an S-Video
cable into the S-VIDEO jack
on the modulator and the
other end into the video
source.
ANT IN
TO TV
S-VIDEO
3/4
broadcasts in your area.
2. Set CHANNEL 3 /4 on the
modulator to the same channel
you set the TV (3 or 4).
Front/Back Button
With a Stereo Video Source
1. Plug the plugs on one
Back View
2. Plug the incoming antenna’s
coaxial cable into the ANT IN
jack on the back of the
modulator.
CHANNEL
3/4
AUDIO
3. Turn on the connected
video source. Make sure
Ô Note Ô
To watch a TV broadcast, turn off all other video sources.
TO TV
ANT IN
end of a stereo A/V
cable into the desired
VIDEO and AUDIO L/R
input jacks on the
modulator.
L
R
VIDEO
•
•
(MONO)
that the front panel switch
is selecting the inputs you
are using.
The blue STEREO LED lights when the modulator is
powered.
3. Connect one end of
another coaxial cable to the
TO TV jack on the back of
the modulator, and the other
2. Plug the connections on
the cable's other end into
the Video and Audio L/R
output jacks on the
CARE
THE FCC WANTS YOU TO KNOW
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
end to the Antenna In jack on your TV.
Keep the modulator dry; if it gets
wet, wipe it dry immediately. Use
and store the modulator only in
normal temperature
4. Plug the modulator's power cord into a
standard AC outlet.
video source.
3. Connect one end of a
coaxial cable to the
environments. Handle the
modulator carefully; do not drop
it. Keep the modulator away from
dust and dirt, and wipe it with a
damp cloth occasionally to keep it
looking new.
TO TV jack on the back
of the modulator, and the
other end to the Antenna In jack on your TV.
Front View
USING THE SUPPLIED STAND
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
After you finish connecting your modulator,
you can lay it horizontally on a flat surface,
or snap the supplied stand onto the AC
power cord end to stand it up vertically.
With a Monaural Video Source
1. Plug the plugs on one end of an A/V cable into the VIDEO and L AUDIO
jacks on the modulator.
If your modulator is not
performing as it should, take it to
your local RadioShack store for
assistance. To locate your
nearest RadioShack, use the
store locator feature on
Stand
(Supplied)
2. Plug the cable's other ends into the Video and Audio jacks on the video
source.
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
RadioShack's website
3. Connect one end of another coaxial cable to the TO TV jack on the back
of the modulator, and the other end to the Antenna In jack on your TV.
1-800-The Shack (843-7422) and
follow the menu options.
•
•
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Modifying or tampering with the
modulator's internal components
can cause a malfunction and
might invalidate its warranty and
void your FCC authorization to
operate it.
Consult your local RadioShack store or an experienced
radio/TV technician for help.
SPECIFICATIONS
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers.
EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DU-
RATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY
LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM
INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair
without charge for parts and labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned
parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration
of the warranty period.
Video Carrier Output Level ............................................................................................. 6 dB mV
RF Output Channels ........................................................................................................... 3 or 4
RF Output Impedance ................................................................................................... 75 Ohms
Video Input Impedance ................................................................................................. 75 Ohms
TV to ANT Insertion Loss 50–806 MHz ................................................................................. 3dB
Dimensions .............................................................................................. 6.65 x 4.0 x 1.5 inches
If you cannot eliminate the interference, the FCC requires
that you stop using your modulator.
Changes or modifications not expressly approved by
RadioShack may cause interference and void the user’s
authority to operate the equipment.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess
voltage or current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation,
set-up service adjustment or reinstallation.
© 2003 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks used
by RadioShack Corporation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
02/03
Specifications are typical: individual units might vary. Specifications are subject to change and
improvement without notice.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99
Printed in USA
Download from Www.Somanuals.com. All Manuals Search And Download.
|