RTS Network Card RT 2M User Guide

RT-2M (90007891000) Quick Start Guide  
INCLUDED PARTS:  
RT-2M Unit  
DB-9 Cable  
NOTE:  
See the entire system diagram on reverse side.  
Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the Step 2. Cable the RT-2M to the Frame.  
RT-2M.  
RS-232 Cable Pinout  
To cable the RT-2M to the Frame, do the following:  
NOTE:  
In Trunk Supervisor, you must designate  
the intercom and port number the RT-2M  
sends the test signal over.  
1. Using the appropriate connector defined below, connect the  
RT-2M to the Frame:  
CONNECTOR  
CONNECTION  
To cable the Trunk Supervisor/TrunkEdit PC to the  
RT-2M, do the following:  
Plug pins 2 and 5 into the Ch 1 input connector terminals.  
RJ-12  
Plug pins 3 and 4 into the Ch 1 output connector terminals.  
Plug pins 7 and 8 into the Ch 1 input connector terminals  
Plug pins 4 and 5 into the Ch 1output connector terminals.  
1. Using the included cable, connect a COM port on  
the Trunk Supervisor computer to the RS-232  
DB-9  
Interface connector on the rear panel of the RT-2M.  
2. Connect the other end of the connector to the trunking  
connection port as defined in the Trunk Supervisor software.  
LIT000306000 Rev. A  
11/2008  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Radio Shack Automobile Accessories 60 4395 User Guide
Radio Shack Network Cables 273 1687 User Guide
Reebok Fitness Home Gym RBEX33190 User Guide
Renesas Computer Hardware M38C59T RLFS User Guide
Rugged Outback Switch RS416 User Guide
Saab Automobile 5 Sep User Guide
Samsung All in One Printer SCX 4016 User Guide
Samsung Microwave Oven ME1060BB User Guide
Seiko Group Printer BP 9000 User Guide
Seiko Watch CAL 7T94 User Guide