42-7011
Dual-Tray CD Player/Recorder
A QUICK LOOK AT THE REMOTE
Refer to your Owner’s Manual for complete instructions.
PLAYING A CD
CONNECTING AND POWERING YOUR RECORDER
Follow the diagram to connect your recorder to your receiver.
You can use the RECORD/PLAYBACK tray to play back CD, CD-R, and CD-
RW discs. You can use the PLAYBACK tray to play back CD and finalized
CD-R/CD-RW discs. You cannot play CD-R/CD-RW discs that have not
been finalized on the PLAYBACK tray.
1. Press POWER on the recorder. READING flashes for a while. When no
disc is set, no DISC or DISC no appears.
2. Press the respective OPEN/CLOSE for the PLAYBACK tray or the
RECORD/PLAYBACK tray.
S-VIDEO IN
S-VIDEO OUT
3. Carefully place the disc, label side up, into the recessed CD holder.
4. Press OPEN/CLOSE for the PLAYBACK tray or the RECORD/
PLAYBACK tray to close the disc tray. When a disc is loaded into the
recorder, READING flashes as it determines the contents of the disc.
When the recorder reads the TOC (Table of Contents), the display shows
the total number of tracks, total play time, and the type of disc (the
RECORD/PLAYBACK tray only).
Note: The receiver, shown above, does not have digital out jacks. If your
receiver also does not have digital out jacks, you can use a digital source such as
a CD player or MD player.
• When a blank disc is set on the RECORD/PLAYBACK tray, BLANK
appears.
A QUICK LOOK AT THE RECORDER
• When a disc is set on the RECORD/PLAYBACK tray, the display shows
one of the following:
MUSICSKIP
Buttons
AUTO
MANUAL
DUBBING
MODE
SYNC REC
OPEN/
CLOSE
RECORD
INSTALLING BATTERIES
OPEN/
CLOSE
DIGITAL REC
LEVEL –/+
CD — a commercial pre-recorded CD.
CD-R — finalized CD-R.
POWER
MUSIC SKIP Buttons
1. Press down on the battery compartment cover and slide it
off in the direction of the arrow.
REMOTE
SENSOR
CD-R, NO TOC — a CD-R which has yet to be finalized.
CD-RW, NO TOC — a CD-RW which has yet to be finalized.
CD-RW — a finalized CD-RW.
2. Insert the batteries into the battery compartment as
indicated by the polarity symbols (+ and –) marked inside.
PHONES
FINALIZE
ERASE
INPUT
SELECTOR
3. Replace the cover.
PLAY
PLAY
STOP
PAUSE
PAUSE
BLANK — No disc or unreadable disc.
STOP
5. Press
for the PLAYBACK tray or
²
/ENTER for the RECORD/PLAYBACK tray to start playback.
²
6. Press † to temporarily stop playback. To resume playback, press † or
.
²
“Think RadioShack for all of Your
CD Player/Recorder Accessories”
7. Press to stop playback.
G
If you set CDs on both the PLAYBACK tray and the RECORD/PLAYBACK
tray, the recorder automatically plays the other CD when the current CD
finishes. The CD recorder stops playing at the end of the second CD.
Headphones
Batteries
Blank CD-R Discs
Optical Cable
Audio Cable
CD Lens Cleaner
RadioShack Corporation
Fort Worth, Texas 76102
© 2003 RadioShack Corporation. All Rights Reserved.
03A03
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|