INSTALLATION GUIDE
Item No.:PSWLE59
Thank you for choosing our product
Pyle Audio
1600 63rd st , Brooklyn, NY, 11204
(718)236-8000
TV Size Range: 32"~55"
Maximum Weight Capacity: 30kg/66lbs
Locking by locking bar on the bottom
Warning
This product contains small items that could be a choking hazard if swallowed. Keep
these items away from young children!
1.Make sure these instructions are read and completely understood before attempting
installation. If you are unsure of any part of this installation, contact a professional
installer for assistance.
www.pyleaudio.com
CAUTION
2.The wall or mounting surface must be capable of supporting the combined weight of
the mount and the display; otherwise the structure must be reinforced.
3.Safety gear and proper tools must be used. A minimum of two people are required
for this installation. Failure to use safety gear can result in property damage, serious
injury or death.
This product was designed to be installed on wood stud walls and solid concrete walls.
Before installing make sure the supporting surface will support the combined load of the
equipment and hardware. Never exceed the Maximum Load Capacity. This product is
intended for indoor use only. Use of this product outdoors could lead to product failure or
personal injury.
-8-
Download from Www.Somanuals.com. All Manuals Search And Download.
Part 3-Mounting the flat ppaanneell ssccrreeeenn
Part 1aa-Wood SStud Moouunting
2,3
Hook the top of brackets(2,3) onto the top flange
of wall plate(1). Then swing the screen down.
Use wall plate(1) as a template, make sure it is level, and mark four mounting
holes along the center lines of the wood studs. Drill four 3/16” (5mm)dia.
holes 2” (50mm) deep. Level wall plate(1) and attach to wall with four long
bolts(G) and four washers(I). Tighten screws firmly. Do not overtighten.
NOTE: Always use an assistant or mechanical
lifting equipment to safely lift and position
heavy equipment.
1
Use the Locking bar(4) to prevent the TV from being removed or
accidentally knocked off of the wall plate.When the locking bar half
insertes into the wall plate , you can use the rotating rod(5) to make it
fully inserted.
5
4
Stud finder
Wood stud
I
2”(50mm)
G
Φ3/16”(5mm)
-3-
-6-
Download from Www.Somanuals.com. All Manuals Search And Download.
Part 2aa-Attaacching Brracketts To Scrreen Wiith Flaat Back
Part 1b--Concrette Wall MMoounting
Center brackets vertically on back of screen. Select the small(A or B),
medium(C or D) or large(E) screws. Attach brackets to screen using four
selected screws and four square washers(F) at the top and bottom of each
bracket. Tighten screws firmly. Do not overtighten.
Level wall plate(1) and use wall as a template to mark four holes. Drill four 3/8”
(10mm) dia. holes 2”(50mm) deep. Insert four anchors(H) into holes and
secure wall plate with four long bolts(G) and four washers(I).Tighten screws
firmly. Do not overtighten.
Square washer(F)
2”(50mm)
F
Large hole for
M8 screws
A-E
Φ3/8”(10mm)
Medium hole for
M5 and M6 screws
Small hole for
M4 screws
Concrete Wall
H
I
G
-5-
-4-
Download from Www.Somanuals.com. All Manuals Search And Download.
|