12nc: 8239 210 97091
Printed in China
27DVCR55
There are many ways to connect your newTV/VCR/DVD to your other equipment.This Quick-Use Guide
shows the easiest, most common connections for theTV/VCR/DVD.
CABLE TV SIGNAL
ANTENNA or
CABLE TV SIGNAL
CABLE BOX
IN
OUT
2
4
3
RF COAXIAL
CABLE
ANT.
L
AUDIO OUT
R
COAXIAL
ANT.
ANT.
OR
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you
have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.
1
2
3
If you do not have a Cable Box, simply connect your Antenna or CableTV signal directly to the ANT(enna)
jack on the rear of theTV/VCR/DVD.
If you do have a Cable Box or Satellite Receiver, first connect the CableTV or Satellite signal to the IN jack
on the Cable Box or Satellite Receiver. Then, use an RF coaxial cable (not supplied) to connect the OUT
jack of the Cable Box or Satellite Receiver to the ANT(enna) jack on theTV/VCR/DVD. To view any channel,
set the TV/VCR/DVD to the output channel of the Cable Box or Satellite Receiver (channel 3 or 4). Then, select channels
at the Cable Box or Satellite Receiver.
When all connections are complete, plug the power cord of theTV/VCR/DVD into an active power
outlet.
4
5
Press the STANDBY-ON 2 button on theTV/VCR/DVD or its remote to turn on theTV/VCR/DVD. The
first time you turn on theTV/VCR/DVD, you should complete theTV/VCR/DVD setup. See the other side
of this Quick-Use Guide for details.
Download from Www.Somanuals.com. All Manuals Search And Download.
|