IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
OWNER’S
1. Read all instructions before using this heater.
MANUAL
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
If provided, use handles when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from
the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment, or
repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, first turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where
gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
14. Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated no less than 1875 watts.
15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.
16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn outlet.
Tower Ceramic
With Remote
Model: HC-0119A
17. The output of this heater may vary and its temperature may become intense enough to
burn exposed skin. Use of this heater is not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid burns.
18.“SAVE THESE INSTRUCTIONS”
Download from Www.Somanuals.com. All Manuals Search And Download.
B. If the setting temperature is lower than or equal to the room temperature, the
temperature display will flash and the unit will stop heating. When the room
temperature falls down to less than the setting temperature, the unit will
ADDITIONAL FEATURES
This heater has additional features:
resume heating. The heater will cycle on and off this way to maintain the
setting temperature.
Dual LED display-Allows you to adjust the heater and check the set value at the
same time in a distance (Within16 ft of the heater), you can also check the status of
the heater easier.
Note: Every time you turn on the heater, the heater will heat forcedly for 2 minutes. After that the
heater will work based on the below instruction. And when the room temperature reaches the
setting temperature or the setting temperature is lower or equal to the room temperature, the
heating element will shut off immediately, but the fan motor will continue running for 10—30
seconds before shutting off. This is a safety feature to protect the unit from being too hot.
Convenient Carry Handle-Allows for easy maneuvering from room to room.
TROUBLESHOOTING
Timer setting: This heater has an 8 hours On/Off timer. You can set an “ On” timer
when the heater is standing by (plugged in but not working) or you can set an “ Off”
timer when the heater is working. For example, you can plug in the heater and set the
timer to turn the heater on after 3 hours, you can also set the timer to turn the heater
off after 6 hours and a half when the heater is working.
If your heater fails to operate, please follow these instructions:
Ensure that your circuit breaker or fuse is working properly.
Be sure the heater is plugged in and that the electrical outlet is working properly.
Check for any obstruction. If you find any obstruction, turn the heater “OFF”. Unplug
the heater and wait a few minutes for it to cool down. Carefully remove the
obstruction. Plug the heater in and turn it on again by referring to the OPERATING
INSTRUCTIONS.
Example for “ On” Timer:
1. When the heater is plugged in and not working, press the “ C” Timer and the “ A” Digital
Indicator will display the last set value (0.0 is the default set). Press the “ Up” or “ Down”
key to choose your desired timer setting. The timer will increase or decrease half on hour
every time you press the “ Up” or “ Down” key and goes up and down from 0.0 to 8.0.
2. Press “ Up” key 6 times until 3.0 is displayed, press the “ C” Timer again to confirm the set.
Now your heater is set to be turned on after 3 hours.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEND
YOUR HEATER TO AN AUTHORISED SERVICE CENTER FOR MAINTENCE.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF.
DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR
PERSONAL INJURY.
Example for “ Off” Timer:
1. When the heater is working, press the “ C” Timer.
2. Press “ Up” key 13 times or “ Down” key 3 times until 6.5 is displayed, press the “ C” Timer
again to confirm the set.
Now your heater is set to be turned off after 6 hours and a half.
To disable the timer, adjust the set value of the timer to 0.0.
Note: Once the timer is set, the heater will work this way unless you unplug the heater. You have
to reset the timer every time you plug in your heater.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in
order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH
OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-
season storage.
Remote control (Refer to Fig 2): This heater has a 6 key remote with the
following function (See picture above):
1. ON/OFF: Power switch key, used to turn off the heater when the heater is on.
2. OSC: Oscillation switch, used to enable the oscillation function by pressing once. To
disable the oscillation function, press the “OSC” key once more. This key is only valid
when the heater is on (Hi, Low or Fan).
3. TIMER: Timer setting key, used to enable the timer setting or confirm the setting value.
4. MODE: Mode select key, used to switch the heater circularly in sequence of HI -LO -
FAN when the heater is on.
Turn the heater “ OFF” , unplug it and wait for the heater to cool down.
Use a dry cloth to clean only external surfaces of the heater.
Do not use any cleaning agents or detergents.
Never immerse the heater in water.
Pack the heater in the original carton and store it in a cool and dry place.
5. “ +” and “ -” : Value adjustment key, used to adjust the set value of the temperature or
the timer.
CAUTION: This heater includes an Overheat Protection System that shuts the unit off if it
overheats due to abnormal conditions. If this occurs turn the heater “OFF”, unplug it, and inspect
and remove any objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it
back in, and resume normal operation.
SPECIFICATIONS
Model No.: HC-0119A
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Power: LO = 900 Watts, HI = 1500 Watts.
Tolerances on all specifications: Approximately +5%, -10%.
Download from Www.Somanuals.com. All Manuals Search And Download.
SERVICE & SUPPORT
ONE (1) YEAR LIMITED WARRANTY
In the event of a warranty claim or if service is required for this heater, please contact us at
the following:
Please read all instructions before attempting to use this product.
Please return the Warranty Registration card within fifteen (15) days from the date of
purchasing this product.
Toll Free: 866-876-4332 (M-F 8:30am to 5:30pm CST)
Email us at: [email protected]
PELONIS warrants as limited herein to the original purchaser of retail that each new
Pelonis Tower Ceramic Heater shall be free of defects in material and workmanship for a
period of one (1) year from the date of original purchase. This one (1) year warranty is
limited to the heating elements, motor, and electric control circuit board.
For questions or comments, please write to:
Pelonis USA, Ltd.
2617 North Great Southwest Parkway
Suite 100
Grand Prairie, TX 75050, USA
In the event of malfunctions or failure of your Pelonis Tower Ceramic Heater, simply deliver
or send the heater, postage prepaid along with PROOF OF PURCHASE, within the
warranty period of one (1) year, to PELONIS. PELONIS reserves the right to inspect the
claimed defective part or parts to determine if the defect or malfunction complaint is
covered by this warranty. PELONIS shall, within sixty (60) days after receipt of the product,
at its option, repair and/or replace the defective part or parts free of charge. This warranty
shall only cover defects arising from normal usage. PELONIS assumes no responsibility
whatsoever if the Tower Ceramic Heater should fail during the warranty period by reason
of:
For your records, staple your sales receipt to this manual and record the following:
DATE OF PURCHASE: ______________________________________________
PLACE OF PURCHASE: _____________________________________________
SERIAL NUMBER: __________________________________________________
Misuse, negligence, physical damage or accidents.
Lack of maintenance (see instructions for proper maintenance).
Repair by any unauthorized party during the warranty period.
Damage caused by connection to an improper input voltage (see specification
label on your heater).
(STAPLE SALES RECEIPT HERE)
PELONIS makes no further warranties or representations, express or implied except those
contained herein. No representative or dealer is authorized to assume any other liability
regarding the Tower Ceramic Heater. The duration of the implied warranty granted under
State law, including warranties of merchantability and fitness for particular purpose are
limited in duration should the duration of the express warranty grant it hereunder. Pelonis
USA shall in no event be liable for direct, indirect, special or consequential damages.
NOTE: PROOF OF PURCHASE IS REQUIRED FOR
ALL WARRANTY CLAIMS
Some states do not allow limitations on how long an implied warranty lasts, and/or the
above limitations or exclusion may not apply to you. This warranty gives you specific legal
rights and you may have other rights which vary from state to state.
Download from Www.Somanuals.com. All Manuals Search And Download.
|