C228M (3/99)
MM22
Enclosure Mount
®
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
3500 Pelco Way,
Clovis, CA 93612-5699
USA
1. Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
2. Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utilizing only approved materials.
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
3. Use only installation methods and materials capable of supporting four times the maxi-
mum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
5. To prevent damage from water leakage when installing a mount outdoors on a roof or
wall, apply sealant around the bolt holes between the mount and mounting surface.
The product and/or manual may bear the following marks:
This symbol indicates that danger-
ous voltage constituting a risk of
electric shock is present within
U
®
L
LISTED
C A U T I O N :
this unit.
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
This symbol indicates that there
are important operating and main-
tenance instructions in the litera-
ture accompanying this unit.
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
DESCRIPTION
The MM22 Pedestal/Wall Mount has been engineered for use with light-to-medium weight cam-
eras and various Pelco enclosures having a 2-inch mounting hole pattern.
The MM22 can be installed on a ceiling or any horizontal surface and will support up to 40
pounds (18 kg).
The MM22 features a fully adjustable swivel head allowing 360° horizontal movement.
INSTALLATION
The MM22 mount is supplied with two 1/4-20 x .625 hex head bolts for use in attaching the
enclosure/camera to the mount.
NOTE: Fasteners to secure the
MM22 (4 required) to the mount-
ing surface are not supplied.
(Minimum 1/4-inch diameter rec-
ommended.)
If installing outdoors, stainless steel hardware is recommended.
To install the mount:
1. Drill holes in the mounting surface using the mount as a template and attach mount se-
curely with the required fasteners.
If you install the mount outdoors, rain water could leak through the holes for the mounting
bolts and damage the wall. This could be a problem only if the mounting bolts go com-
pletely through the roof or wall.
To prevent water damage, seal the bolt holes with an appropriate sealant. Apply the seal-
ant around the bolt holes between the mount and the mounting surface.
CAUTION: Make cer-
tain the mounting sur-
face is able to support
2. Attach the enclosure or camera securely with the two 1/4-20 hex head screws provided.
the full load of the mount, enclo-
sure, and camera.
3. Loosen the hex head bolts on the swivel head and adjust for pan rotation (360°) and tilt
angle (75° up or down). Tighten bolts and lock into place.
Download from Www.Somanuals.com. All Manuals Search And Download.
|