Nokia Bluetooth Headset BH-208
6
7
8
5
3
11
10
12
9
Issue 1
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Introduction
The Nokia Bluetooth Headset BH-
and the headset do not need to be
208 allows you to make and receive in line of sight, but they should be
calls while on the move. You can
use the headset with compatible
phones that support Bluetooth
wireless technology.
within 10 meters (30 feet) of each
other. Connections may be subject
to interference from obstructions,
such as walls, or other electronic
devices.
Read this user guide carefully
before using the headset. Also read The headset complies with the
the user guide for your phone,
which provides important safety
and maintenance information.
Keep the headset out of reach of
small children.
Bluetooth Specification 2.0 + EDR
that supports the Headset Profile
1.1 and Hands-Free Profile 1.5.
Check with the manufacturers of
other devices to determine their
compatibility with this device.
Bluetooth wireless
technology
Bluetooth wireless technology
allows you to connect compatible
devices without cables. The phone
There may be restrictions on using
Bluetooth technology in some
locations. Check with your local
authorities or service provider.
Get started
The headset contains the following indicator light (1), answer/end key
parts shown on the title page:
(2), charger connector (3), earloop
ownload from Www.Somanuals.com. All Manuals Search And Downloa
3
When you disconnect the power cord
of any enhancement, grasp and pull
the plug, not the cord.
(4), microphone (5), earpiece (6),
power key (7), and volume key (8).
Before using the headset, you must
charge the battery and pair the
headset with a compatible phone.
Parts of the headset are magnetic.
Metallic materials may be attracted to
the headset. Do not place credit cards
or other magnetic storage media near
the headset, because information
stored on them may be erased.
Charge the battery
The headset has an internal,
nonremovable, rechargeable
battery. Do not attempt to remove
the battery from the device, as you
may damage the device.
1. Connect the charger to a wall
outlet.
Chargers
2. Connect the charger cable to
the charger connector. The red
indicator light is on while
charging. It may take a while
before charging starts. If
Check the model number of any
charger before using it with this
headset. The headset is intended for
use with the
AC-3, AC-4, and DC-4 chargers.
charging does not start,
Warning: Use only
chargers approved by
Nokia for use with this
disconnect the charger, plug it
in again, and retry. Charging the
battery fully may take up to 1
hour and 30 minutes.
particular enhancement. The use of
any other types may invalidate any
approval or warranty and may be
dangerous.
3. When the battery is fully
charged, the indicator light
turns to green. Disconnect the
ownload from Www.Somanuals.com. All Manuals Search And Downloa
4
charger from the headset and
the wall outlet.
Pair the headset
1. Ensure that your phone is
switched on and the headset is
switched off.
The fully charged battery has power
for up to 6 hours and 30 minutes of
talk-time or up to 150 hours of
standby time. However, the talk and
standby times may vary when used
with different mobile phones or
other compatible Bluetooth
2. Press and hold the power key
until the green indicator light
starts to flash quickly.
3. Activate the Bluetooth feature
on the phone, and set the phone
to search for Bluetooth devices.
devices, usage settings, usage
styles, and environments.
4. Select the headset from the list
of found devices.
When battery power falls low, the
headset beeps and the red indicator
light starts to flash.
5. Enter the passcode 0000 to pair
and connect the headset to your
phone. In some phones you may
need to make the connection
separately after pairing. You
only need to pair the headset
with your phone once.
Switch the headset on or off
To switch on, press and hold the
power key until the headset beeps
and the green indicator light is
displayed.
To switch off, press and hold the
If the pairing is successful, the
power key until the headset beeps headset beeps and appears in the
and the red indicator light is
displayed briefly.
phone menu where you can view
the currently paired Bluetooth
devices. The headset is now ready
for use.
ownload from Www.Somanuals.com. All Manuals Search And Downloa
5
Basic use
progress, and proceed as described
in the user guide of your phone.
Place the headset on the ear
Slide the earloop behind your ear
(9), and point the headset toward
your mouth. Carefully bend the
earloop around your ear for the
best fit (10).
To answer or end a call, press the
answer/end key. To reject an
incoming call, press the answer/end
key twice.
To adjust the headset volume, press
the volume key up or down.
To use the headset on the left ear,
gently detach, rotate, and attach
the earloop as shown in Figures 11
and 12.
To mute or unmute the
microphone, press the middle of the
volume key.
Call handling
To make a call, use your phone in
the normal way when the headset
is connected to your phone.
To switch the call between the
headset and a compatible phone,
press and hold the answer/end key.
Clear settings or reset
If your phone supports last number
redialing with the headset, press
the answer/end key twice while no
call is in progress.
To clear all the pairing settings
from the headset, switch off the
headset, and press and hold the
power key and the answer/end key
until the red and green indicator
lights start to alternate.
If your phone supports voice dialing
with the headset, press and hold
the answer/end key when no call in
ownload from Www.Somanuals.com. All Manuals Search And Downloa
6
To reset the headset if it stops
press the power key and the
functioning, although it is charged, answer/end key at the same time.
plug the headset into a charger, and
Battery information
Your device is powered by a
Leaving the device in hot or cold
rechargeable battery. The battery can places, such as in a closed car in
be charged and discharged hundreds
of times, but it will eventually wear
out. Recharge your battery only with
Nokia approved chargers designated
for this device.
summer or winter conditions, will
reduce the capacity and lifetime of the
battery. Always try to keep the battery
between 15°C and 25°C (59°F and
77°F). A device with a hot or cold
battery may not work temporarily,
even when the battery is fully charged.
Battery performance is particularly
limited in temperatures well below
freezing.
Unplug the charger from the electrical
plug and the device when not in use.
Do not leave a fully charged battery
connected to a charger, since
overcharging may shorten its lifetime.
If left unused, a fully charged battery Do not dispose of batteries in a fire as
will lose its charge over time.
they may explode. Batteries may also
explode if damaged.
Never use any charger that is
damaged.
Care and maintenance
Your device is a product of superior
be treated with care. The following
design and craftsmanship and should suggestions will help you protect your
ownload from Www.Somanuals.com. All Manuals Search And Downloa
7
warranty coverage.
•
•
Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the device.
•
Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If
your device does get wet, allow it
to dry completely.
Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
All of the above suggestions apply
equally to your device, battery,
•
•
Do not use or store the device in
dusty, dirty areas. Its moving parts charger, or any enhancement. If any
and electronic components can be device is not working properly, take it
damaged.
to the nearest authorized service
facility for service.
Do not store the device in hot
areas. High temperatures can
shorten the life of electronic
devices, damage batteries, and
warp or melt certain plastics.
•
Do not store the device in cold
areas. When the device returns to
its normal temperature, moisture
can form inside the device and
damage electronic circuit boards.
•
•
Do not attempt to open the device.
Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
ownload from Www.Somanuals.com. All Manuals Search And Downloa
8
|