Nikon Telescope 25 8x25 EER User Manual

(516B)/2E  
In the event that you should require service for your Nikon  
RIFLESCOPE, in case of USA market, please send it directly to:Nikon  
Scope Service  
841 Apollo Street, Suite 100  
EI Segundo, CA. 90245-4721  
1-800-Nikon SV.  
In other market, please bring it to dealer from which you purchased it.  
ENCORE Handgun Scope  
Pour les autres marchés, veuillez apporter la lunette de visée au  
magasin où vous l'avez achetée.  
2x20 EER  
2.5-8x28 EER  
Manufacturer:  
3-25, Futaba 1-chome, Shinagawa-ku, Tokyo 142-0043, Japan  
Tel:+81-3-3788-7697 Fax:+81-3-3788-7698  
Printed in Taiwan (516B)/2E  
Instruction manual/Mode d'emploi  
E F  
Congratulations on your choice of a Nikon ENCORE Handgun Scope. Your new scope is the finest  
example of Nikon's rugged and durable construction and precision bright optics; important qualities  
for a serious shooter's handgun scope.  
3. Instructions  
(1) Focusing  
Whether you use your scope for hunting or for target shooting, the procedure for mounting is  
identical. You should acquire a set of high quality steel mounting rings which have a standard  
diameter of 25.4 mm (1 inch). Follow the ring manufacturer's instructions for mounting procedures.  
After mounting the scope on your handgun scope, follow the procedures for reticle alignment.  
When setting the reticle for hunting, you should determine your standard range and then adjust the  
reticle based upon that target distance. For targets which vary from that standard distance you may  
simply adjust the position of the reticle in relation to your target, or you may wish to use the  
procedure for trajectory compensation. It's up to your personal preference.  
1
Look through the eyepiece with your eye positioned about 10cm (4 in) away from the  
eyepiece lens (Fig. 3-1), and you will see the BDC Encore Reticle (Fig. 3-2).  
Be sure your eye is positioned within proper alingment and proper eye relief otherwise the  
view will "black out".  
2
Point the objective end of the scope at the sky (Do not point at the sun) or at a plain  
unpatterned wall.  
Turn the eyepiece adjustment counter-clockwise and then turn it clockwise until the reticle  
appears sharp.  
We hope that you will enjoy your new Nikon ENCORE Handgun Scope for many years to come.  
Enjoy using it, and above all, always follow safe shooting procedures!  
(2) Magnification  
The Nikon ENCORE Handgun scope 2x20 EER has a 2x magnification.  
The Nikon ENCORE Handgun scope 2.5-8x28 EES has a variable magnification from 2.5 to  
8X.  
Caution  
(1) Do not look at the sun through the handgun scope. It will permanently damage your eye. This  
precaution applies to all optical devices such as cameras and binoculars.  
(2) The handgun scope is effectively sealed against moisture and dust. You may use your scope  
safely either in the rain or in dusty climates. To preserve the appearance of the scope, we  
suggest that it be dried and cleaned prior to storage. Use a soft cloth for cleaning metal  
surfaces and use photographic lens tissue to clean the scope's lenses.  
To change powers, just rotate the power selector ring until the desired magnification appears  
adjacent to the power index dot (Fig. 1-1).  
(3) Adjustment of the handgun scope  
Sighting through the handgun scope, align the rifle with your aiming point on the target and  
shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and windage  
after removing the Adjustment cap, as follows:  
For the Nikon ENCORE Handgun Scope adjustment is made by turning the grip by hand. If  
The product(s) described herein may be subject to export control regulations in the relevant  
country(ies). It (they) should not be exported without authorization of the exporting govermental  
authority if the regulations apply.  
the bullet hits under the aiming point, turn the grip in the direction of the arrow marked "U"  
(Fig. 3-3). If the bullet hits to the left of the aiming point, turn the grip in the direction of the  
arrow marked "R" (Fig. 3-3).  
(4) Zero setting of grip (Fig. 3-4)  
After the reticle has been adjusted to the point of impacts, with the grip held with your fingers to  
avoid shifting of the aligned grip, turn the grip screw in top of the grip counterclockwise with  
1. Nomenclature  
coin. Then lift the grip up and align the " " with the index mark. It may happen that the "  
"
could not align with the index mark exactly because of the coupling pitch of the grip with the  
shaft. And by securing the grip with your fingers to avoid shifting of the grip, turn the grip screw  
clockwise with the coin until the grip in firmly secured.  
Note:  
The windage and elevation scales of the ENCORE Handgun scope 2x20 EER is calibrated in  
divisions of 1/2 minite of angle with a click at intervals of 1/2 minute of angle.  
The windage and elevation scales of the ENCORE Handgun scope 2.5-8x28 EER is calibrated  
in divisions of 1/4 minute of angle with a click at intervals of 1/4 minute of angle .  
When adjusting the reticle to the point of aim, remember that one minute of angle equals  
Fig. 1-1  
2.5-8x28 EER  
approximately one inch (2.54 cm) at 100 yards (91.44 m). Therefore, if the impact point is  
two inches (5.08 cm) low and one inch (2.54 cm) right at 100 yards (91.44 m), you should  
adjust two minutes of angle up one minute of angle left.  
Magnified Figure of 2.5-8x28 EER  
Hand turn Grip  
Maintenance  
(1) Lens cleaning  
To remove dirt or fingerprint, soak gauze or lens cleaning paper (silicon-free paper sold at  
camera shop) with a small quantity of absolute alcohol (available from drugstore) and lightly  
wipe off. Wiping with handkerchief of leather is not recommended as it is likely to damage the  
lens surface.  
Dust may scratch the lens surface or corrode the lens.  
Brush dust off using a soft oil-free brush.  
Objective Lens  
Eyepiece Lens  
Elevation Adjustment  
Windage Adjustment  
Eyepiece Adjustment  
Power Index Dot  
Power Scale  
Power Selector Ring  
Adjustment Cap  
(2) Scope Exterior  
Use a soft dry cloth to wipe off any dirt or finger-prints that might accumulate.  
It is not necessary to oil the scope's surface.  
Fig. 1-2  
(3) Windage/Elevation Adjustments  
These adjustments are permanently lubricated. Do not attempt to lubricate them. Cover with  
caps supplied, except when adjusting, to keep out dust and dirt.  
(4) Eyepiece Ajustment  
This adjustment is permanently lubricated. Do not attempt to lubricate.  
(5) Power Selector Ring  
No lubrication is required on the power selector ring.  
Do not loosen or remove screws in power selector ring.  
Waterproof models:  
The ENCORE Handgun scope are waterproof, and will suffer no damage to the optical system if  
submerged or dropped in water to a maximum depth of 2 meters for up to 10 minutes.  
The ENCORE Handgun scope offer the following advantages:  
Fig. 1-3  
2x20 EER  
Can be used in conditions of high humidity, dust and rain without risk of damage.  
Nitrogen-filled design makes them resistant to condensation and mold.  
Magnified Figure of 2x20 EER  
Hand turn Grip  
Observe the following when using the ENCORE Handgun scope:  
As the unit does not have a perfectly sealed structure, it should not be operated nor held in  
running water.  
Eyepiece Adjustment Eye Relief  
Any moisture should be wiped off before adjusting movable parts (Elevation/Windage knob,  
eyepiece, etc.) of the ENCORE Handgun scope to prevent damage and for safety reasons.  
To keep your ENCORE Handgun scope in excellent condition, Nikon Vision recommends regular  
servicing by authorized dealer.  
Fig. 3-1  
Fig. 1-4  
2. Specifications  
ENCORE  
2x20 EER  
ENCORE  
2.5-8x28 EER  
Model  
(mm)  
(in)  
BDC Encore Reticle  
Actual Magnification  
2x  
2.5-8x  
Objective Diameter  
Exit Pupil  
(mm)  
(in)  
20  
28  
0.79  
1.10  
(mm)  
(in)  
10  
0.39  
3.5  
0.14  
Eye Relief  
(mm)  
 *� (in)  
246.4-569.0  
9.7-22.4  
304.8-762(2.5x)-228.6-330.2(8x)  
12-30(2.5x)-9-13(8x)  
Field of View at 100yds.  
Tube Diameter  
Objective Tube Diameter  
Length  
(m)  
6.2  
3.9-1.2  
 *� (ft)  
20.5  
13.1-4.1  
(mm)  
(in)  
25.4  
1
25.4  
1
(mm)  
(in)  
25.4  
1.00  
35.5  
1.40  
Fig. 3-2  
(mm)  
(in)  
209  
8.23  
249  
9.80  
Fig. 3-3  
Weight  
(g)  
(oz)  
210  
7.4  
325  
14.5  
Adjustment Graduation  
1click=14mm/100m  
1click=1/2"/100yards  
1click=7mm/100m  
1click=1/4"/100yards  
(moa)  
Maximum Internal  
Adjustment  
(Elevation & Windage)  
(moa)  
**�  
120  
40  
Parallax Setting�  
(at factory)  
(m)  
91.44  
100  
91.44  
100  
(yards)  
***�  
Outside Diameter of  
Eyepiece  
(mm)  
(in)  
41  
1.61  
41  
1.61  
Structure  
Waterproof (maximum depth of 2 meter for up to 10 minites)  
and Nitrogen Gas  
(at minimum magnification)-(at maximum magnification)  
**moa=minute of angle (in front of 100 yards one moa is nearly equal to one inch.)  
***Nikon ENCORE Handgun Scope is factory set to be parallax free at 100 yards (91.44 m).  
Fig. 3-4  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miele Clothes Dryer T1570C User Manual
Miele Washer w 5877 User Manual
Mountain Buggy Stroller Carrycot User Manual
MTD Snow Blower Style L User Manual
Multi Tech Systems Network Card MT3334HD8 User Manual
Multi Tech Systems Webcam MTCBA G U F4 User Manual
Muratec Fax Machine MFX 2530 User Manual
Nintendo Video Game Console NDSUSGBMKB User Manual
Omnimount TV Mount 100 CL User Manual
Omron Healthcare Heart Rate Monitor HR 100 User Manual