Flash Compensation
A
En
Addenda to the D4S User’s Manual
The flash compensation value selected with the button and sub-command dial
is added to the flash compensation values selected for the master flash (Optional
flash), group A, and group B in the Commander mode menu. A
M
Your D4S is equipped with the latest firmware (version C 1.20), which offers
the following features not described in the User’s Manual.
icon is dis-
Y
played in the control panel and viewfinder when a flash compensation value other
“Time” ( 132–133)
Shooting no longer ends automatically after 30 minutes when “Time” is se-
lected for shutter speed. To close the shutter and end shooting, press the
shutter-release button all the way down.
0
than 0 is selected for Optional flash > TTL. The
icon flashes when the master
Y
flash is in mode M.
Commander Mode
D
Position the sensor windows on the remote flash units to pick up the light from the
master flash (particular care is required if the camera is not mounted on a tripod). Be
sure that direct light or strong reflections from the remote flash units do not enter the
camera lens (in TTL mode) or the photocells on the remote flash units (AA mode), as
this may interfere with exposure even when – – is selected for Optional flash. To
prevent timing flashes emitted by the master flash from appearing in photographs
taken at short range, choose low ISO sensitivities or small apertures (high f-numbers).
After positioning the remote flash units, take a test shot and view the results in the
camera monitor.
Custom Setting d3: Max. Continuous Release ( 327)
The maximum number of shots is ignored when shutter speeds of 4 s or
0
f
h
slower are selected in mode or
.
Custom Setting e3: Optional Flash ( 332)
0
The D4S now supports optional SB-500 flash units. Custom Setting e3 (Op-
tional flash) offers a Commander mode option when an SB-500 is attached.
❚❚ Commander Mode
Although there is no limit on the number of remote flash units that may be used, the
practical maximum is three. With more than this number, the light emitted by the
remote flash units will interfere with performance.
Use a camera-mounted SB-500 as a master flash controlling one or more
remote optional flash units in up to two groups (A and B) via Advanced Wire-
less Lighting.
Selecting Commander mode displays the menu
shown at right. Press
or
or
to highlight the fol-
to change. Compose
4 2
lowing options and
1 3
the shot and arrange the flash units as shown in the
SB-500 manual.
Option
Description
Optional Choose a flash mode for the SB-500 mounted on the camera accessory
flash shoe (the master flash).
i-TTL mode. Choose flash compensation from values between +3.0 and
–3.0 EV in increments of ⁄ EV.
TTL
M
Choose the flash level.
The master flash does not fire, although remote flash units do. The master
flash must be on so that it can emit monitor pre-flashes.
– –
Group A Choose a flash mode for all flash units in group A.
i-TTL mode. Choose flash compensation from values between +3.0 and
–3.0 EV in increments of ⁄ EV.
TTL
Auto aperture (available only with compatible flash units). Choose flash
AA compensation from values between +3.0 and –3.0 EV in increments of
⁄ EV.
M
Choose the flash level.
– – The flash units in this group do not fire.
Choose a flash mode for all flash units in group B. The options available are
Group B
the same as those listed for Group A, above.
Choose from channels 1–4. All flash units in both groups must be set to
the same channel.
Channel
Download from Www.Somanuals.com. All Manuals Search And Download.
|