MicroBoards Technology DVD Recorder 820 00151 01 User Manual

Orbit II Stand-Alone DVD and CD Copier  
Quick Reference Guide  
Installation  
Instructions  
Basic Duplication  
This is a reference for basic operation and duplication only. Please read the  
manual for more detailed instructions on the advanced features of the Orbit II.  
1. Prepare a workspace  
for the Orbit II.  
The  
dimensions required for the  
Orbit II are shown in Fig. A.  
Blank Media Note: Authoring DVD media is not supported  
1. Load discs into the Input Hopper. The  
first 5-6 should lay flat, the rest should  
lean against the short input hopper rod.  
See Fig. C.  
2. Remove the Power Cord, Output  
Bin, 3 Input Rods, and Starter Kit  
from the box. The Starter Kit  
includes the Documentation CD,  
Warranty Card, and Quick  
Reference Guides. Position the  
Orbit II in the prepared space.  
2. Press “Yes” when the display reads  
“Copy?”  
3. Place the Master Disc in the tray when  
the reader drive opens. See Fig. D  
below.  
Fig. A - Workspace Dimensions  
3. Make sure the switch on the  
back of the Orbit II is in the OFF position.  
4. Press the “Yes” key again to start  
4. Plug the power cord into the back of the Orbit II, then into the  
nearest power outlet.  
duplication.  
Fig. C - Loading Procedure  
5. When the input hopper is empty, either  
add more discs and press “Yes” to  
continue, or press “No” to end the  
duplication.  
NOTE: It is recommended that you do not use an outlet that  
is already powering other equipment.  
5. Install the Output Bin on the left  
side. Extend the bin out to the  
2 Narrow  
Input Rods  
Wide  
Input Rod  
6. Once the duplication has been  
completed, the reader drive will eject.  
Remove the master.  
left until it snaps into position.  
6. Install the Input Rods as shown  
in Fig. B.  
7. Remove the copies from the Accept bin  
on the left. Rejected discs, if any, will  
be to the right of the Orbit II.  
7. Turn on the Orbit II.  
Fig. D - Reader Drive Ejected  
Please save all packing  
materials from your Orbit II!  
Please refer to the Operator’s Manual for information on the advanced  
duplication features of the Orbit II.  
Fig. B - Input Rod Positions  
820-00151-01 Rev M  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Krell Industries Stereo Amplifier KAV2250 User Manual
Learning Resources Marine GPS System LER 2959 User Manual
LG Electronics Air Conditioner 230 208V User Manual
LG Electronics Washer WM2077CW User Manual
Linear Home Security System AE 2000 User Manual
Lowrance electronic Thermostat EP 80R TH User Manual
Mackie Speaker SA1530Z User Manual
McIntosh Speaker XRT28 User Manual
Melissa Food Warmer 650 007 User Manual
Mercedes Benz Automobile 2001 CL 500 User Manual