INSTALLATION INSTRUCTIONS FOR PART 95-9308B
INSTALLATION INSTRUCTIONS FOR PART 95-9308B
APPLICATIONS
BMW X5
2000 - 2006
(non-navigation models)
95-9308B
KIT FEATURES
• DDIN Head Unit Provision
• ISO Stacked Head Unit Provision
• Painted Scratch Resistant Matte Black
KIT COMPONENTS
• DDIN Radio Trim Plate • DDIN Brackets • (4) Plastic Snaps • (8) Flush ISO Screws
TOOLS REQUIRED
• Phillips Screwdriver • Torx Screwdriver • Panel Removal Tool
• Small Flat Blade Screwdriver • Cutting Tool or File
METRA. THE WORLD’S BEST KITS.™
METRA. THE WORLD’S BEST KITS.™
1-800-221-0932
metraonline.com
1-800-221-0932
metraonline.com
Download from Www.Somanuals.com. All Manuals Search And Download.
© COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
© COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
95-9308B
95-9308B DASH DISASSEMBLY
NOTES
BMW X5 2000-2006
Disconnect the negative
battery terminal to prevent an
accidental short circuit.
1
A
2
3
Remove the volume knob.
(Fig. A)
Using a T-10 torx-head
screwdriver, turn the release
lever under the shaft 90º.
(Fig. A)
4
Leaving the screwdriver
B
in position, pull out on the
bottom of the factory head unit
and remove the unit. (Fig. A)
5
6
Disconnect the wiring.
Using a T-10 torx-head
screwdriver, loosen (2) T-10
torx-head screws located
beside the head unit guides
and remove the top of the
factory head unit. (Fig. B)
Continued on Pg. 2 .............
7
Disconnect the wiring.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
95-9308B DASH DISASSEMBLY
95-9308B KIT ASSEMBLY
BMW X5 2000-2006
BMW X5 2000-2006
1
Mount the DDIN radio to the
.............Coninued from Pg. 1
C
A
supplied DDIN brackets us-
ing the ISO screws supplied
with the aftermarket radio
(screws must be flush).
(Fig. A)
8
9
With the factory radio door
open, press in on the tabs at
either side and remove the
door. (Fig. C)
2
Locate the factory wiring har-
ness in the dash. Metra rec-
ommends using the proper
mating adapters from Metra
Cut and remove shown sec-
tion from the sub dash.
(Fig. D)
and AXXESS to integrate
your new radio. Re-connect
the negative battery terminal
and test the unit for proper
operation.
D
B
3
Snap the radio bracket as-
sembly into the dash opening
(tight fit). (Fig. B)
4
Snap the DDIN trim plate
over the radio (be sure to
align the snaps with the
holes in the brackets or it
won’t seat properly). (Fig. B)
Continue to Kit Assembly
2
3
Download from Www.Somanuals.com. All Manuals Search And Download.
|