To Use on Ice
Congratulations on purchasing the most advanced hand held digital sonar ever made. The MarCum LX-i
can be used to shoot through ice, single layer aluminum boat hulls, fiberglass hulls, or can be used from
inflatable watercraft.
Clear snow from the ice so you have a clean surface. Place a small amount of water on the ice
and couple the transducer to the water / ice by applying gentle downward pressure while
pushing the ON button. Three dashes will appear in the LCD display. The unit is now in Active
Bottom Search Mode. When bottom is found, it will be displayed on the digital read out. Once
the bottom is found, the unit will automatically enter Fish Mode. In Fish Mode, the unit will
actively search for approximately one second. If fish are found, the unit’s alarm will activate
and the digital display will flash the depth of the target seven times. The unit will then revert
back to Bottom Mode. The unit will rotate automatically between Bottom Mode and Fish Mode
until the unit is either turned off or the unit can’t find bottom at which time it will shut off
automatically within fifteen seconds. To turn the fish alarm off, depress the ON/OFF button.
Ice with air pockets (crusted snow and water that freezes) can make it difficult to obtain depth
readings. If this situation exists, try other nearby areas until better ice is found. If poor ice
continues, a hole may have to be drilled to check depths.
To Get Started
Remove the battery door located on the lower backside of the unit. Insert a coin into the coin slot and turn
counter clockwise. Place the coin under one of the slotted corners and apply gentle upward pressure until
battery door opens. Place lithium CR-P2 battery into the molded battery compartment. Replace battery
door by applying gentle downward pressure with your finger while turning the coin slot clockwise until you
feel a gentle click. You are now ready to use the LX-i to obtain depth readings. The battery will last
roughly twenty hours of continuous run time or multiple years worth of depth readings.
To Use in Boat
To obtain a depth reading through a boat hull, place water in the bottom of the boat. Make sure that the
transducer face has enough water to eliminate any air between the transducer face and the bottom of the
boat. Another method is to coat the bottom of the LX-i (transducer) with petroleum jelly and couple to the
bottom of the boat. To obtain a reading over the side of a boat, hold the transducer in the water 1/2 to 1
inch and push ON. Be sure to hold the unit exactly vertical or the reading won’t be accurate.
One Year Warranty
Nature Vision, Inc. warrants this product to be free from defects in materials and workmanship
for one year from the date of purchase. This warranty applies to customers who properly fill
out and return the warranty card included with this manual. Failure to complete and return the
warranty card voids the warranty. Nature Vision, Inc. will, at its sole discretion and without
charging the customer, repair or replace any components that fail in normal use. Failures due
to abuse, misuse, or unauthorized alteration, modification or repair are not covered. The
warranty is valid only for the original owner who purchases the unit from an authorized dealer.
Products purchased from on-line auction sites are not considered under warranty.
How to Obtain Service
We want our products to provide you with a pleasant on-the-water experience. That means
maximum customer satisfaction. If you have a problem with your unit please contact Nature
Vision's toll free number at (866) 777-0733 for a Return Authorization Number (RA#) or e-mail
us at [email protected]. No service returns will be accepted without this pre-return
authorization number, which must be clearly marked on the outside of the package. Nature
Vision, Inc. retains the exclusive right to repair or replace the unit at its discretion.
The customer is responsible for shipping costs associated with returning the unit to Nature
Vision, Inc. Nature Vision, Inc. will pay for shipping the repaired unit back to the customer
while it is still under warranty. All out of warranty services will be charged a fee for service and
shipping which must be paid in advance. After obtaining a Return Authorization number, the
unit should be securely packed and shipped “pre-paid freight” and insured to Nature Vision,
Inc. It is the consumers' full responsibility to track their products sent out in the mail or other
forms of delivery service. Nature Vision Inc. will not be liable for lost packages sent out in the
mail. Unless specified otherwise, do not include batteries or other accessories when returning
the product for repair. Nature Vision, Inc will not be responsible for lost or damaged
accessories. Please allow a minimum of 10 business days to complete your repair.
LX-i
DIGITAL SONAR
Nature Vision, Inc.
1480 Northern Pacific Road
Brainerd, MN 56401
Canadian customers please return to:
FTN
C/O Nature Vision Inc.
RA#____________
7075 Ordan Drive
Note: The RA number must be clearly
marked on the outside of the package
Mississauga, ON L5T 1K6
RA#____________
Note: The RA number must be clearly
marked on the outside of the package
MA-037-MK Rev A, Effective: 9/5/08
Download from Www.Somanuals.com. All Manuals Search And Download.
|