M6A-UM 3/8/05 3:45 PM Page 1
User’s Manual
Model: M6a
For Technical Assistance, please call (800) 638-3600,
Download from Www.Somanuals.com. All Manuals Search And Download.
M6A-UM 3/8/05 3:45 PM Page 3
Lock and Unlock the Vehicle
Remote Lock:
1. Press the
button on the transmitter.
2. The horn will chirp once and the parking lights will flash once indicating that the doors are
now locked.
Remote Unlock:
1. Press the
button on the transmitter.
2. The horn will chirp two times and the parking lights will flash two times, indicating that the
doors are now unlocked.
Silent Lock/ Unlock:
Press the
and
buttons on the transmitter at the same time to lock or unlock the doors
without the horn chirping. This is a user selection feature.
Pathway Illumination: (Optional Feature)
This feature turns “On” the parking lights for 30 seconds upon disarming of the security system.
Arming the security system will leave the parking lights on for 10 seconds.
Two Step Door Unlocking: (Optional Feature)
This feature will independently unlock the drivers door only when disarming the security system.
Pushing the “Unlock” button a second time within 3 seconds will unlock the entire vehicle.
Panic Function (Horn Connection must be Installed)
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of emergency.
1. Press and hold the
button for 3 seconds. The horn will immediately sound.
2. To stop the panic mode, press and hold the Lock or Unlock button on the transmitter again for
3 seconds. Also, if any transmitter button other than the Lock or Unlock button is pressed and
released, the panic mode will be turned off immediately.
Dome Light Convenience Delay & Supervision (Option)
If this option has been installed, it will operate in the following manner:
1. Upon disarming, the interior lights will remain on for 30 seconds.
2. Turning on the ignition switch will turn off the dome light.
Ignition Control Door Locks (Option)
If the vehicles door locks have been connected to the system, the system will automatically lock the
vehicle’s doors when the ignition is turned “On” and/or unlock the vehicle’s door when the ignition
is turned “Off” (Programming is required for this feature to be active).
Trunk Release
Press and hold the
button on the transmitter for two seconds to activate the trunk release or
other electronic devices.
Car Locator
Press the
button twice within 3 seconds to activate car locator function. The horn will chirp 6
times and the parking lights will flash 12 times to help you locate your car.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
M6A-UM 3/8/05 3:45 PM Page 4
Remote Start Operation
Warnings
As with any product that performs automatic functions, there are certain safety precautions that you
must practice and be aware of:
1. Keep the transmitter out of reach of children.
2. DO NOT leave anyone in the vehicle while running on remote control.
3. Alert any service personal that the vehicle can be started automatically.
4. DO NOT start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is corrected.
7. The use and operations of this device is the sole responsibility of the owner/operator of the
vehicle.
8. Some areas may have local ordinances that prohibit leaving a vehicle running on public
streets. Check your local laws and ordinances.
How to Remote Start Your Vehicle
1. Press the
button on the transmitter two times within 3 seconds.
2. The parking lights will activate to indicate the remote start signal has been received.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after 1 second the parking lights will turn on again and climate
controls will activate and adjust the vehicle’s interior temperature to your preset setting.
5. The vehicle will run for a 5 to 30 minute cycle and automatically shut down
Note: The remote start unit will not start the vehicle if any one of the following conditions exists:
A. The hood is open
B. The brake pedal is pressed
C. Move the optional remote start enable switch to “Off” position (if installed)
D. The gear selector is in any gear other than “Park” or “Neutral”.
How to Operate the Vehicle While Running on the Remote Start Function
1. Insert the ignition key and turn it to the “On” Position. Be sure you DO NOT turn the Ignition
key all the way to the “Start” position. This will cause severe damage to the starter
components on your vehicle.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the “On” position, the engine will
automatically shut down.
Temporary Stop Feature
This feature allows the vehicle to remain running after the key has been removed from the ignition.
This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of
time but, would like to leave the motor running and climate control on.
1. Before turning off the engine, press the
button twice on the transmitter.
2. Turn the ignition key to the “Off” position (The engine will stay running)
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
M6A-UM 3/8/05 3:45 PM Page 5
Timer Start
The remote starter can be programmed to start the engine every 2 or 3 hours. The engine will run
for the programmed run time and then shut down. This feature is designed for an extremely cold
climate, preventing the engine from being hard to start or freezing over. A MAXIMUM OF SIX
CYCLES CAN OCCUR.
Important: Timer start should be used in open areas, never start and run the vehicle in enclosed
spaces as a garage or carport.
To Activate the Start Timer:
1. Press the button twice within 3 seconds to remote start the vehicle.
2. As soon as the vehicle is running and the parking lights have turned on or are flashing.
immediately depress the
button.
3. Press the button within 2 seconds. The parking lights will flash 3 times. The siren or horn
will chirps 3 times. The vehicle is now programmed to start every 3 hours.
Note: Unless the installer of this remote start system has reprogrammed the start timer for a 2
hour duration, the default programmed start time is set to 3 hours.
Exit the Timer Start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition On. The parking lights will flash 4 times. The horn will chirp 4 times.
OR
1. Press the button twice within 3 seconds to remote start the vehicle.
2. As soon as the vehicle is running and the parking lights have turned on or are flashing,
immediately depress the
3. Then press and hold the
button.
button for 2 seconds. The parking lights will flash 4 times. The
siren or horn chirps 4 times. The vehicle is no longer programmed to start automatically.
(Also See Installation Manual)
Turbo Timer Mode
Turbo Timer Mode keeps the engine running after arriving at your destination for a programmable
time period of 1, 3 or 5 minutes. This allows the system time to conveniently cool down the turbo
after you have left the vehicle.
To Activate:
1. While the engine is running, place the transmission in "Park" then set the emergency brake.
2. Before turning off the engine, press and release
and
buttons at the same time. The
parking light will turn on to indicate the remote start has entered turbo charge mode.
3. Remove the “Ignition Key” from the key cylinder. The engine will keep running.
4. Exit and secure the vehicle. The Engine will continue to run until the pre-programmed time has
elapsed.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
M6A-UM 3/8/05 3:45 PM Page 6
Disabling the Remote Start System
This feature allows your security system’s remote start unit to be temporarily disabled to prevent
the vehicle from being remote started accidentally. This feature is useful if the vehicle is being
serviced or stolen in an enclosed area. To disable the remote start, move the optional remote start
enable toggle switch to the “Off” position.
Shut Down Input for Remote Starter
If any of the following conditions exist while the system is operating, the engine will not start or will
shut down:
1. The hood is open.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to the “Off” position (if installed).
4. Engine is over-revved (tachometer checking type).
5. The pre-programmed run time 5-10-20-30 minutes has elapsed.
6. Transmitter
button is pressed.
7. The vehicle refused to start running after 3 unsuccessful attempts.
Parking Lights
Chirp Indicators
Parking Lights
1 Flash
Function
Chirp
Function
Doors Locked
Doors Unlocked
Car Locator
1 Chirp
2 Chirps
6 Chirps
Doors Locked
Doors Unlocked
Car Locator
2 Flashes
12 Flashes
Constant On
Under Remote Control
Replacement Parts for the M6a
ORDER BY MAIL
DESCRIPTION
MODEL #
$ PRICE
4-Button Transmitter with
SAW Technology for
M4ARF
44.95 ea.
M6a Remote Engine Starter with
Keyless Entry System
3 Volt CR2032 Lithium Battery (1 pc.)
—
—
Models:
Radio Shack: #23-162 (CR2032)
Duracell: #DL2032
Eveready: #ECR2032
Panasonic: # CR2032
6
Download from Www.Somanuals.com. All Manuals Search And Download.
M6A-UM 3/8/05 3:45 PM Page 7
Limited Lifetime Warranty
Magnadyne Corporation or its authorized agents will, for the life of the vehicle and to the original
purchaser, repair, replace or refund the retail sales price of said product or any part thereof, at the
option of the Magnadyne Corporation or its authorized agents, if said product or part is found
defective in materials or workmanship, when properly connected and operating on the correct
power requirements designated for the specific product. This warranty and Magnadyne Corporation
or its authorized agents obligations, hereunder do not apply where the product was: damaged while
in the possession of the consumer, subjected to unreasonable or unintended use, not reasonably
maintained, utilized in commercial or industrial operation, or serviced by anyone other than
Magnadyne Corporation or its authorized agent, or where the warning seal on the product is broken
or the power plugs or wires are detached from the unit. Magnadyne Corporation or any of its
authorized agents do not assume any labor costs for the removal and reinstallation of any product
found to be defective, or the cost of transportation to Magnadyne Corporation or its authorized
agents. Such costs are the sole responsibility of the purchaser.
This warranty does not cover the cabinet, appearance items, normal wear and tear or accessories
used in connection with the product resulting from improper installation, alteration, accident, misuse,
abuse or acts of nature.
This Limited Life Time Warranty applies only to the receiver section of the security system. Neither
the siren, transmitters, wire harness or any accessory item added to or used with a Remote Mobile
security system are covered by this Limited Life Time Warranty. Sirens, transmitters, wire harness
or any accessory item are covered by our standard 12 month limited warranty.
Magnadyne Corporation or its authorized agents shall not be liable to anyone for consequential
or incidental damages or claims that may arise due to failure of product to operate properly
except those accorded by law. Magnadyne's or its authorized agents liability to the repair,
replacement of the product as stated above if all conditions of the warranty are met. No
expressed warranty or implied warranty is given except those set forth herein. Magnadyne does
not warrant or guarantee against break in damage or the theft of the vehicle in part or whole, or
against the loss or damage to the contents of any vehicle in which a security system is installed.
Magnadyne security systems are only a deterrent against possible theft.
This warranty extends only to the original purchaser of the product and for the vehicle in which it
was originally installed. This warranty is not transferable or assignable to any person or vehicle.
Defective merchandise should be returned to the original point of purchase or secondly to
Magnadyne Corporation, 1111 W. Victoria Street, Compton CA 90220.
A return authorization must be obtained before sending, or merchandise may be refused.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
M6A-UM 3/8/05 3:45 PM Page 8
Parts and Accessories Order Form
Mail to: Magnadyne Corporation
ATTN: Consumer Parts Sales
P.O. Box 5365
Credit Card or Money Order Only
(Sorry No Cash, C.O.D. or personal checks accepted)
Carson, CA 90749-5365
SHIP TO: (No P.O. Boxes)
LAST NAME
FIRST NAME
INITIAL
STREET ADDRESS
ADDITIONAL ADDRESS
ADDITIONAL ADDRESS
CITY
STATE
ZIP CODE
DAY TIME PHONE NUMBER
CREDIT CARD INFORMATION
VISA
MC
CREDIT CARD N0.
CARD HOLDER’S LAST NAME
STREET ADDRESS
CITY
EXPIRATION DATE
FIRST NAME
INITIAL
STATE
QTY.
ZIP CODE
PART #
DESCRIPTION
PRICE EACH
TOTAL
Shipping and Handling
Sales Subtotal = ________ . ______
Up to $20.00
20.01 to 30.00
30.01 to 45.00
45.01 to 70.00
Over 70.01
$5.00
5.95
6.50
6.95
7.95
California Residents Add Sales Tax = ________ . ______
Shipping and Handling (See Chart) = ________ . ______
TOTAL = ________ . ______
On regular orders please allow 4-5 weeks for delivery.
Please give a shipping address where this order may be delivered between the hours of 9 a.m. and 5 p.m. weekdays.
If UPS is unable to deliver, your order will be returned and additional shipping charges will be required.
© Copyright 2005 Magnadyne Corporation
M6A_UM 3-8-05 Rev. C
Download from Www.Somanuals.com. All Manuals Search And Download.
|
Lennox International Inc Air Conditioner Dave Lennox Signature Collection XC21 System User Manual
LG Electronics Washer WM2487HRMA User Manual
Life Fitness Bicycle LCSR30 0XXX 01 User Manual
Life Fitness Stepper Machine clsxh oxxx 02 User Manual
Magnepan Speaker System MG36 R User Manual
Maytag Refrigerator W10321475A User Manual
McCulloch Chainsaw MS1432 User Manual
McCulloch Lawn Mower 966564101 User Manual
Melissa Styling Iron 635 109 User Manual
Memorex TV VCR Combo MVT2139 User Manual