1. INTRODUCTION
2. KEYPAD FEATURES
The Model AM-KPI keypad is designed for use with Linear’s AM/II
access control system. The keypad is housed in a rugged, plastic
enclosure and is designed to be mounted indoors in a standard single-
gang electrical box. Tamper resistant screws secure the keypad to its
mounting plate. The die-cast keys have bright, easy-to-read yellow
graphics.
RED/GREEN
POWER/ACCESS
INDICATOR
YELLOW
"LOCKOUT"
INDICATOR
AM-KPI
BEZEL
The keypad is supplied with a satin-chrome plastic bezel installed.
Three interchangeable colored plastic bezels (white, ivory, & bronze)
are included with the unit to customize the keypad appearance for the
installation.
Access
Control
Keypad
SOLID STATE
WHITE LED
DOWN LIGHT
DEVICE
ADDRESS
SELECTOR
All system indicators and lights are long-lasting, solid-state LEDs.Two
indicators show the status of the entry system. The left indicator lights
red to indicate power, then turns green when access is granted. The
right indicator lights yellow when the keypad is in “lockout” condition
(from too many incorrect code entries). A white LED downlight lights
the keypad for nighttime use. An internal sounder beeps when each
key is pressed.
FACEPLATE
KEYPAD
Installation
Instructions
The AM-KPI is normally powered from the AM/II controller. Alternately,
the keypad can be powered locally with a 12 VDC power supply.
Robust static and lightning protection circuits safeguard the keypad’s
electronics.
TERMINAL
BLOCK
A rotary switch selects the keypad’s device address. Each device
connected to the AM/II must be set to a different device address.
MOUNTING
PLATE
(760) 438-7000 • FAX (760) 438-7043
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
3. OPEN THE KEYPAD
4. CUSTOMIZE THE BEZEL (OPTIONAL)
5. INSTALL WALL BOX & MOUNTING PLATE
1
PRY UP ON THE
FACEPLATE HERE
TO CHANGE THE APPEARANCE OF THE KEYPAD
TO BLEND IN WITH THE INSTALLATION,
CHOOSE THE APPROPRIATE KEYPAD BEZEL
INSTALL A SINGLE-GANG
ELECTRICAL BOX AT THE
PROPER LOCATION
FOR THE KEYPAD
REMOVE THE
FACEPLATE
2
KEYPAD BEZEL COLORS:
•
•
•
•
SATIN-CHROME (FACTORY INSTALLED)
KEYPAD
BEZEL
WHITE
IVORY
BRONZE
KEYPAD
ASSEMBLY
MAKE SURE THE
TAB IS UP
MOUNTING
PLATE
3
ATTACH THE MOUNTING
MOUNTING
REMOVE THE
TWO SCREWS
THE BEZEL SNAPS
ONTO THE KEYPAD
ASSEMBLY
PLATE TO THE
ELECTRICAL BOX
PLATE
SEPARATE THE
MOUNTING PLATE
FROM THE KEYPAD
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|