LEGACY
INSTRUCTION MANUAL
USA
EUROPE
IMPORTANT:
This radio is set to USA frequency by factory, if European
frequency is required please flip the frequency step switch on
the side of the unit.
After the switchover of the frequency switch, the frequency convert
function will not be valid until the RESET button has been pressed.
REMOTE CONTROL BASICS BATTERY REPLACEMENT:
1.Remove the battery holder as the direction indicated by the arrow.
2.Replace the battery Set a new battery properly with (+)side up as illustrated.
3.Insert the battery holder. Push in the holder to the original position.
NOTE ON BATTERIES:
Old batteries must immediately be removed and disposed.
BATTERY INFORMATION:
Designated Battery: CR2025 3V.
Battery Life: 6 months with normal use (in normal room temperature)
CAUTION:
Improper use of batteries may cause overheating, explosion or ignition. Resulting in
jury or fire .Battery leakage may cause damage to the unit.
Do not disassemble or short the batteries. Do not throw the batteries into the fire.
To avoid the risk of accident, keep the batteries out of reach of children.
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM
AUTO-LOADING COMPACT DISC PLAYER
AM/FM STEREO WITH DIGITAL TUNING RADIO
MODEL:LCD69DSX
11
Download from Www.Somanuals.com. All Manuals Search And Download.
TROUBLE SHOOTING
DISC PLAY:
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Cleaning discs
Before playing, clean the disc with a clean, lint-free.
Flip the disc in the direction of the arrow.
Symptom
No power
Cause
Solution
The car ignition is not on.
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
The fuse is blown
Replace the fuse
Presence of CD disc inside
the player
Remove the disc in the player
then put a new upward
Disc cannot
be loaded or
ejected
NOTE:
. Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
Inserting the disc in upside
down
Insert the compact disc with
the label facing upward
Compact disc is extremely
dirty or defective
Clean the disc or try to play a
new one
Insert a disc with the label surface down. Doing so may damage the unit.
Temperature inside the
car is too high
Cool off until the ambient
temperature returns to normal
Label
surface up
Condensation
Leave the player off for an
hour or so, then try again
Volume is in minimum
Adjust volume to a desired level
No sound
Wiring is not properly
connected
Check wiring connection
NOTE:
. Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
.Handle the disc by its edge. And to keep the disc clean, do not touch
the surface.
The operation
keys do not
work
The built-in microcomputer
is not operating properly
due to noise
Press the RESET button
front panel is not properly
fix into its place
The installation angle
is more than 30 degrees
Adjust the installation angle
to less than 30 degrees
Sound skips
The disc is extremely
dirty or defective
Clean the compact disc/try to
play a new one
The radio does
not work
the radio
Insert the antenna cable firmly
select a station manually
The antenna cable is not
connected
the signals are too weak
station
.Do not stick paper or tape on the disc.
automatic
selection does
not work
.Do not expose the disc to direct sunlight or heat sources such as hot air
ducts. Or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
2
9
Download from Www.Somanuals.com. All Manuals Search And Download.
SPECIFICATION
GENERAL
LOCATION AND FUNCTION OF CONTROL
Power requirement..............................................................................................DC 13.8V.
Current consumption..............................................................................................7A MAX.
POWER OUTPUT.....................................................................................................4 X 40W.
FM SECTION
Frequency range..................................................................................87.5MHz -108.0MHz.
Usable sensitivity.........................................................................................................3uV.
I.F Frequency........................................................................................................10.7MHz.
AM SECTION
Frequency range.....................................................................................522KHz - 1620KHz.
Frequency range.....................................................................................530KHz - 1710KHz.
LINE - OUT [OPTION]
Output...............................................................................1000mV @ FM 10% THD POWER.
Impedance............................................................................................................600 ohm.
CD PLAYER
System........................................................................................compact disc audio system.
Usable disc......................................................................................................compact disc.
Signal format.............................................................................sampling frequency 44.1KHz.
No of quantization bits 1bit.
Frequency characteristics...............................................................................5-40Hz < 5dB
10K-20KHz < 5dB.
1. FOLDABLE SPEAKER
Signal to noise radio................................................................70dB [1KHz] [IEC - A net work].
Number of channels..............................................................................................2 STEREO.
Chassis dimensions.......................................................................178[W] X 50[H] X 165[D].
2.
[TUNE/SEEK DOWN] BUTTON and TRACK DOWN BUTTON
a. The frequency scans down by one step when pressing
button once. Hold
it for more than 2 seconds to seek for a station of lower frequency.
b. During CD mode, press
button allow you to track forwards.
Hold the button allow you to skip forwards.
c. To set minutes at time setting mode.
[TUNE/SEEK UP] BUTTON and TRACK UP BUTTON
a. The frequency scans up by one step when pressing
button once. Hold
it for more than 2 seconds to seek for a station of higher frequency.
b. During CD mode, press button allow you to track backwards.
Hold the button allow you to skip backwards.
c. To set hour at time setting mode.
3
8
Download from Www.Somanuals.com. All Manuals Search And Download.
3. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTON
Press SEL button to change the mode in the sequence of
VOL
BAS
TRE
BAL
FAD
Speaker Connection
a. The volume level can be adjusted at any time by pressing the audio level+ or
- button as select mode has been initially defaulted at volume mode.
b. The volume level is also obtained by stepping through the SEL button until
the function VOL is displayed and then press + or - button to adjust the
sound level.
ANTENNA PLUG
12 P
YELLOW
MEMORY B+
FUSED
FILTER
BOX
c. Press and hold the + or - button to adjust the sound level.
RCA LINE OUT
RED R
BLACK(GND)
0.5A &7A
FUSES
WHITE L
BASS CONTROL
a. Press the SEL button to select the bass mode until BAS appears on the display.
b. Press + or - to adjust the bass effect.
RED (B+)
BLUE AUTO ANT
+
+
FRONT
GRAY
WHITE
FRONT
RIGHT
SP
TREBLE CONTROL
a. Press the SEL button to select the treble mode until TRE appears on the display.
b. Press + or - to adjust the treble effect.
WHITE/BLACK
GRAY/BLACK
VIOLET
LEFT
SP
+
+
GREEN
REAR
REAR
GREEN/BLACK
VIOLET/BLACK
BALANCE CONTROL
Note:
Make sure use a 4-ohms impedance speaker in spite of having any kinds
of speaker system. So that reduce the distortion during high volume level.
a. Press the SEL button to select the balance mode until BAL appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
left or right speaker.
FADER CONTROL
NOTE: SOMETIMES THE DISC CANNOT BE LOADED
WHEN THE YOU CONNECT THE MEMORY WIRE AT THE
FIRST TIME AND THE DISC MARK WILL BE DISPLAYED
ON LCD. PLEASE PRESS RESET BUTTON AND RESTART
THE UNIT, THE UNIT WILL RESTORE TO NORMAL STATE.
a. Press the SEL button to select the fader mode until FAD appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
front or rear speaker.
4. INFRA-RED RECEIVE WINDOW
5. LCD ( LIQUID CRYSTAL DISPLAY)
6. MUTE BUTTON
Press it to reduce the volume level temporarily.
7. POWER BUTTON
Press the button to turn on or off the unit.
8. OPEN(EJECT) BUTTON
Push it to slide the panel then you can insert or eject the disc from
the compartment.
7
4
Download from Www.Somanuals.com. All Manuals Search And Download.
9. RELEASE BUTTON
Press it to flip down the front panel when you want to take away.
17. PRESET STATION [ 1-6 ] / 2RPT, 3INT, 4RDM.
A]. To memorize the current frequency, press and any one of the six preset
buttons for more than 2 seconds.
10. LOUDNESS BUTTON
Press it to enhance the bass effect.
B]. To recall the preset memory, press one of the preset button [1-6].
C]. REPEAT BUTTON
During CD mode. Press 2 RPT button to repeat a single track.
D]. During CD mode press 3 " INTRO "button.
11. CLOCK ADJUSTMENT BUTTON
During frequency display, press it to change to clock function.
Press the button for more than 2 seconds, until time flashes. and you can adjust
time now.
It play individually tune for 10 seconds.
If this key is pressed in intro scan mode, it display " INTRO ".
E]. During CD mode press 4 " RDM " button.
If this key is pressed, and at the end of the tune random tuning function
performs.
To adjust hour:
with time on display, push the tune
completed, release the button.
To adjust minute:
with time on display, push the tune
completed, release the button.
button adjust hour, when adjustment is
button adjust minute. When adjustment is
If this key is pressed, in random play mode, it display " RDM ".
12. MONO/STEREO BUTTON
Press it to select mono/stereo mode.
13. LOCAL/DISTANCE BUTTON
When in the radio mode, press them to select local or distance broadcast
station receive sensitivity. The word LOC will appear on LCD during local
state.
14. BAND BUTTON
Press it to select your desired radio band.
15. AS/PS [ AUTOMATIC STORE AND PRESET MEMORY] BUTTON
Press it to perform all stations memory for 5 seconds each time. While memory
digital and frequency will flash on LCD. If the button is pressed for more than 2
seconds, it will seek station on current band, then write to the preset memories
and word ART will appear on LCD. When the auto-storage operation is completed,
it will automatically perform for 5 seconds each time, during the memory station
performing, press 1-6 digital buttons to select and stop scanning function.
a. SCAN BUTTON
Press it to scan the memorized stations 10 seconds each. Stop scanning
function and return to playback as long as your desired station has been
found.
b. POWER BUTTON
Press it to turn on or off the unit.
16. CD
[CD PLAY, PAUSE] BUTTON
button to switch to CD mode. At CD mode,
At tuner mode, press
press it to pause the CD program and press it again to resume CD
playback.
6
5
Download from Www.Somanuals.com. All Manuals Search And Download.
|