LTR-RBR
REMOTE BELL RINGER
Installation & User’s Guide
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION, INSTALLATION
AND MAINTENANCE MANUAL
“REMOTE BELL RINGER”
LATHEM TIME CORP
Doc #USG0027A
“LTR8-512” and “MasterLink”
are Registered Trademarks of Lathem Time Corp., Atlanta,
GA, USA
©2003 LATHEM TIME CORP
Download from Www.Somanuals.com. All Manuals Search And Download.
Welcome to the LTR-RBR (Remote Bell Ringer)
Lathem’s LTR8-512 Master Controller for Clocks and Bells is capable
of storing up to eight (8) Schedules for Bells and Control Zones, each
of which may contain up to sixty-four (64) multi-function ‘Events’. An
‘Event’ may be defined by a very simple instruction, such as “Ring the
Bell on Circuit #4 for 3-seconds every day at 3:00PM”, or it may
contain a more complicated definition, as, “On Mondays, Wednesdays,
Fridays and Holidays, Activate Circuits #2, #3 and #4 at 2:45PM for a
duration of 7-seconds.” While eight Schedules may be stored in the
Master, the User may select which of the eight may be ‘Active’. As
time advances each minute, the day and time are automatically
compared against the Events stored in the Schedules which have been
selected as ‘Active’. If a match is found, the programmed Event is
executed. The Master Controller also provides the capability for
Manually Activated Bells, through the use of KeyPad Function
[#][3}[#], which allows the user to select one or more of the Bell
Circuits to be activated by subsequent press of the [#] key.
The “Remote Bell Ringer”, an accessory for the LTR8-512 Master
Controller (Firmware v4.08 and above, only), allows an Operator to
Download from Www.Somanuals.com. All Manuals Search And Download.
select and activate one (1) of the eight (8) possible Bell Circuits or all
Bell Circuits (those circuits not defined as Clock Control Circuits) in
the Master Controller. The selection made will execute when the push
button on the Remote Bell Ringer’s Panel is pressed, and those circuits
will remain activated until the button is released.
The Assembly of the Remote Bell Ringer consists of an Electronic
Circuit suspended beneath a cover plate for a double-gang switch-type
electrical box (not supplied with the product). The Circuit includes a
low-power MicroProcessor, a method of selecting the ‘Address’ of the
Master to be remotely controlled, and a 4-screw Terminal Block for
Installer Interconnect. Two screws of the Terminal Block are for
attachment of the Twisted-Pair (Cat-3 typical) low-voltage Network
Communications Cable to the Master’s RS-485 Port. The other two
screws are to be used for supplying 9-24V AC/DC as continuous power
source to the unit.
On the face of the cover plate are a 9-position Rotary Switch (to select
the Circuits to be made ‘Active’), a Push Button to send the Command
to the Master, and an array of lighting Status Indicators by which the
Operator can receive confirmation from the Master that the Manual
Bells Command has been accepted and acted upon.
Download from Www.Somanuals.com. All Manuals Search And Download.
Installing the LTR-RBR
To install the Remote Bell Ringer, simply set the hidden Address
Selector switch / jumpers to match the Master’s Programmed Address
(default = Code 65) and attach the Communication Cable wire-pair
(with proper polarity) and the low-voltage Power Pair to the Terminal
Block, then secure the cover-plate to the electrical box with four 6-32
FH screws.
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
Operational Description
To use the Remote Bell Ringer, the Operator will first select, via the
Rotary Switch, which of the Bell Circuits are to be made active.
Selected Circuits that are not configured as Bell Circuits in the Master
Controller will be ignored
y
y
The ‘OFF’ position may be used to de-activate all Bell Circuits
Positions ‘1’ to ‘8’ may be used to select a single Bell Circuit to be
made ‘Active’
y
The ‘ALL’ position may be used to activate all circuits configured
as Bell Circuits.
After setting the selected position of the Rotary Switch, the Operator
should press the ‘ENTER SELECTION’ Push-Button. This will ‘wake-
up’ the Microprocessor (indicated by a brief ‘flash’ of the indicators)
which will, in turn, read the Switches and transmit the appropriate
Command to the Master. It will wait for a reply from the Master, which
will indicate the Bell Circuits which are now Active, and display that
information on Lighting Indicators as confirmation to the Operator that
the Command has been accepted and executed by the Master. The lit
Indicators will remain active for 2 seconds after the button is released,
after which the unit will go back to ‘sleep mode’, to conserve power.
Download from Www.Somanuals.com. All Manuals Search And Download.
Master Control/Remote Bell Ringer
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
Limited One-Year Limited Warranty
Lathem warrants the hardware products described in this guide against defects
in material and workmanship for a period of one year from date of original
purchase from Lathem or from an authorized Lathem reseller. The conditions
of this warranty and the extent of the responsibility of Lathem Time
Corporation (“Lathem”) under this warranty are listed below.
1. This warranty will become void when service performed by anyone
other than an approved Lathem warranty service dealer results in
damage to the product.
2. This warranty does not apply to any product which has been subject to
abuse, neglect, or accident, or which has had the serial number altered
or removed, or which has been connected, installed, adjusted, or
repaired other than in accordance with instructions furnished by
Lathem.
3. This warranty does not cover dealer labor cost for removing and
reinstalling the machine for repair, or any expendable parts that are
readily replaced due to normal use.
4. The sole responsibility of Lathem under this warranty shall be limited to
repair of this product, or replacement thereof, at the sole discretion of
Lathem.
5. If it becomes necessary to send the product or any defective part to
Lathem or any authorized service dealer, the product must be shipped in
Download from Www.Somanuals.com. All Manuals Search And Download.
its original carton or equivalent, fully insured with shipping charges
prepaid. Lathem will not assume any responsibility for any loss or
damage incurred in shipping.
6. WARRANTY DISCLAIMER AND LIMITATION OF LIABILITY:
Except only the limited express warranty set forth above, the products
are sold with no expressed or implied warranties of any kind, and the
implied warranties of merchantability and fitness for a particular
purpose are hereby expressly disclaimed. No warranties are given with
respect to products purchased other than from Lathem or an authorized
Lathem reseller and any such products are purchased "as is, with all
faults." In no event will Lathem be liable for any direct, indirect,
special, incidental or consequential damages arising out of or in
connection with the delivery, use or inability to use, or performance of
this product. In the event any limited remedy given herein shall be
deemed to have failed of its essential purpose, Lathem's maximum
liability shall be to refund the purchase price upon return of the product.
7. Proof of date of purchase from Lathem or an authorized Lathem reseller
is required for warranty service on this product.
8. This Warranty grants specific legal rights. Additional legal rights,
which may vary by locale, may also apply.
9. Should any difficulties arise with the performance of this product during
warranty, or with any Lathem authorized service centers, contact
Lathem Time at the address below.
Download from Www.Somanuals.com. All Manuals Search And Download.
Lathem Time
200 Selig Drive, SW, Atlanta, GA 30336
404-691-0405
Copyright © 2003 Lathem Time Corporation. All rights reserved.
Download from Www.Somanuals.com. All Manuals Search And Download.
|
KWC Indoor Furnishings 12243151000 User Manual
Lexmark Printer 19Z0100 User Manual
Linksys Network Card WGA11B User Manual
Loewe Flat Panel Television 3781 ZW 3981 ZW 32 6381 ZW 5381 ZW User Manual
LSI Computer Hardware 25083 User Manual
Makita Saw 2414NB User Manual
Matsushita Personal Computer CF 74ECBAXBM User Manual
McCulloch Lawn Mower M40 125 M46 125 M46 125R User Manual
McIntosh Car Amplifier MCC204 User Manual
Meyer Sound Speaker System 500A Series User Manual