To mount a Kramer insert or connector module:
The Kramer T1AF-26 Inner Frame
Congratulations on purchasing your Kramer T1AF-26 inner frame for the TBUS-1Axl Table
1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the
blank plate.
Connection bus.
The T1AF-26 inner frame includes:
2. Place the required Kramer insert over the opening, insert the two screws to fix the
Kramer insert in place, and tighten them.
•
•
An opening for 2 power sockets
4 blank inserts
•
2 cable pass-through inserts
Installing the Assembled Inner Frame
To install the T1AF-26 inner frame:
1. Place the assembled inner frame inside the TBUS-1Axl enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired
position, screw and tighten it in place using the height adjustment screws supplied with
the inner frame.
Connecting the Cables
Figure 1: T1AF-26 Inner Frame (P/N: 80-000399)
When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so
on):
Power Socket and Power Cord Options
1. Insert the cables to their appropriate connectors from underneath.
Various power sockets and power cords are available to use with the T1AF-26, as described
in the “TBUS Modular Power Socket Installation and Power Cord” Installation Instructions,
supplied with the power socket.
2. Secure the cables to the tie holes on the TBUS-1Axl.
Do not secure the cables too tightly or too loosely. Leave a small amount of slack.
After the TBUS-1Axl is connected to mains power and the proper cables, it is ready for use.
Each power socket comes with detailed assembly instructions.
i
Inserting Pass-through Cables
To insert the pass-through cables (for example, to connect a laptop) do the following:
1. Remove the four screws attaching the split pass-through bracket.
2. Remove the split grommet(s).
Mounting the Inserts
user manuals and the complete list of Kramer wall plates and
module connectors.
i
3. Insert the cable(s) through the rectangular opening.
You can rearrange or remove any of the plates mounted on the inner frame and replace them
4. Open the split grommet slightly and insert the required cables.
with Kramer passive wall plates or connector modules for interfacing A/V type signals.
5. Place the split bracket around the grommet and position this assembly over the inner
frame.
6. Place the four screws appropriately and tighten the split bracket together with the
grommet and inserted cables to the inner frame.
Download from Www.Somanuals.com. All Manuals Search And Download.
|