THX Ultra2
In-Ceiling
Owner's Manu
Download from Www.Somanuals.com. All Manuals Search And Download.
To maximize performance, install the KL-7502-THX equally spaced to
either side of the video display. When being used as a center channel,
please locate the speaker as close to the video display as is practical.
4. Insert the speaker assembly into the opening and attach by
tightening the Phillips screws (see illustration). The frame’s
“dogs” will swivel out and “sandwich” the ceiling and frame
together as they are tightened. If you use a power tool to
tighten these screws, please use a low torque setting. Failure
to do so could result in damage to your speaker (see Figure 3)
The KS-7502-THX should be installed to either side of the listening
position at an equal distance from the listener whenever possible. You
may also install them behind the listening position and achieve good results.
Figure 3
Figure 1
5. At this point, you may paint the speaker grille before attaching it
to the speaker. Klipsch speakers and grilles are designed to
accept most types of paint. Use the supplied clear paint shield to
protect the speaker baffle and drivers when painting the bezel of
the speaker. Care should be taken to avoid excessive paint
build-up in the grille perforations. Please remove the scrim
material attached to inner surface of the grille by carefully
peeling it out prior to painting. Reinstall scrim after the paint on
the grille is dry.
THX Ultra2 7.1 surround systems utilize a surround back channel in
addition to the traditional side surrounds. When configuring such a
system it is suggested to use KL-7502 speakers in the surround back
location.
Figure 2
6. Press the grille into place.
Speaker Installation
(for New Construction, skip to step #3)
1. Cut the appropriate size opening in the ceiling using the template
provided. If the template is not available, cutout dimensions are
listed are minimum. If accuracy of cut cannot be achieved,
you may add 1/4” to the dimension. Be careful not to cut
through any existing wiring or plumbing. Avoid compromising
any fire stops between studs.
2. Run speaker wiring (18 gauge minimum) to the openings. Be
sure to comply with all building codes in your area.
3. Attach the wire to the speaker using the wire’s color coding or
markings as a guide to maintain proper polarity.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Warranty – U.S. and Canada
Warranty Outside the U.S. and Canada
The Warranty on this product if it is sold to a consumer outside of the
United States and Canada shall comply with applicable law. To obtain
any applicable warranty service, please contact the dealer from
which you purchased this product, or the distributor that supplied
this product.
Klipsch warrants to the original retail purchaser that this product is
to be free from defective materials and workmanship for a period
of five (5) year, from the date of purchase, if it is properly used and
maintained. If this product proves defective in either material or
workmanship, Klipsch, at its option, will (a) repair the product, or (b)
replace the product, at no charge for parts or labor. If the product
model is no longer available and cannot be repaired effectively or
replaced with an identical model, Klipsch at its sole option may
replace the unit with a current model of equal or greater value. In
some cases, modification to the mounting surface may be required
where a new model is substituted. Klipsch assumes no responsibility
or liability for such modification. To obtain a repair or replacement
under the terms of this warranty, please contact our customer
service group at 1-800-KLIPSCH. You will be required to submit a
copy of the original receipt via fax or email. The receipt must reflect
that you are the original purchaser, the product was bought from an
authorized Klipsch retailer, and the product is still within warranty.
You will be issued a return authorization number (RA#) and asked to
ship the defective product, together with proof of purchase and RA#,
prepaid insured to the address set forth Klipsch 137 Heampstead
#278 Hope, AR 71801. Freight collect shipments will be refused.
Risk of loss or damage in transit is to be borne by the purchaser.
Once Klipsch receives the defective product, a repair or replacement
order will be initiated.
FCC and Canada Compliance Information
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Limitations:
Approved under the verification provision of FCC Part 15 as a Class
B Digital Device.
•
This limited warranty does not cover failure of the product
resulting from improper installation, misuse, abuse, accident,
neglect, mishandling, or wear from ordinary use or environmen-
tal deterioration.
Caution: Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate this device.
•
This limited warranty does not cover cosmetic damage,
including paint damage, or consequential damage to other
components or premises which may result for any reason
from the failure of the product.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme á la norme
NMB-003 du Canada
•
•
This limited warranty is null and void for products not used in
accordance with Klipsch’s instructions.
This limited warranty is null and void for products with altered or
missing serial numbers and for products not purchased from an
authorized dealer.
EU Compliance Information
Eligible to bear the CE mark, Conforms to European Union Low Volt-
age Directive 73/23/EEC and 2006/95/EC; Conforms to European
Union EMC Directives 89/336/EEC and 2004/108/EC.
•
This limited warranty terminates if you sell or otherwise transfer
this product to another party.
WEEE Notice
Note: This mark applies only to countries within the European Union
(EU) and Norway.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU
MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO
STATE, JURISDICTION TO JURISDICTION OR COUNTRY TO COUNTRY.
KLIPSCH’S RESPONSIBILITY FOR MALFUNCTIONS AND DEFECTS
IN HARDWARE IS LIMITED TO REPLACEMENT OR REPAIR AS SET
FORTH IN THIS WARRANTY STATEMENT. FOR CANADIAN
CUSTOMERS, KLIPSCH DISCLAIMS ALL OTHER WARRANTIES AND
CONDITIONS, EXPRESS OR IMPLIED, STATUTORY OR OTHERWISE,
FOR THE PRODUCT. FOR U.S. CUSTOMERS, ALL EXPRESS AND
IMPLIED WARRANTIES FOR THE PRODUCT, INCLUDING BUT NOT
LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN TIME TO
THE TERM OF THIS WARRANTY. SOME STATES, JURISDICTIONS OR
COUNTRIES DO NOT ALLOW THE EXCLUSION OF CERTAIN IMPLIED
WARRANTIES OR CONDITIONS, OR LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY OR CONDITIONS LASTS, SO THIS LIMITATION
MAY NOT APPLY TO YOU. KLIPSCH DOES NOT ACCEPT LIABILITY
FOR SPECIAL, INDIRECT, CONSEQUENTIAL OR INCIDENTAL
This application is labeled in accordance with
European Directive 2002/96/EC concerning waste
electrical and electronic equipment (WEEE). This label
indicates that this product should not be disposed of
with household waste. It should be deposited at an
appropriate facility to enable recovery and recycling.
THX and the THX logo are trademarks of THX Ltd. which may be
registered in some jurisdictions. All rights reserved.
DAMAGES, INCLUDING WITHOUT LIMITATION, ANY LIABILITY FOR
THIRD PARTY CLAIMS AGAINST YOU FOR DAMAGES OR FOR
PRODUCTS NOT BEING AVAILABLE FOR USE. THE MAXIMUM
LIABILITY FOR WHICH KLIPSCH MAY BE RESPONSIBLE WILL BE NO
MORE THAN THE AMOUNT YOU PAID FOR THE PRODUCT THAT IS
THE SUBJECT OF THE CLAIM. SOME STATES, JURISDICTIONS OR
COUNTRIES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES,
SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|