Dual 4'' Two-Way Center-Channel Satellite Loudspeaker
RCX-4
The RCX-4 is a low-profile, horizontally
oriented center channel loudspeaker. Although
designed primarily to work with the RSX-4 and
I
Very high sensitivity
MicroTractrix Horn tweeter for clean, detailed highs
Dual Cerametallic cone woofers in a Tapered Array configuration to
I
I
RSX-5 Reference Satellites, which it matches
maximize clarity
perfectly both cosmetically and sonically, the
I
Ball-joint pedestal stand with keyholes allows easy placement
RCX-4’s sound also blends well with that of
I
Magnetically shielded to prevent video interference
other Klipsch loudspeakers, allowing
maximum flexibility in system configuration. Its
gracefully contoured, high-rigidity enclosure
fits easily on any television set, or it can be
S P E C I F I C A T I O N S
shelf-, wall-, or ceiling-mounted. An integrated
ball-joint pedestal stand with bottom keyholes
makes it easy to place the RCX-4 on any
convenient surface and direct its sound into
the listening area.
BANDWIDTH
92Hz-20kHz 3dB
94dB @ 2.83 volts/1 meter
8 ohms compatible
2100Hz
SENSITIVITY
NOMINAL IMPEDANCE
CROSSOVER FREQUENCY
POWER HANDLING
High frequencies emanate from a 1-inch
titanium dome compression driver tweeter.
The round MicroTractrix™ Horn molded into
the front of the cast aluminum baffle raises the
driver’s efficiency and controls its radiation
pattern to minimize detail-blurring reflections
from walls, floor, and ceiling. Flanking the
tweeter are twin 4-inch Cerametallic™cone
woofers operating as a Tapered Array. Klipsch
Tapered Array™ Technology operates both
woofers at the lowest frequencies and only
one all the way up to the point where the
tweeter takes over, eliminating the destructive
middle-frequency interference between
woofer outputs characteristic of ordinary
woofer-tweeter-woofer lineups. Low-
frequency response extends deep enough to
mesh seamlessly with the crossovers built into
A/V receivers, surround processors, and
powered subwoofers. All drivers are
magnetically shielded to prevent interference
with direct-view television sets. As in all
Reference Series loudspeakers, premium
crossover components ensure optimum signal
transfer.
75 watts (300 watts peak)
ENCLOSURE TYPE
DRIVE COMPONENTS
Bass reflex via dual rear-firing ports
Two-way system using one 1'' (2.5cm)
magnetically shielded, titanium dome
compression driver tweeter with an integral
round 90˚ MircroTractix Horn and two 4''
(10.2cm) magnetically shielded, Cerametallic
cone woofers
WEIGHT
HEIGHT
WIDTH
DEPTH
7.5 lbs. (3.4kg) including base
7.5" (19cm) including base, 5.4" w/out base
14.8" (37.6cm)
8.4" (21.3cm)
FINISH
MOUNTING
Black or Silver
Base swivels 360˚ for on-wall mounting via
keyholes
Because of its high power-handling capability
and unusually high sensitivity, the RCX-4 can
sustain significantly higher output than most
similar-size center speakers. And though
ideally suited for use with other Klipsch
loudspeakers, it will provide excellent center
channel sound in any system.
1-800-KLIPSCH
Download from Www.Somanuals.com. All Manuals Search And Download.
All specifications are subject to change without notice. ©2004
|