b06739_QuickStartInsert_B60 5/2/05 4:57 PM Page 1
®
KEURIG
Quick Start Guide
Premiuum Coffffee Sysstems
Let the Magic Begin FAST!
®
Thank you for purchasing a Keurig Special Edition - Model B60 Gourmet Single
Cup Home Brewing System.
IMPORTANT: You cannot use your Keurig Brewer until it has been primed for its first
use as set forth below. Please follow these easy steps and you will discover what
Deliciously Simple™ truly means.
Please note, if your Brewer has been exposed to temperatures below freezing, it is recommended you
allow two hours for an unpacked brewer to warm to room temperature before priming or brewing.
displayed and the Travel Mug button will flash.
1. Unpacking the Special Edition -
g. Press the blue Travel Mug button to start a cleans-
Model B60 Brewer
ing brew, during which hot water will flow into your
a. Carefully remove the Brewer by placing the box on
cup or mug. Pour the hot water into the sink.
its side, and pulling the Brewer out of the box and
h. The one-time priming process is now complete and
you are ready to brew!
removing the protective materials.
b. Place the Brewer upright on a flat surface. Remove
three pieces of adhesive tape from Brewer.
NOTE: The Brewer may take 15 seconds to reheat
between brews and the LCD Control Center will
indicate 'NOT READY'. During this time the pump
may cause a vibration noise. This is normal. The
LCD Control Center will indicate 'READY TO BREW'
once the water has heated and the Brewer is ready.
c. Unwrap cord and plug Brewer into a grounded outlet.
2. Priming
a. Place a cup or mug on the Drip Tray Plate.
b. Remove the Water Reservoir from the Brewer by
first removing the Lid from the Water Reservoir,
then lifting the Water Reservoir straight up and away
from the Brewer. Rinse and fill with cold water.
Replace the Water Reservoir back on the Brewer
and replace the Lid.
3. Choose
a. Place a cup or mug on the Drip Tray Plate.
b. Select a K-Cup® portion pack.
Do not remove the foil lid.
c. Press the Power Button to turn the Brewer on and
the blue light in the Water Reservoir and LCD
Control Center will become illuminated.
4. Brew
a. Lift the Handle, place the K-Cup in the K-Cup Holder
Assembly and then push the Handle all the way
down to puncture the K-Cup.
d. The LCD Control Center will indicate ‘PRIME’ and
the Travel Mug button will flash. Please note, a
K-Cup® portion pack should not be used for the
Priming Sequence.
Please be careful to avoid the sharp needles in the
K-Cup Assembly Housing & Lid.
Power Button
b. Select a brew size by pressing the flashing Cup,
Mug or Travel Mug button.
PRIME
READY
TO BREW
Travel Mug
Button
Travel Mug
Button
MENU
Cup Button
e. Press the flashing blue Travel Mug button.
Mug Button
f. The Brewer will automatically fill (priming it) and then
the water will be heated. This will take about 3 minutes.
During the heating period the ‘NOT READY’ indicator
will be on. When the water is heated ‘READY’ will be
NOTE: The smaller cup will brew stronger tasting
coffee/tea.
Please consult the Use & Care Guide for additional information on your Brewer. If you
are experiencing problems, contact Customer Service at 1-866-901-BREW (2739).
© 2005 Keurig Incorporated
Part #: 60-200258-037
Revision A, April 2005
Download from Www.Somanuals.com. All Manuals Search And Download.
|