2533 ADIRONDACK BAR STOOL
(1) Short Cross Brace
(4) Cross Braces
(22) 1/4 - 20 x 2” Bolts
(6) 1/4 - 20 x 2 1/2” Bolts
(12) Washers
Contents:
(1) Seat, (1) Back
(2) Arm Rests
(2) Front Chair legs
(2) Back Chair legs
(1) Footrest
(12) Locknuts
Locknut Washer 1/4-20 x 2” Bolt
(2) Side Braces
Tools Required:
7/16” Wrench
#3 Phillips Head Screwdriver
1.
Assembly Instructions
1.
a. With the wing on the post facing front,
align the predrilled holes on front leg to the seat
and insert the 1/4 - 20 x 2” Bolts through the leg
in thru the seat. Clean any plastic residue from the
bolt then slide a washer on. Screw on the locknut
and then tighten it with the wrench and phillips
screwdriver. Repeat on the other front leg.
a. Align predrilled then
insert bolts to attach
front legs.
b. Align predrilled
holes then insert bolts
to attach back legs.
Place arm rest on top of chair legs, align
front predrilled holes, insert bolt.
b. Align the predrilled holes on the back leg to
the seat and insert the 1/4 - 20 x 2” Bolts through
the leg in thru the seat. Clean any plastic residue
from the bolt then slide a washer on. Screw on the
locknut and then tighten it with the wrench and
phillips screwdriver. Repeat on the other back leg.
2.
2.
Place arm rest on top of chair legs align the
front predrilled holes and insert the 1/4 - 20 x 2”
Bolts through the leg and in thru the arm. Clean
off any plastic residue then slide a washer on the
end of bolt. Screw on the locknut and then tighten
it with the wrench and phillips screwdriver.
3.
a. Attach the back of the chair to the seat
Properly Seated
Washer and Nut.
3.
by aligning holes and inserting a 1/4 - 20 x 2”
Bolt then tighten with a phillips screwdriver.
b. Attach the back of the chair to the arm by
aligning holes and inserting a 1/4 - 20 x 2 1/2”
Bolt thru the arm, leg and into the chair back, then
tighten with a phillips screwdriver.
Repeat on both sides.
Attach the back of the
chair by aligning holes
on the arm and the seat
to insert bolt.
3b.
3a.
4.
Attach the cross braces of the chair to the
legs by aligning holes and inserting a 1/4 - 20 x
2” Bolt through the leg into the cross brace and
tighten with a phillips screwdriver.
Repeat on other leg.
Do Front and Back cross braces.
4.
Attach the braces to
the legs by aligning
holes and inserting
a 2” bolt.
Slide washer then
locknut onto end of
bolt then tighten.
Copyright © Kettler USA 309.01
Download from Www.Somanuals.com. All Manuals Search And Download.
|