System connections
SEPARATE CUSTOM FIT SPEAKER
Connection example 1
Tweeter connection from center unit. (Tweeter is installed on the dashboard.)
K-ES01
Center unit
INSTRUCTION MANUAL
Black/Gray
6Connection cord (for tweeter)
Black/Gray
KENWOOD CORPORATION
B54-1210-20 (FHP)
Tweeter
Thank you for purchasing this product.
Speaker output
Black
Black/Gray
Please read this instruction manual thoroughly before installing speakers, and
install speakers correctly.
Black
8Erectro-tap (for woofer)
Refer to "Woofer connections" in this instruction manual.
Red
Black/Gray
Black/Gray
Phillips screwdriver, Flat-head screwdriver, Clip driver, Pliers, Nippers, Wrench,
Tools required for installation
Electric hand drill and bits, Cutting knife, Electrical tape, Scissors, Felt-tip pen
Black
Black
Safety caution
Woofer
Be sure to observe the warning and caution provided below as they are critical for your safety.
The meanings of the symbols are as follows.
Black
~Connection cord
Black
(for woofer)
Vehicle connector
These indicate what must not be done.
(Inhibition marks)
This indicates what must be done.
(Imperative mark)
The high path filter for a tweeter is built in the main part of a tweeter.
Installation cautions
Connection example 2
Tweeter connection from woofer. (Tweeter is installed on the door panel.)
If the product is handled erroneously by ignoring the instruction of this mark,
fatal hazard or serious injury on human body may result.
WARNING
Work depending to instruction manual.
Remove battery connection before work.
Use proper tools for the processing
objects.
Wrap cords with protective tape.
When installing or wiring the product,
be sure to follow strictly the instruction
and installation manuals of the product.
(If the instructions are not observed
strictly, the product may be displaced
and hit you during braking and there
may also be a risk of electric shock or
fire hazard.)
Before installing or wiring anything, be
sure to remove the cable from the nega-
tive terminal of the battery.
The cords near metallic parts of the
vehicle should be protected against
sharp edge of the metallic parts by
wrapping insulating tape around them.
(If a cord is damaged, electric shock or
short-circuiting* as well as fire hazard
may result.)
When tightening a bolt or nut, always be
sure to use the tool matching its size. If
the securing torque of a part is speci-
fied, be sure to secure it with the speci-
fied force.
Cut
(Otherwise
a
shorting accident* may
6Connection cord (for tweeter)
occur, which could result in fire acci-
dent.)
(Otherwise the bolt or nut may be dam-
aged or detached during use.)
Remove negative terminal.
Center unit
Black/Gray
Please read thoroughly.
6Connection cord which is cut
(for tweeter)
Be careful not to damage the tank and
electric wiring.
Do not cut insulation tube in the middle Do not open the back and top covers of
Use a fuse with the specified rating.
of a power cord.
the product or modify it.
When the fuse is blown, first ensure that
there is no short-circuiting* between the
wired cords, then replace with a new
fuse with the capacity (Ampere value)
specified on the fuse box.
Tweeter
Red
In case the product is installed by mak-
ing holes on the vehicle chassis, be
careful never to damage the gasoline
tank, piping, electric wiring or other
parts of the vehicle.
Do not use power cord for other prod-
ucts by cutting insulation tube in the
middle of a power cord.
(This may lead to fire hazard or other
accident.)
• For inspection and servicing, consult
your dealer or nearest KENWOOD ser-
vice agent or distributor.
8Erectro-tap (for woofer)
Black/Gray
Black
Black/Gray
Refer to "Woofer connections" in this instruction manual.
(Otherwise
a
shorting accident* may
(Using other fuse than specified may
lead to fire hazard.)
occur, which could result in fire acci-
dent.)
(Otherwise fire hazard may result.)
• Servicing by the user may lead to fire
hazard or other accidents.
Please check the spec.
Black/Gray
• For fuse replacement, refer to the
owner's manual of your vehicle.
Black
If the product is handled erroneously
by ignoring the instruction of this
mark, injury on human body, or dam-
age of product may result.
Use provided parts for installation.
Inspect the vehicle after installation.
Black
Black
Be sure to install a product using pro-
vided parts. When parts other than the
provided ones are used, a product may
fall off and hit the passenger while driv-
ing, causing injury or product breakage.
After installation of the product, be sure
to check that the brake lamps, head
lamps, direction indicators, windshield
wipers, power window, etc. of the vehi-
cle function normally.
Woofer
CAUTION
~Connection cord (for woofer)
Connection cord
of vehicle
Black
Do not pull the cord.
(If any of the vehicle functions are dam-
aged due to incorrect wiring , etc., traf-
fic accident may result. )
Vehicle connector
When you remove the connector, please
remove and lock it with the connector
main part, without pulling the cord.
Otherwise disconnection of a cord and
poor contact may result.
The high path filter for a tweeter is built in the main part of a tweeter.
If the tweeter level is too high.
* Short-circuiting and shorting accident
Short-circuiting refers to the direct connection between the positive and negative poles of electricity. This may occur when a stripped cord (electric wiring) comes in
contact with another cord or metallic part of vehicle. Short-circuiting may produce spark, which may be caught by surrounding objects and result in fire hazard.
Connection example 3
Tweeter connection from center unit. (Tweeter is installed on the dashboard.)
7Sound Level Adjuster
(for tweeter)
Black/Gray
Black/Gray
Black/Gray
Black/Gray
Cautions on use
WARNING
Tweeter
Operate the car audio after stopping
the vehicle.
Do not use loud volume.
Do not continue sound output at an
abnormal level.
Do not open the back and top covers of
the product or modify it.
Center unit
Black
Black
During driving, do not turn the listening vol-
ume too high at which you cannot hear the
sound outside the vehicle.
The car audio system should be operated after
having stopped the vehicle in a safe place.
(Operating it while driving a vehicle may lead
to traffic accident.)
Do not use the speakers for a long period at a
high volume level at which the sound is dis-
torted.
(This may lead to fire hazard or other acci-
dent.)
6Connection cord (for tweeter)
(You may be unable to notice what is happen-
ing outside the vehicle, and a traffic accident
may result. )
• For the inspection and servicing, consult your
dealer or nearest KENWOOD service agent or
distributor.
• Servicing by the user may lead to fire hazard
and other accidents.
(The system may be overheated and fire haz-
ard may result. )
Black/Gray
Speaker output
Black/Gray
Black
8Erectro-tap (for woofer)
Red
Immediately stop operation in case of abnormality.
Refer to "Woofer connections" in this instruction manual.
Should any of the following abnormal phenom-
ena is observed, immediately stop the use and
operation of the product.
• The product starts smoking.
CAUTION
• Abnormal noise or odor is produced.
(If the use of the product is continued, fire haz-
ard or other accident may result.)
In this case, immediately switch the power off,
check safety and consult your dealer or nearest
KENWOOD service agent or distributor.
Black/Gray
Black/Gray
• No sound output.
Do not use the product for other purpose
than car use.
• Water is spilt on the product.
• A foreign object such as metal or a piece of
paper gets inside the product.
This product has been designed for installation and
operation in a vehicle. Do not use it for other pur-
pose.
(Otherwise imperfect installation may cause the
product to drop and cause injury.)
Black
Black
Woofer
Black
~Connection cord
(for woofer)
Black
Vehicle connector
• Please install depending to this instruction manual. Please keep it carefully after fin-
ishing reading this. It is better to keep this manual together with the owner's manual
of your vehicle.
• For inquiries on installation, please consult your dealer or nearest service agent.
• Refer to guidance on attached sheet for inquiry about the product to our company.
If the tweeter level is too high.
Tweeter connection from woofer. (Tweeter is installed on the door panel.)
Connection example 4
7Sound Level Adjuster
(for tweeter)
Black/Gray
Black/Gray
Black/Gray
Black/Gray
Caution
1. When installing in some types of a car, it is necessary to remove the seat belt. It is
necessary to mount the bolt which fixes a seat belt by the specified force. For
inquiries on torque, please consult your dealer or your car shop.
2. When installing in some types of a car, you have to install using an installation kit.
For inquiries, please consult your dealer.
3. Depending on the year or grade of a car, some vehicles may have changed parts.
For inquiries, please consult your dealer.
Tweeter
Black
Black
Center unit
6Connection cord which is cut
(for tweeter)
Refer to “Connection exsample 2”.
8Erectro-tap (for woofer)
Black/Gray
Black/Gray
Refer to "Woofer connections" in this instruction manual.
Red
About bolting torque
Black/Gray
"The power to twist something" is called "torque."
Two persons grip each end of one bat, and twist in opposite direction, respectively. In this case, the person with the
thick bat side is more advantageous.
Black
Black
Black
Thus, even if using the same force, turning something with a large radius will have larger twisting strength, or torque.
Woofer
~Connection cord (for woofer)
Connection cord
of vehicle
0.1m
1m
Black
[Bolting torque of a screw] ; The power in which an adult tightens a
Vehicle connector
screw normally using an ordinary screwdriver is 1-2N·m (0.1-0.2kgf·m).
[Bolting torque of a bolt] ; The torque when tightening a bolt by 25kg
power using a wrench is 49N·m (5kgf·m).
Caution
• The terminal which is not used should be protected by electrical tape for shorting accident prevention.
1kg
• Be careful of the polarity of plus/minus and connect depending to the connection example.
10kg
Both are the same torque, 9.8N·m (1kgf·m).
Download from Www.Somanuals.com. All Manuals Search And Download.
|