Kawasaki Motorcycle Accessories VN1700 User Manual

Assembly Instructions  
Description:  
Tachometer, Bar Clamp Model:  
VN1700 Nomad, Classic  
and Classic LT  
30 min  
Part-Number:  
K53020-386  
Approximate  
Assembly Time:  
Before you begin installation, read through the installation instructions and check to be sure all parts are  
present.  
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to complete the  
installation. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect  
installation.  
Parts List  
Part Number Description  
Tools Required:  
Seq.  
Qty.  
Cross-point screwdriver  
Tachometer  
Assembly  
Small flat blade screwdriver  
Wire connector crimping pliers  
8mm Hex Socket 3/8“ drive  
Ft.lb. torque wrench  
T.B.D.  
1
3
1.  
2.  
99-0605  
4” cable ties  
(Range minimum: 20 Ft lbs)  
Installation Instructions  
Tachometer Installation Preparation  
Parts Removal  
NOTICE  
Refer to the Service manual for specific information in removing  
the bar clamp components if further instruction is needed.  
It is recommended that you  
have an assistant stabilize the  
handlebars at this point to  
prevent the handlebars from  
moving away from the original  
position and possibly causing  
damage to the fuel tank  
Remove the two screws holding the headlight assembly and  
carefully disconnect the 3-pin connector on the back of the  
headlight reflector to remove the headlight, set it aside for now.  
Remove the four chrome handlebar clamp caps and bolts and the  
two clamps, being careful not to move the handlebars, see side  
note.  
Install Tachometer  
Punch mark  
Apply 2-stroke oil to the threads of the clamp bolts. Place the  
tachometer onto the handlebar clamp area and reinstall the four  
bolts. Make sure the handlebar punch mark aligns with the lower  
mating surface of the bar clamp at the rear edge. Tighten the front  
clamp bolts first, and then the rear bolts.  
aligned with  
top surface of  
lower clamp  
Tighten the bolts to 34 Nm (25 Ft-lbs)  
NOTE:  
o
There will be a small gap at the back of the clamp.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Indesit Washer Dryer WA 125 User Manual
Invacare Sleep Apnea Machine ISP2000 User Manual
Jumpking Fitness Equipment YJ User Manual
JVC CD Player KD G331 User Manual
JVC Dishwasher CA MXDVA9 User Manual
JVC VCR LPT0816 001A User Manual
Kenmore Vacuum Cleaner 175869039 User Manual
Kicker Portable Speaker KM620 User Manual
Kicker Speaker System KMT6 User Manual
KitchenAid Ice Maker W10136912C User Manual