Kambrook Fan KFH310 User Manual

Kambrook - Australia  
Kambrook - New Zealand  
Building 2, Port Air Industrial Estate  
1A Hale Street  
Private Bag 94411  
Botany, Manukau  
Botany NSW 2019  
Auckland 2163  
Australia  
New Zealand  
Customer Service Line 1300 139 798  
Customer Service Fax 1800 621 337  
Customer Service Line/  
Spare Parts 0800 273 845  
Customer Service Fax 0800 288 513  
Upright  
Fan Heater  
Instruction Booklet  
Due to continual improvement in design or otherwise, the product you  
purchase may differ slightly from the illustration in this book. Issue A11  
KFH310  
Download from Www.Somanuals.com. All Manuals Search And Download.  
To disconnect heater turn the control switch to  
OFF, turn off at the power outlet then remove the  
plug from the outlet.  
Keep the heater clean.Follow the cleaning  
instructions provided in this book  
Kambrook Recommends Safety First  
Always ensure the heater is properly assembled  
before use. Follow the instructions provided in  
this book.  
Do not insert or allow foreign objects to pass through  
the inlet or outlet openings.This may cause an  
electric shock, fire or damage the heater.  
Do not operate the heater on a sink drain board.  
To prevent a possible fire or heat damage, allow  
ample space around the heater (1.7m at front  
and 0.5m at the rear, top and sides) and do not  
totally or partially block the air inlet or outlets in  
any manner. Check the openings from time to  
time for accumulated dust.  
Do not operate the heater on an incline plane.Do  
not move while the fan heater is switched on.  
IMPORTANT: Please retain your  
instruction book for future use.  
To avoid an electrical overload,it is recommended  
that no other appliances are plugged into the  
same circuit as your heater when it is in use.  
Regularly inspect the supply cord,plug,control  
settings,air inlets and outlets and main housing for  
any damage in any way.Immediately cease use  
of the heater and return to Kambrook service  
centre or an authorised service agent for  
inspection or repair.  
Do not touch hot surfaces.  
Switch off at the control switch and power outlet,  
then unplug and allow heater to cool down  
before cleaning or storing.  
At Kambrook, we believe that safe performance is the first priority in any  
consumer product, so that you, our valued customer, can confidently  
use and trust our products. We ask that any electrical appliance that  
you use be operated in a sensible fashion with due care and attention  
placed on the following important operating instructions.  
Use this heater only as described in this instruction  
manual.Any other use not recommended by the  
manufacturer may cause fire, electric shock or  
injury and voids all warranties.  
Important Safeguards For Your Kambrook  
Upright Fan Heater  
Important Safeguards For All Electrical  
Appliances  
Carefully read all instructions before operating the  
Fan Heater and save for future reference.  
Do not operate heater whilst asleep.  
Do not operate any heater with a damaged  
cord or plug, or if heater has been dropped or  
damaged in any manner. Return heater to your  
nearest Kambrook Service Centre for examination,  
electrical or mechanical adjustment or repair.  
Remove any packaging material and promotional  
stickers before using the heater for the first time.  
Carefully read all instructions before operating the  
appliance and save for future reference.  
Any maintenance other than cleaning should  
be performed at an authorised Kambrook  
Service Centre.  
To eliminate a choking hazard for young children,  
remove and safely discard the protective cover  
fitted to the power plug of this heater.  
Connect only to 230V or 240V power outlet.  
This appliance is for household use only. Do not use  
this appliance for other than its intended use. Do  
not use in moving vehicles or boats.  
Do not operate the heater with the power cord  
damaged, frayed or split, wound around any part  
of the heater, or in contact with heated surfaces  
of the heater.  
Remove and safely discard all packaging  
material and promotional labels before using the  
appliance for the first time.  
Avoid touching heater body while it is on, as some  
parts of the heater are hot.When moving the unit  
switch off and hold the heater by the handles  
where provided.  
Do not use outdoors. Misuse may cause injury.  
Fully unwind the power cord before use.  
Do not run the cord under carpeting or cover the  
cord with rugs, runners or the like.Arrange cord  
away from traffic areas and where it will not be  
tripped over.  
The installation of a residual current device (safety  
switch) is recommended to provide additional safety  
protection when using electrical appliances. It is  
advisable that a safety switch with a rated residual  
operating current not exceeding 30mA be installed  
in the electrical circuit supplying the appliance. See  
your electrician for professional advice  
Do not let the power cord hang over the edge  
of a bench or table, touch hot surfaces or  
become knotted.  
Keep combustible materials such as drapes and  
other furnishings at least 1.7 metres from the front,  
sides and rear of the heater.  
Do not use outdoors.This heater is not intended for  
commercial use, such as construction sites.  
To protect against electric shock, do not immerse  
the power cord, power plug or appliance in water  
or any other liquid, unless it is recommended in the  
cleaning instructions.  
Do not locate the heater immediately below a  
power socket outlet when in use.  
WARNING: In order to  
avoid overheating, do  
not cover the heater.  
Always turn the appliance to the OFF position,  
switch off at the power outlet and unplug at the  
power outlet when the appliance is not in use.  
Do not use this heater with a programmer,timer  
or any other device that switches the heater on  
automatically,since a fire risk may exist if the heater  
is covered or positioned incorrectly.  
The appliance is not intended for use by persons  
(including children) with reduced physical, sensory  
or mental capabilities, or lack of experience  
and knowledge, unless they have been given  
supervision or instruction concerning use of the  
appliance, by a person responsible for their safety.  
Before cleaning, always turn the appliance to the  
OFF position, switch off at the power outlet, unplug  
at the power outlet and remove the power cord,  
if detachable, from the appliance and allow all  
parts to cool.  
Extreme caution and supervision is necessary  
when this heater is used by or near children,  
invalids or animals.  
This heater is not intended for use in wet or moist  
locations. Do not use this heater in the immediate  
surroundings of a bath, a shower or a swimming  
pool. Do not immerse or allow liquids to be spilt  
on heater.  
Children should be supervised to ensure that they  
do not play with the appliance.  
Important – this heater is intended for floor  
use only.  
Do not place this appliance on or near a heat  
source, such as hot plate, oven or heaters.  
It is recommended to inspect the appliance  
regularly. Do not use the appliance if the power  
supply cord, plug, connector or appliance  
becomes damaged in anyway. Return the entire  
appliance to the nearest authorised Kambrook  
Service Centre for examination and/or repair.  
This heater has hot and arcing or sparking parts  
inside. Do not use in areas where petrol, paints,  
aerosols, or other inflammable substances are  
used or stored.  
Do not mount on ceiling or walls.  
Position the appliance at a minimum distance of  
20cm away from walls, curtains and other heat or  
steam sensitive materials and provide adequate  
space above and on all sides for air circulation.  
Do not leave heater unattended when in use.  
Always switch off the heater at the controls and  
at the power outlet then unplug heater from the  
power outlet when not in use.  
Do not allow materials that have been in contact  
with oil, petroleum based products or drying fluids  
to come in contact with the heater.  
Do not use heater to dry your laundry.  
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Your Kambrook Upright Fan Heater  
Quick Start Guide  
1. 2400 watt heating element  
Not Shown  
Convenient cord storage in base  
Safety tip-over cut-out switch  
Setting the  
heating  
2. ThermoGuard protection for  
peace of mind  
Turning the  
heater on  
Turning the  
heater off  
mode and  
variable  
Control Panel  
temperature  
3. 2 heat settings, plus fan  
only setting  
4. Variable thermostat dial,  
to maintain your desired  
temperature setting  
Ensure the  
Plug the cord  
into a 230V or  
240V power  
point and  
Turn the Mode  
dial to the  
Once a  
Turn the heater  
off by turning  
heater is set  
to the OFF  
comfortable  
highest setting 2. room  
the Mode dial to  
position and  
the Variable  
Thermostat  
dial is turned  
clockwise as far  
as it will go to  
MAX.  
temperature has the OFF position.  
been reached,  
slowly turn  
switch on.  
the Variable  
Thermostat dial  
anti-clockwise  
until a click  
sound is heard.  
• Put draft stoppers, such as a rolled  
up towel, at the bottom of outside  
doorways to keep out cold air  
Hints/Tips to Retain Heat in  
Your Home  
• Don’t overheat your home.  
The temperature of a heated  
room in winter should be 18-21°C  
• Keep the heat in and the cold out by  
installing wall and ceiling insulation  
• Avoid placing items too close to the  
heater (both at the front and back)  
for optimal air flow  
• Your heater will work more  
efficiently if you stick to Kambrook’s  
recommended clearance spaces  
• Choose the right size heater for the  
room type you want to heat  
• Zone off unoccupied rooms by  
closing doors and only heat the  
main living areas  
• Fit window coverings like curtains  
to halve winter heat loss  
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Using Your Upright Fan Heater  
Before First Use  
NOTE: This heater features a tip-  
over switch. If the heater tips  
over, it will automatically switch  
off. Once placed back into the  
upright position, the heater will  
automatically switch on again.  
Remove any promotional material  
and packaging from the heater.  
Unwind the cord to its full length  
and place the heater on a firm, level  
surface in a stable, upright position.  
Visually inspect the air inlet and outlets  
to ensure there are no blockages.  
ThermoGuard Overheating  
Safety Device  
Turning Your Heater On  
Ensure the Mode dial is turned to the  
OFF position and turn the Variable  
Setting the Heating Mode  
Thermostat dial to the MAX setting.  
and Variable Temperature  
To control the heater, turn the Mode  
dial and the Variable Thermostat dial  
as follows.  
The Mode dial has 4 settings:  
OFF - Shuts off the heater and fan  
- For fan only operation  
1 - Low heat setting (1200 watts)  
2 - High heat setting (2400 watts)  
The Variable Thermostat dial acts as  
an automatic thermostat and can  
be used to maintain your desired  
temperature.  
Turn the Mode dial to setting 2 and  
the Variable Thermostat dial to MAX  
setting. Once a comfortable room  
temperature has been reached,  
slowly turn the Variable Thermostat  
dial anti-clockwise until a click sound  
is heard.  
At this setting, your heater will  
automatically cycle on and off  
to maintain the desired room  
temperature.  
Your heater is fitted with a safety  
device that switches off the heater  
in the event of overheating. Should  
this heater stop working, turn off the  
heater and inspect the air inlet and  
outlet for blockages.Wait at least five  
minutes for the protection system to  
reset before attempting to restart  
the heater.  
If the heater fails to operate or the  
safety device switches off again,  
return the heater to your nearest  
Kambrook Service Centre for  
examination or repair.  
Plug the cord into a 230V or 240V  
power point and switch on.  
NOTE: To avoid an electrical  
circuit overload, it is  
recommended that no other  
appliances are plugged into  
the same circuit as your heater,  
when it is in use.  
Turn the heater off by turning the  
Mode dial to the OFF position.  
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
Care and Cleaning  
Notes  
Ensure that the heater is switched off  
and disconnected from the power  
point before cleaning.  
Use a clean, dry cloth to clean the  
external surfaces of the heater. If  
the heater has collected dust or dirt  
inside the unit or around the elements,  
have the unit cleaned by a qualified  
service agent. Do not operate the  
heater in this condition.  
Do not attempt to open the case of  
the heater at any time as there are no  
customer serviceable parts inside.  
When not in use, store the heater  
(preferably in its original box) in a cool,  
clean and dry location.  
10  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  

InFocus Saw CR 13V User Manual
Ingersoll Rand Water Pump 66650 User Manual
Ingersoll Rand Water Pump NM2C23X A1 XXX User Manual
Insignia Car Speaker NS PLTPSP13 User Manual
Ironman Fitness Treadmill M6 User Manual
JVC Portable Speaker sp x100 User Manual
JVC VCR HR DVS1EU User Manual
Kenwood Marine Radio TS 820S User Manual
KitchenAid Double Oven KEBI141X User Manual
KitchenAid Mixer KSM95BU0 User Manual