JobSite Systems Speaker System LSO 5 LSO 6 LSO 7 LSO 8 User Manual

INSTALLATION & USER GUIDE

For Accurate Music and

Voice Reproduction

from Indoor and

Outdoor Locations

Download from Www.Somanuals.com. All Manuals Search And Download.

LSO-5/6/7/8

INDOOR/OUTDOOR LOUDSPEAKER

FEATURES: LSO-5

FEATURES: LSO-7

I 5” mica filled polypropylene woofer

I 5-1/4” mica filled polypropylene

with butyl rubber surround

woofer with butyl rubber surround

I 3/4” liquid cooled polycarbonate

I 1” liquid cooled ElastoDynamic

tweeter

dome tweeter

I Glass and mineral-filled

polypropylene enclosure

I Weather and UV resistant

Installation friendly design:

I Includes stainless-steel and

brass hardware

Installation friendly design:

I Includes stainless-steel and

brass hardware

I Recessed gold-plated 5-way

binding posts

I Includes adjustable rustproof

mounting bracket

I Includes aluminum rustproof grilles

FEATURES: LSO-6

FEATURES: LSO-8

I 5” mica filled polypropylene woofer

I 6-1/2” mica filled polypropylene

with butyl rubber surround

woofer with butyl rubber surround

I 1” liquid cooled ElastoDynamic

dome tweeter

I Glass and mineral-filled

polypropylene enclosure

I Weather and UV resistant

Installation friendly design:

I Includes stainless-steel and

brass hardware

Installation friendly design:

I Includes stainless-steel and

brass hardware

I Recessed gold-plated 5-way

binding posts

I Includes adjustable rustproof

mounting bracket

I Includes aluminum rustproof grilles

Download from Www.Somanuals.com. All Manuals Search And Download.

PRODUCT OVERVIEW

The LSO series of Indoor/Outdoor speakers give you the freedom to listen to music

anywhere! You can use them indoors and outdoors (even on a boat). The cabinet

is shaped to fit neatly into corners or eaves. It is supplied with a swiveling

mounting bracket for easy installation anywhere.

Figure 1 Parts Guide

a. Bracket

f. Grille

b. Nail Hole

g. Cabinet

c. Wire Hole

d. Screw Hole

e. Bracket Knob

h. Baffle

i. Binding Posts

j. Threaded Inserts

Download from Www.Somanuals.com. All Manuals Search And Download.

PACKAGE CONTENTS

I Indoor/Outdoor speakers x 2

I Mounting brackets x 2

I Paint masks x 2

PREPARING FOR

INSTALLATION

Figure 2

If you are mounting the speakers onto

an existing indoor wall, take time to

consider any possible obstructions,

which may be hidden inside the wall:

studs, electrical wiring, telephone

wiring, plumbing, AC or heating conduit

and ductwork.

Placement for enhanced bass output

If you are mounting the speaker’s

outdoors, use hardware designed for

outdoor use.

Mount the speakers in a location that

provides the best sound coverage and

minimizes the speaker’s exposure to

the elements.

Figure 3

Placement for average bass output

TOOLS REQUIRED

Label the speaker wires at the amplifier

location.

I Stud Locator

I Cordless screwdriver

Consider the amount of Bass you

would like to have. If you need a

average amount of Bass, then place

your loudspeakers as shown in

Figure 3. If you prefer more Bass,

place your loudspeakers as shown in

Figure 2.

I Three screws or bolts suitable

for the mounting surface

I Pencil

I Wire stripper

I Wire labels

Download from Www.Somanuals.com. All Manuals Search And Download.

INDOOR INSTALLATION

the amplifier to the black terminal.

Connect the positive output from

the amplifier to the red terminal.

1. LSO speakers can be mounted either

horizontally or vertically.

13. Remove the bracket knobs from the

speaker.

2. Use the stud locator to identify the

location of the studs in the proposed

mounting locations of the speaker.

14. Slide the speaker into the mounting

bracket.

3. Mark the stud edges, using masking

tape.

15. Insert the knob through the bracket

and into the threaded insert in the

cabinet.

4. Repeat this process for the other

speaker.

16. Secure the speaker in place by

tightening the bracket knobs.

5. You may decide to adjust the speaker

mounting locations based on how

symmetrical the studs are located in

the wall space.

17. Repeat this procedure for the next

speaker.

6. Use a pencil and the mounting

bracket to mark the locations of the

mounting holes on the wall.

OUTDOOR INSTALLATION

1. LSO speakers can be mounted either

horizontally or vertically.

7. Drill pilot holes into the mounting

surface.

2. Determine the appropriate mounting

location.

8. If the mounting holes lines up with a

stud, use screws to secure the

bracket to the wall.

3. Use a pencil and the mounting

bracket to mark the location of the

mounting holes on the surface.

9. If the mounting holes do not line up

with a stud, secure the bracket to the

wall using anchors designed to

support the weight of the speaker.

10. Strip 1/4" of insulation from the end

of each wire.

11. Tightly twist the end of each wire

until no frayed ends remain.

Figure 4

12. Attach the speaker wires to the

speaker terminal connectors.

Connect the negative output from

Download from Www.Somanuals.com. All Manuals Search And Download.

4. Drill pilot holes into the mounting

surface.

10. Remove the bracket knobs from the

speaker.

5. If the mounting holes line up with a

stud, use galvanized screws to

secure the bracket to the wall.

11. Slide the speaker into the mounting

bracket.

12. Insert the knob through the bracket

and into the threaded insert in the

cabinet

6. If the mounting holes do not line up

with a stud, secure the bracket to the

wall using anchors designed to

13. Secure the speaker in place by

tightening the bracket knobs.

support the weight of the speaker.

7. Strip 1/4" of insulation from the end of

each wire.

14. Repeat this procedure for the

next speaker.

8. Tightly twist the end of each wire

until no frayed ends remain.

9. Attach the speaker wires to the

speaker terminal connectors.

Connect the negative output from the

amplifier to the black terminal.

Connect the positive output from the

amplifier to the red terminal.

Figure 5

Removing the grille using a paper clip

REMOVINGTHE GRILLE

If the grille is already installed, remove it by using a bent paper clip or the tip of a

corkscrew and pulling it away from the frame. See figure 5

Download from Www.Somanuals.com. All Manuals Search And Download.

PAINTINGTHE SPEAKERS

PAINTINGTHE GRILLES

1. Separate the parts of the speaker by

removing the brackets and the

bracket knobs. Remove the grille by

hooking it with a bent paper clip or

the tip of a corkscrew and pulling it

away from the cabinet.

The grilles should be painted before

they are installed on the speakers. The

best results will be obtained by using

a spray gun or airless sprayer. Thin the

paint, and then apply several light coats.

This technique helps prevent clogging

of grille holes. Paint both sides of the

grille to cover all the white paint.

2. Mask off the binding posts and the

brass threaded inserts on the back

panel with masking tape.

OPERATION

3. Mask off the threaded inserts on the

top and bottom with masking tape.

Listening at Higher

Volumes:

4. Protect the front of the speakers by

inserting the supplied paint masks in

place of the grille on each speaker.

It requires more power to achieve a

reasonable volume of sound in a large

room than it does in a small room. It is

possible to turn the volume so high that

the amplifier runs out of power. This

creates “clipping” distortion.

5. Apply two thin coats of a primer to

the cabinet and knobs. We

recommend Krylon Sandable Spray

Primer. The bracket doesn't require a

coat of primer.

Clipping distortion makes treble

sound very harsh and unmusical. When

you hear harsh sounding treble from

any good speaker, turn the volume

down immediately! You are much less

likely to damage a speaker with a large

amplifier because it will be less likely to

produce any clipping distortion.

6. Allow the primer to completely dry.

7. Apply the finish color.

8. Allow the paint to completely dry.

9. Carefully remove the masking

material.

Download from Www.Somanuals.com. All Manuals Search And Download.

SPECIFICATIONS: LSO-5

SPECIFICATIONS: LSO-7

Power handing:

5 – 75 watts

10 – 100 watts

Frequency response:

110Hz- 21kHz +/-3dB

75Hz-21kHz+/-3dB

Impedance:

8 ohms

Dimensions bracket:

9-1/4” high x 7” wide x 6-5/8” deep

including Bracket

11” high x 8-3/8” wide x 7-9/16” deep

including Bracket

Warranty: 2 year limited

SPECIFICATIONS: LSO-6

SPECIFICATIONS: LSO-8

Power handing:

10 - 100 watts

10 - 150 watts

Frequency response:

110 Hz - 21kHz +/-3dB

65Hz-21Hz+/-3dB

Impedance:

8 ohms

Dimensions bracket:

9-1/4” high x 7” wide x 6-5/8” deep

including Bracket

13” high x 9-7/8” wide x 9” deep

including Bracket

Warranty: 2 year limited

Download from Www.Somanuals.com. All Manuals Search And Download.

LIMITED WARRANTY

serial number of your unit, and a brief

description of the problem.

JobSite Systems (“JOBSITE”), a Niles Audio

Corporation company, warrants its passive

products (those not requiring AC or battery

power) to the original purchaser to be free

of manufacturing defects in material and

workmanship for a period of ten years from

date of purchase.

A factory Return Authorization Number will

be sent to you. DO NOT RETURN ANY UNIT

WITHOUT FIRST RECEIVING WRITTEN

AUTHORIZATION AND SHIPPING

INSTRUCTIONS FROM JOBSITE.

JOBSITE warrants its passive loudspeaker

products (those not requiring AC or battery

power) to the original purchaser to be free

of manufacturing defects in material and

workmanship for a period of five years

from date of purchase.

If the above conditions are met, the

purchaser’s sole remedy shall be to return

the product to JOBSITE, in which case

JOBSITE will repair or replace, at its sole

option, the defective product without

charge for parts or labor. JOBSITE will

return the unit repaired or replaced under

warranty by shipping it by its usual

shipping method from the factory (only) at

its expense within the United States of

America. THERE ARE NO OTHER

WARRANTIES, INCLUDING, WITHOUT

LIMITATION, EITHER EXPRESS OR IMPLIED

WARRANTIES OF MERCHANTABILITY OR

FITNESS FOR A PARTICULAR PURPOSE,

WITH RESPECT TO THE PRODUCT.

JOBSITE warrants its indoor/outdoor

loudspeaker products to the original

purchaser to be free of manufacturing

defects in material and workmanship for a

period of two years from date of purchase.

JOBSITE warrants its all weather rock

loudspeaker products to the original

purchaser to be free of manufacturing

defects in material and workmanship for a

period of five years from date of purchase.

REPAIR OR REPLACEMENT AS PROVIDED

UNDER THIS WARRANTY IS THE

EXCLUSIVE REMEDY OF THE

CONSUMER/PURCHASER. JOBSITE SHALL

NOT BE RESPONSIBLE FOR ANY

INCIDENTAL OR CONSEQUENTIAL

DAMAGES EXCEPT TO THE EXTENT

PROVIDED (OR PROHIBITED) BY

APPLICABLE LAW.

JOBSITE warrants its active products

(those requiring AC or battery power) to the

original purchaser to be free of

manufacturing defects in material and

workmanship for a period of two years

from date of purchase.

This Warranty is subject to the following

additional conditions and limitations. The

Warranty is void and inapplicable if

JOBSITE deems that the product has been

used or handled other than in accordance

with the instructions provided by the

manufacturer, including, but not limited to,

damage caused by accident, mishandling,

improper installation, abuse, negligence, or

normal wear and tear, or any defect

caused by repair to the product other than

by JOBSITE or an authorized JOBSITE

wholesale distributor.

Some states do not allow the exclusion or

limitation of incidental or consequential

damages, so the above limitation may not

apply to you. This warranty gives you

specific legal rights, and you may also have

other rights, which vary from state to state.

For the name of the nearest authorized

JOBSITE wholesale distributor, contact:

JobSite Systems, a Niles Audio

Corporation company

To obtain warranty service, you must write

to JOBSITE: Include your name, address,

telephone number, model number and

P.O. Box 160818, Miami, Florida 33116

Download from Www.Somanuals.com. All Manuals Search And Download.

NOTES:

Download from Www.Somanuals.com. All Manuals Search And Download.

JOBSITE SYSTEMS

12331 S.W. 130 STREET, MIAMI, FLORIDA 33186

TEL (866) 4JB-SITE (866-452-7483) – FAX (305) 238-0185

WWW.JOBSITESYSTEMS.COM

Corporation. JobSite, Pure Custom and Niles are registered trademarks of Niles Audio Corporation and the JobSite Logo

is a trademark of Niles Audio Corporation. All other trademarks are the property of their respective owners. Some JobSite

products (or components thereof) are manufactured under one or more U.S. Patents, foreign equivalents and/or pending

patents (see product for details). Because we constantly strive to improve our products, JobSite reserves the right to

change product specifications, descriptions, and prices without notice. The technical and other specifications of

information contained herein are not intended to set forth all technical and other specifications of JobSite products.

Additional information can be obtained at www.JobSitesystems.com or by calling JobSite at 866-452-7483. Printed in

Taiwan. 11/04 DS00386ATW

Download from Www.Somanuals.com. All Manuals Search And Download.

IRiver MP3 Player iFP 500 Series User Manual
Jackson Dishwasher 200 User Manual
Jacuzzi Hot Tub HD84000 User Manual
Jade Range Range JCR 1 User Manual
Jenn Air Cooktop CVE3401 User Manual
JVC Car Stereo System KW XG707 User Manual
Jwin TV DVD Combo JD TV108 User Manual
Kenwood Car Satellite Radio System H2EC User Manual
KitchenAid Blender 5KSB52XXXX User Manual
Klipsch Speaker Bookshelf Speaker User Manual