Keep this manual for future reference.If you sell this stroller or
give it away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
Strider STROLLER
Operating Instructions for Single and Double models
Important:Read and follow these Safety Rules and Assembly Instructions before operating stroller.If you have
any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F, 8:00 a.m.–
5:00 p.m.CST or visit our web site at www.instep.net or E-mail us at [email protected] before using.
Safety Rules:
WARNING: Failure to follow these warnings and assembly instructions could result in
serious injury or death.
WARNING: Immediately discard any plastic wrapping.
WARNING: Never allow children to fold, assemble or disassemble the stroller.
WARNING: Maximum weight capacity for the Single stroller is 50 lbs. or 22.7 kg. Double 85 lbs.
or 38.6 kg.
WARNING: Never place child in stroller on their back with their head forward and feet rearward.
WARNING: Avoid serious injury from falling or sliding out. Always use seat belt.
WARNING: Never leave child unattended.
WARNING: Never use this stroller with roller skates or in-line skates.
WARNING: Never allow stroller to be used as a toy or allow children to give rides to others.
WARNING: Never use stroller if it becomes damaged.
WARNING: Always be aware of traffic around you when walking or jogging.
WARNING: Always engage brakes when you stop or when you let go of handle.
WARNING: Always use an approved bicycle helmet on child.
WARNING: Always use wrist strap.
WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.
WARNING: Maximum weight for objects in back pouch is 2.2 lbs. or 1 kg. Double 2.2 lbs. or 1 kg. in
each back pouch. Excessive weight may cause a hazardous, unstable condition.
WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position
unless T-shield and shoulder strap placement has been readjusted to the seat’s new
position.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 2. Rear Wheel Assembly
B
Remove the rear wheel lock nut from the rear wheel axle.
Mount rear wheel to the rear wheel bracket by inserting the
axle through the hole in the bracket.Attach the lock nut and
tighten completely using an adjustable wrench.Repeat for
other side (Figure B).WARNING:The interior jam nuts are
factory installed and do not need adjustment.
Rear
Wheel
Rear
Brake
Step 3. Front Wheel Assembly
Turn stroller upright onto its rear wheels, then tip stroller back
so the handlebar is down on the ground and the front fork is
up.Attach the front wheel by loosening the exterior lock nut
on each side of the front wheel far enough to allow the axle
and tab washer to slide into the front fork.The tab washer’s
tab should be inserted into the small hole on the outside of
the front fork (Figure C).Center the wheel between the front
fork.Tighten the nuts with an adjustable wrench.
Lock
Nut
C
Locknut
IMPORTANT: The alignment of the front wheel determines
if the stroller will roll straight, or pull to the right or left during
use.In the event you notice the stroller pulling to one direction,
loosen front axle nuts, point the front wheel in the opposite
direction the stroller is pulling, ensure the tab washers are
seated in the holes and tighten the nuts.If you need help
making this adjustment, please call our Customer Service
department for assistance.
Front
Wheel
Tab
Washer
Adjustment
Hole for Tab Washer
WARNING: The interior jam nuts are factory
installed and do not need adjustment.
D
Step 4. Front Fender Assembly
Insert the #8 – 11⁄2" screws into the holes located on the
front support between the front forks.Align the 2 holes on
the bottom side of the fender with the screws and tighten
with a Phillips screwdriver.Note:The Double EZStrider has
4 screws (Figure D).
#8 – 11⁄2
Screws
"
Step 5. Canopy Positioning
The canopy has adjustable positions.Pull the canopy down
to the desired position.
Double has
4 Holes/Screws
Step 6.To AttachWrist Strap
Place strap on top of handle bar.The wrist strap has different
sized loops.The large loop will go on your wrist, the small
loop will be on handlebar.Slide end with large loop through
the small loop, then grasp the end with the large loop and pull
strap to tighten on handlebar.
WARNING: Whenever child is in stroller always use the
wrist strap.Before you remove the wrist strap from your wrist make
sure you first engage the rear brakes.
Congratulations – assembly is now complete!
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Use Instructions
E
Pull Seat Forward
When Folding
To close/fold stroller:
WARNING: Always remove child from
stroller before folding.
Pull the seat/seats forward, locate the plastic
latches on the side of the stroller frame.Using one
hand on each lever, pull the levers from the lower
bar.The stroller will automatically begin to fold, the
front wheel will fold under frame and the handle will
fold backwards ( Figure E).
Latches
F
NOTE: The stroller will be easier to fold if the seats
are not in the recline position.If the seats are in the
recline position please pull forward.
Latches on
Both Sides
To open stroller:
Grasp handle with one hand and pull up on the
front axle mount with your other hand.Lock both
plastic latches onto the lower frame (Figure F).
Single EZ Strider
Double EZ Strider
Download from Www.Somanuals.co4m. All Manuals Search And Download.
To engage rear brakes:
G
Step lightly on the levers next to the rear wheels
until the cogs of the brakes engage the cogs of the
wheel.Repeat on other side.To release brake,
lift levers using your toe until cogs disengage
(Figure G).
Proper use of seat belts & shoulder
straps:
Rear
Brakes
WARNING: Avoid Serious Injury.Always use
seat belts.
Shoulder Straps
H
1. Place child in seat.Make sureT-shield is
between the child’s legs.
2. When child is seated, place shoulder straps
over the child’s shoulders.
Shoulder
Strap
Adjustment
Slides
3. Slide waist straps through lower loops of shoul-
Lder straps, bring lap belt ends together and clip
into place around child’s waist.Adjust waist and
shoulder straps for snug fit (Figure H).
Waist
Belt
Waist
Belt
To recline seat:
To fully recline, unhook buckle on back of the seat.
(Figure I).
To place seat in upright position, push seat forward
and reconnect buckle located on back of seat.
Waist
T-Shield
Buckle
Adjustment
To adjust the recline position, adjust the slide on
the strap.
I
WARNING: Child may slip into leg openings
and strangle.Never use in a reclined carriage posi-
tion unlessT-shield and shoulder strap have been
readjusted to the new seat position.
Download from Www.Somanuals.co5m. All Manuals Search And Download.
Care and Maintenance
Check fasteners
After one hour of use, check all fasteners to make sure they are secure.Adjust if necessary.
Periodically check the stroller to ensure that it is in good operating condition.
To adjust the stroller from pulling to the left or right (not rolling
straight):
Loosen the front axle nuts and check to see that the tab washers are inserted in the holes of the front fork.
Point the front wheel forward or in the opposite direction the stroller is pulling, then tighten the nuts with an
adjustable wrench.
NOTE:Sometimes it is a very slight adjustment to eliminate the pulling and this step may need to be
repeated.
To clean seat and canopy:
If light cleaning is required, use a soft cloth with warm water and mild soap then air dry.Do not put into
washing machine.Do not put in dryer.DO NOT BLEACH.
To clean frame:
Wipe using a soft cloth with warm water and mild soap.Air dry.DO NOT USE polish or abrasives.
WARNING: If you have any questions concerning the safe use of this product, please contact
InSTEP LLC before using:
1-800-242-6110
InSTEP LLC
2425 Enterprise Drive
Suite 900
Mendota Heights, MN 55120
6
Download from Www.Somanuals.com. All Manuals Search And Download.
|