BATTERY OPERATED
BI-PLANE
91311
ASSEMBLY & OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
IMPORTANT:
If damage is caused due to a crash, your warranty is void.
Copyright© 2004 by Harbor Freight Tools®. All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions and replacement parts please call 1-800-444-3353.
REV 10/05
Download from Www.Somanuals.com. All Manuals Search And Download.
11. Do not modify this Bi-Plane and do not use this Bi-Plane for a purpose for which it was
not intended.
12. Do not use or assemble the Bi-Plane if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgement or reflexes are impaired while
taking drugs. If there is any doubt, do not assemble or use the Bi-Plane.
13. Do not pick up the Bi-Plane while it is in motion.
14. Use only Batteries of the type recommended.
15. Do not mix old and new batteries.
16. Remove batteries if the Bi-Plane is not used for a long period of time.
17. Do not recharge non-rechargeable batteries.
18. Make certain to use the Bi-Plane in a large area free from interference from trees,
electrical power lines and other obstacles.
19. Never fly near buildings, cars or busy streets.
20. Do not fly the Bi-Plane at or near other people or animals.
21. Do not fly the Bi-Plane if wind speeds are above 10 MPH.
22. Do not allow children to use glue without adult supervision. Make certain that the glue is
stored out of reach of children and animals.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Assembly/ Operation
Your Battery Operated Bi-Plane will require complete assembly. It is important that you read the
entire manual to become familiar with the product BEFORE you use the Bi-Plane. Before
assembling the Bi-Plane be sure that you have all parts described in the Parts List and Assembly
Diagram located on the last pages of this manual.
Set out all parts on a clear and level surface prior to assembly.
1.
2.
Insert the Battery/Switch Compartment Plug (13) into the plug located on the Fuselage (1)-
see Figure 1.
Remove the backing from the tape on the center of the Lower Wing (11).
IMPORTANT:
If damage is caused due to a crash, your warranty is void.
REV 05/06
SKU 91311
For technical questions, please call 1-800-444-3353.
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure 1
Figure 2
Fuselage (1)
Fuselage (1)
Lower Wing (11)
Lower
Wing (11)
Battery/Switch
Compartment Plug (13)
Note: Make certain to only peel off the backing. Peeling off too much will also remove the sticky
tape so that the parts will not adhere to one another. The backing should peel off easily; if it
is not coming off easily, you may be removing the backing and the tape.
3.
Attach the Lower Wing (11) with Battery/Switch Compartment Plug (13) to the Fuselage-see
Figure 2. Make certain that the Lower Wing (11) with Battery/Switch Compartment Plug (13)
and the Fuselage (1) are lined up perfectly before pressing them together.
4.
Locate both Bi-Wing Supports (10). The Bi-Wing Supports (10) must be set on the Lower
Wing (11) pointing forward and outward-see Figure 3. Remove the tape backing from both
sides of the Lower Wing (11) and press the Bi-Wing Supports (10) into place as in Figure 3.
Figure 4
Figure 3
Upper Wing
Support (3)
Tail Wing
Support (8)
Bi-Wing
Support (10)
Lower Wing (11)
Horizontal Tail Wing (12)
5.
6.
Remove the four tape backings from under the Upper Wing (9). Line up the taped areas
with the Upper Wing Supports (3) and the Bi-Wing Supports (10). Press the Upper Wing
(9) into place.
Locate the two (2) Horizontal Tail Wings (12). Remove the tape backings from the Tail Wing
Platform. Line up the taped areas of the Horizontal Tail Wings (12) with the Tail Wing Support
(8) and press them into place-see Figure 4.
7.
8.
9.
Snap the Landing Gear Assembly (15) into the slot at the front and bottom of the
Fuselage (1)- see Figure 5.
With one hand holding the Fuselage (1), push the Propeller (16) and Spinner (17) onto
the shaft located on the nose of the Fuselage (1).
Place the Decals (19) on the Bi-Plane.
SKU 91311
For technical questions, please call 1-800-444-3353.
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure 6
Figure 5
Charger (20) into the Battery/Switch
Compartment (13)
Landing Gear
Assembly (15)
10.
11.
Make certain that the “On/OFF” switch for the Bi-Plane is in the “OFF” position. Install four
(4) “AA” Batteries into the Charger (20) making certain that the (+) and (-) polarity marks are
lined up correctly.
Plug the Charger (20) into the Battery/Switch Compartment (13)- see Figure 6. Charge the
Batteries for 30 seconds only.
WARNING! NEVER charge the batteries longer than 30 seconds. Overcharging can
cause overheating, resulting in PERSONAL INJURY or property damage.
Turn the Bi-Plane “ON” and allow the batteries to run through one cycle until the Bi-Plane
runs down. Recharge battery at this point.
First Motorized Test Flight
Fly the Bi-Plane in an open area, free of obstructions (especially phone and electrical power lines)
and fly it on a calm day. Never fly in winds above 10 MPH.
Make certain that you fly in a large and clear area as you experiment with flight patterns.
Wind can take the Bi-Plane a considerable distance.
Flying the Bi-Plane
1.
2.
3.
4.
Turn the On/Off Switch on the Bi-Plane to the “ON” position. Tilt the Bi-plane with the nose
10 degrees upward and face it into the wind. Firmly toss the Bi-Plane.
Turning “OFF” the power for about 15 minutes between each flight will prolong your batteries
life-span.
To adjust the flight radius of the Bi-Plane, you can bend the rudder of the Horizontal Tail Wing
(12) two or three degrees left or right.
Check the Bi-Plane for damage before each use. Make certain that the wings are correctly
aligned and that they are free from damage. Make certain that the Bi-Plane and all of its
parts are free from damage. Make certain that the Propeller (16) is securely in place before
using.
5.
The Bi-Plane comes with one container of Glue for any minor repairs which are needed if
damage occurs during use.
REV 10/05
SKU 91311
For technical questions, please call 1-800-444-3353.
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
Unpacking
When unpacking the Battery Operated Bi-Plane, check to make sure the following parts are
included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
1-800-444-3353.
Part # Description
Quantity Part # Description
Quantity
1
2
1
2
3
4
5
6
7
8
9
10
Fuselage
1
1
2
1
1
1
1
1
1
2
11
12
13
Low wing
Motor Mount
Upper Wing Support
Canopy
HorizontalTailWing
Battery-Switch
Compartment
Landing Gear Assy
Propeller
Spinner
Motor
1
1
1
1
1
2
1
Pilot
15
16
17
18
19
20
Vertical Tail Wing
HorizontalTail Wing
Tail Support
Upper Wing
Decals
Charger
Bi-wing Support
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
rger (20)
shown.
SKU 91311
For technical questions, please call 1-800-444-3353.
Page 6
Download from Www.Somanuals.com. All Manuals Search And Download.
|