Jan 04, 2010
X1103
REPLACING THE MAIN POWER PANEL
iJoy-2400
To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 2
Tools Required: Phillips-head screwdriver, utility blade, flat-head screwdriver.
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
Power panel
REMOVING THE MAIN POWER PANEL
1. Power off the chair then unplug it.
2. Using a utility blade, peel the label off the main power panel, located on the left-hand side of the chair (Fig.1).
Note: Be sure to record the serial number that is printed on the power panel label before discarding it.
The serial number is required for warranty service.
Peel the label off
3. Using a Phillips-head screwdriver, remove the two screws that secure the power panel to the chair (Fig.1).
4. Using a flat-head screwdriver, pry the panel out of the chair enough to expose the connectors, then disconnect
the connectors (Fig.2).
5. Remove the power panel from the chair (Fig.3).
Power panel
(Fig.1)
Connectors
Power panel
Power panel removed
flat-head screwdriver
(Fig.2)
(Fig.3)
1
|